RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: Nitrovein
Showing results 1 to 25 of 227
Search took 0.20 seconds.
11-17-2017, 02:01 PM
Replies: 6
Views: 1,282
Posted By Nitrovein

It doesn't find anything, it just lets you have...

It doesn't find anything, it just lets you have the same point to adjust from. Changing ride height is done beside that, though for racing it's often very little that is changed regarding ride...
11-17-2017, 07:31 AM
Replies: 6
Views: 1,282
Posted By Nitrovein

You need two blocks to put under the chassi, what...

You need two blocks to put under the chassi, what you use doesn't matter as long as you always use the same and they are straight. If you're going to use someone else setup you need to know what they...
Forum: RC Fuels
10-31-2017, 08:44 AM
Replies: 24
Views: 46,564
Posted By Nitrovein

It's a complicated question, it depends on what...

It's a complicated question, it depends on what you're looking for, different total percentages will want different ratios, as will different engines and use of engine.
Just trying to give you a...
Forum: RC Fuels
10-31-2017, 06:56 AM
Replies: 24
Views: 46,564
Posted By Nitrovein

Well, yes, it is a better oil and you don't need...

Well, yes, it is a better oil and you don't need the amount of oil that was for 50's engines with their metallurgy and tolerances (even with other oils).
But it also has a very low viscosity, so...
Forum: RC Fuels
10-31-2017, 04:03 AM
Replies: 24
Views: 46,564
Posted By Nitrovein

Everything gets a bit complicated as the engines...

Everything gets a bit complicated as the engines are designed for regular fuel blends. There have been fuel mfg that has been down this road and given up.
But in the end it's worth it, no doubt! :)
Forum: RC Fuels
10-31-2017, 02:04 AM
Replies: 24
Views: 46,564
Posted By Nitrovein

Just went to RCtech and noticed that, I had the...

Just went to RCtech and noticed that, I had the SDS, but was curious to the statement made.
It's a great oil, they have their act together at Redline, they make the best product they can and hope...
Forum: RC Fuels
10-31-2017, 01:28 AM
Replies: 24
Views: 46,564
Posted By Nitrovein

Not to sure about the Flash point though...

Not to sure about the Flash point though...
Forum: RC Fuels
10-30-2017, 02:18 PM
Replies: 24
Views: 46,564
Posted By Nitrovein

BeNOL is castor oil, the different Techniplate is...

BeNOL is castor oil, the different Techniplate is synthetic oil (if you choose to use Klotz).
RC Model (http://www.klotzlube.com/radio_control_.html)
10-27-2017, 06:51 AM
Replies: 12
Views: 1,976
Posted By Nitrovein

Yeah, those radios is the top brands. Sanwa...

Yeah, those radios is the top brands. Sanwa usually has better respons then Futaba, but both are good. Some radios are lacking a lot on respons time, and that makes or breaks a radio, I've seen pro's...
10-27-2017, 03:27 AM
Replies: 12
Views: 1,976
Posted By Nitrovein

Kyosho not only makes crappy cars, they make good...

Kyosho not only makes crappy cars, they make good ones too, but they are priced a bit to high. They seem to work well for most people though.
Xray makes good quality cars, no doubt, but it's messy...
10-27-2017, 02:16 AM
Replies: 12
Views: 1,976
Posted By Nitrovein

Go over to RCtech forum, it's where the people...

Go over to RCtech forum, it's where the people who compete is.

Xray makes great cars, fit and finish is second to none. But, you'll need to upgrade pretty much every year. They release new parts...
10-26-2017, 06:22 AM
Replies: 12
Views: 1,976
Posted By Nitrovein

Hobbico stop Team Durango activities...

Hobbico stop Team Durango activities -NeoBuggy.net ? Offroad RC Car News (http://www.neobuggy.net/2017/08/18/hobbico-stop-team-durango-activities/)
10-26-2017, 01:11 AM
Replies: 12
Views: 1,976
Posted By Nitrovein

Durango is out of business. Personally I...

Durango is out of business.
Personally I wouldn't buy Xray as they update their cars every year, so you'll soon have an out of date car.
Both Mugen and Hotbodies are great, pick the one that...
Forum: Glow Engines
10-17-2017, 10:07 AM
Replies: 70
Views: 8,905
Posted By Nitrovein

Run C3. Bearings sold for engines are C3 (at...

Run C3.
Bearings sold for engines are C3 (at least all I ever seen).
Forum: Glow Engines
10-17-2017, 06:58 AM
Replies: 70
Views: 8,905
Posted By Nitrovein

Most of the time I would rather bet on loser...

Most of the time I would rather bet on loser fitting like bushed engines or the larger C3 fitting, it will most likely be more chock resistant.
In airplane engines where you typically run higher...
Forum: Glow Engines
10-17-2017, 01:38 AM
Replies: 70
Views: 8,905
Posted By Nitrovein

The whole point of posting that list was to show...

The whole point of posting that list was to show what happens when installed, what to think about and so on.
I have tried my fair share of bearings as well, different brands in different engines,...
Forum: Glow Engines
10-16-2017, 03:42 PM
Replies: 70
Views: 8,905
Posted By Nitrovein

It's; C1 = Less clearance then C2 C2 = Less...

It's;
C1 = Less clearance then C2
C2 = Less clearance then CN
CN = Normal clearance
C3 = Greater clearance then CN
C4 = Greater clearance then C3
C5 = Greater clearance then C4
Forum: Glow Engines
10-16-2017, 09:15 AM
Replies: 70
Views: 8,905
Posted By Nitrovein

Here is one online source how to determine what...

Here is one online source how to determine what to use as far as clearance goes.
2241388
Forum: Glow Engines
10-16-2017, 01:48 AM
Replies: 70
Views: 8,905
Posted By Nitrovein

The engine will work the same with any seal (in...

The engine will work the same with any seal (in the front, remove for the rear), but it's never a bad idea to get rubber seal as the will be better at stopping things from getting in.
Especially if...
Forum: Glow Engines
10-11-2017, 08:46 AM
Replies: 70
Views: 8,905
Posted By Nitrovein

Oiling the bearing will fool you, it needs to be...

Oiling the bearing will fool you, it needs to be perfectly smooth when it's completely degreased, otherwise it needs replacing.
Forum: Gas Engines
09-18-2017, 10:40 AM
Replies: 42
Views: 2,975
Posted By Nitrovein

The oil doesn't know what engine it's going...

The oil doesn't know what engine it's going through, how could it?
And does that mean that people isn't using racing oil for other things then racing? I've seen my fair share of people on forums...
Forum: Gas Engines
09-18-2017, 09:27 AM
Replies: 42
Views: 2,975
Posted By Nitrovein

We have pretty much all the oils that you have,...

We have pretty much all the oils that you have, plus a bunch more.
Be glad that you experience is good, I've seen sooo much problems that it's not even funny, and heard of even more.
That the...
Forum: Gas Engines
09-18-2017, 06:53 AM
Replies: 42
Views: 2,975
Posted By Nitrovein

If you don't mention what 2 stroke oil you're...

If you don't mention what 2 stroke oil you're talking about it's safer to say that it's not safe, as far from all 2 stroke oils have any conditioner/stabilizer.
Some oils are not even recommended...
Forum: Gas Engines
09-18-2017, 03:51 AM
Replies: 42
Views: 2,975
Posted By Nitrovein

Indeed so. Knowing what petrol stations that has...

Indeed so. Knowing what petrol stations that has fresh fuel or not is key when you start tuning a freshly built engine that will run pump gas.
Forum: Gas Engines
09-18-2017, 01:35 AM
Replies: 42
Views: 2,975
Posted By Nitrovein

Then you clearly don't know what you're talking...

Then you clearly don't know what you're talking about!

True car collectors use all sorts of tricks to avoid all the problems with stale fuel, I've talked to a few.

Race gas has very little to...
Showing results 1 to 25 of 227
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.