RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: etarak
Showing results 1 to 14 of 14
Search took 0.17 seconds.
Replies: 10
Views: 942
Posted By etarak

RE: 160 motors squels

It could be the propeller is too loose and spins on the shaft when you accelerate.
</p>
Replies: 3
Views: 599
Posted By etarak

RE: Need correct ESC. What do I get?

If you buy a 30 or 40 amp brushless esc with bec, you should be okay. With regards your second question: you should hear several short beeps and then one long beep when you plug the battery in. This...
Replies: 2
Views: 741
Posted By etarak

RE: I need help on determining the right size brushless motor.

You can use an AXI 2814/16 or equivalent, with a 10x6 prop, a 30 amp ESC and a 3S lipo battery.
Replies: 6
Views: 821
Posted By etarak

RE: bigger EP setups and battery heat

I have been flying an F18 jet with a 90mm ducted fan. I have used a 6S 3700mah battery and a 5000mah battery with no heating problems. The battery fits very tight in the compartment with now airflow...
Replies: 3
Views: 2,886
Posted By etarak

RE: Grayson Hobby - ESC Programming

Go to www.graysonhobby.com and find the 20amp esc. Click on the speed controller and when you get to next page you will see an item at the bottom in large blue letters (More Info Manual). It will...
Replies: 4
Views: 707
Posted By etarak

RE: motor question

http://www.hobbypartz.com/alpha-3701360kvbrushless-motor.html

Use the above link to find the motor that will likely work. I would recommend a 15-20 amp speed control.
Replies: 4
Views: 707
Posted By etarak

RE: motor question

What does your airplane weigh, including the battery?
Replies: 3
Views: 633
Posted By etarak

RE: LiPo storage question

That's 3.80 volts per cell.  Sorry!
Replies: 3
Views: 633
Posted By etarak

RE: LiPo storage question

Just plug the battery into the charger and put it on storage mode, if it shows a default setting, start it up and it should discharge the batteries to approx 3.80 volts for storage
Replies: 50
Views: 27,133
Posted By etarak

RE: beware grayson hobby

Thank you for the support on this one Drywaller. For a very small amount Grayson Hobbies could have kept me as a customer. I would have been satisfied with a credit on account for future purchases!...
Replies: 50
Views: 27,133
Posted By etarak

RE: beware grayson hobby

I had a problem with Grayson Hobby as well. I ordered a 50 amp speed control with a BEC, however I was shipped a 50 amp without a BEC. I sent many emails etc to get the problem corrected, but with no...
Replies: 2
Views: 648
Posted By etarak

RE: brushless inrunner

Thanks for the infomation, Whitecrest.
Replies: 2
Views: 648
Posted By etarak

brushless inrunner

Is it possible that running an inrunner brushless motor, without the fan blade, on a edf, would cause it to fly apart on the inside????
Thanks
Replies: 0
Views: 553
Posted By etarak

100 amp esc

I have just purchased a 100 amp esc from Banana Hobby, but no instructions were included. I have a programming chart for a 60 esc. It shows 1 short and 3 long beebs for a 6s lipo. Is this standard...
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.