RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: fb72
Showing results 1 to 6 of 6
Search took 0.23 seconds.
Forum: Engine Conversions
11-18-2009, 10:19 PM
Replies: 1,445
Views: 295,022
Posted By fb72

RE: New CDI - opensource project JMJ and Bigboat

Ok so i finally got everything i needed to fully test my ignition, But when i power it up, it is very erratic, the microcontroller doesnt seem to be doing anything. I made a ground shield that covers...
Forum: Engine Conversions
11-04-2009, 05:47 PM
Replies: 1,445
Views: 295,022
Posted By fb72

RE: New CDI - opensource project JMJ and Bigboat

wasnt planning on using the homemade coil, i knew i was going to fry it pretty quick because i wound it with a drill and i didnt insulate between the layers.
Forum: Engine Conversions
11-04-2009, 07:58 AM
Replies: 1,445
Views: 295,022
Posted By fb72

RE: New CDI - opensource project JMJ and Bigboat

Yes, i was using a homemade sparkcoil, im only using it for testing though. I have a factory-made sparkcoil on the way.

I wound the HV-coil with the specs on the schematic, same wire sizes/amount...
Forum: Engine Conversions
11-03-2009, 10:53 PM
Replies: 1,445
Views: 295,022
Posted By fb72

RE: New CDI - opensource project JMJ and Bigboat

OK, i just re-tested evything and it is still putting out way over 600v while sparking. I burnt out the spark coil i made testing it.
Forum: Engine Conversions
11-03-2009, 09:39 PM
Replies: 1,445
Views: 295,022
Posted By fb72

RE: New CDI - opensource project JMJ and Bigboat

I tested the voltage with everything hooked up as it would be during operation, but i will go and set everything up again from the beginning to make shure.
Forum: Engine Conversions
11-03-2009, 06:14 PM
Replies: 1,445
Views: 295,022
Posted By fb72

RE: New CDI - opensource project JMJ and Bigboat

I just got done testing my HV side of the circuit and i am getting almost 800V from the coil. The highest voltage my components (capacitor & SCR) can handle is 630V. What can i do to reduce this to...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.