RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: Reeb
Showing results 1 to 25 of 42
Search took 0.63 seconds.
Replies: 2
Views: 665
Posted By Reeb

Thanks. I'm going to try taking the sattelite...

Thanks. I'm going to try taking the sattelite part of the ar8000 and connecting it into the flexi port on the cc3d which says is can handle spektrum DSM. I guess I will need a BEC to get a voltage of...
Replies: 2
Views: 665
Posted By Reeb

Spektrum ar8000 advice

Hi guys. Just getting into drones. I bought an eachine falcon 210 pro and am trying to get it to work with my spektrum dx8. The falcon comes with a flysky receiver with all of the escs going into a...
10-02-2003, 04:50 AM
Replies: 11
Views: 1,752
Posted By Reeb

RE: Triton charger questions

HelipilotRC, the problem with your charger not ramping up to the set current on lipo cells is due to the fact that your charging lead is to long or induces too much resitance. The triton measures...
09-27-2003, 02:43 PM
Replies: 6
Views: 1,085
Posted By Reeb

RE: Problems with a new replaced Triton Charger...

from my test results so far, your charging cables should be made out of paper clips :-) Actually I have no idea. I will try putting banana plugs on the standard wired already attached to a mini jst...
09-27-2003, 07:52 AM
Replies: 6
Views: 1,085
Posted By Reeb

RE: Problems with a new replaced Triton Charger...

Guys,

I am a very happy man. I've solved this ongoing triton problem! After receiving my replacement triton today which exhibited the same problems as before, ie. same problems as you've...
09-13-2003, 07:05 AM
Replies: 1
Views: 592
Posted By Reeb

Temp. of pack after flight

Hi, I've read the temp. off a pack of nimh 700maH cells after a high rpm flight on a picc pro and with an IR gun it measured 75 degrees C. Is that high enough to damade the cells? What are the "safe"...
09-06-2003, 11:02 PM
Replies: 15
Views: 1,608
Posted By Reeb

Kokam and triton behaviour

By the way, does anyone have an email address to greatplanes for asking technical questions such as this.
09-06-2003, 10:44 PM
Replies: 15
Views: 1,608
Posted By Reeb

Kokam and triton behaviour

Yes I agree with you, it should have ramped up the current to the set value after 15 minutes and the voltage is a lot lower than 8.4v so something fishy is going on although I am skeptical re: faulty...
09-06-2003, 10:39 PM
Replies: 2
Views: 1,007
Posted By Reeb

Triton needs another UPDATE!!!

Yes, I have that problem too. Can you please post back and let me know if you got the problem fixed as I am curious if it is worth sending the unit back overseas for recalibration. Actually I am...
09-03-2003, 09:05 PM
Replies: 15
Views: 1,608
Posted By Reeb

Kokam and triton behaviour

Thanks for the reply. Could it be something wrong with the pack, that it doesn't want to draw more than 0.5A ?
08-31-2003, 08:45 AM
Replies: 15
Views: 1,608
Posted By Reeb

Kokam and triton behaviour

Hi. It reads 7.6V. It did get up to 0.5A yesterday I should mention.
08-29-2003, 09:19 AM
Replies: 15
Views: 1,608
Posted By Reeb

Kokam and triton behaviour

thanks for the reply. It's useful to read that your triton reaches max current after 10 minutes.

The problem I'm having (once again) is that the triton never gets over 0.4A for a 1.2mAh pack. I...
08-27-2003, 10:35 AM
Replies: 15
Views: 1,608
Posted By Reeb

Kokam and triton behaviour

No that's not the answer as I have also charged them after a full use depleting them and the stupid triton still limited the current to 0.4A the whole way until they were full which took three hours....
08-26-2003, 05:19 PM
Replies: 3
Views: 1,004
Posted By Reeb

What should kokam1200s draw on triton?

Thanks for the replies.

Yes the pack seemed fully charged. It's just a shame I can't ramp up the current a bit, even after depleting the pack and then putting it on charge. The voltage at initial...
08-26-2003, 05:16 PM
Replies: 14
Views: 1,490
Posted By Reeb

Triton Li-ion Charging

Thanks for the reply.

Well I emptied the cells today after flying 55 minutes with a pico stick. I put them on charge at 1.2A and still it doesn't go over 0.4A. Is there no way to override the...
08-25-2003, 09:25 PM
Replies: 14
Views: 1,490
Posted By Reeb

Triton Li-ion Charging

Hi Red,

I'm getting the same problem as the other guys in this old thread with a triton and 2x1200 Kokam HD lipo's. When I set the triton to charge at 1.2A or 0.6A or whatever it is overridden by...
08-25-2003, 08:21 PM
Replies: 15
Views: 1,608
Posted By Reeb

Kokam and triton behaviour

Hi,

Just got delivery of my first lipo's - 2x 1200 HD kokams which I will be using on a pico stick slow flyer. I've bought a triton to charge them on. When delivered they are supposed to hold 50%...
08-25-2003, 06:55 PM
Replies: 3
Views: 1,004
Posted By Reeb

What should kokam1200s draw on triton?

Hi,

Just got delivery of my first lipo's - 2x 1200 HD kokams which I will be using on a pico stick slow flyer. I've bought a triton to charge them on. When delivered they are supposed to hold 50%...
08-24-2003, 04:31 PM
Replies: 1
Views: 613
Posted By Reeb

Concept 30DX rotor blade upgrade help

just order a set of SR rotor grips. The SR blades have the black plastic bits on either side of the actual blade root, making them thicker. Or..you could get hold of some aluminium blade grips, Zeal....
08-23-2003, 01:29 PM
Replies: 2
Views: 731
Posted By Reeb

Kokam 1020 and Triton, what am I doing wrong...

Wreck, did you find out what the problem was?
08-18-2003, 09:37 AM
Replies: 33
Views: 3,218
Posted By Reeb

Slow Stick

35mins, that sounds excellent.

So the 850mah packs you use, are they the correct weight for the pico stick? Does that mean the 1200 cells are too heavy?
08-17-2003, 07:40 PM
Replies: 33
Views: 3,218
Posted By Reeb

Slow Stick

great, so NOW I found out about the slow stick. I took delivery of a pico stick a few days ago and went out for the first time today. Luckily it was windless so it flew really well. I fly helis and...
Replies: 9
Views: 751
Posted By Reeb

Next radio after this one

well there is a JR PCM 10 going reasonably cheap. It's not the 10X version though - is there a big difference? Is it worth getting the PCM10 for US$600 ?
Replies: 9
Views: 751
Posted By Reeb

Next radio after this one

thanks. Yeah I don't think the phase shift is an issue over here.

What about recommendations for a followup transmitter guys?
Replies: 9
Views: 751
Posted By Reeb

Next radio after this one

Hi, I have an Eclispe transmitter and am considering a GV1 but that
needs a few extra channels to be able to select different rotor speeds
from the trannie. Can anyone recommend a good (but not...
Showing results 1 to 25 of 42
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.