RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: rx7devil210
Showing results 1 to 25 of 246
Search took 0.20 seconds.
05-05-2013, 09:00 PM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

Car tune whats your number I need your help over the phone?
05-03-2013, 09:24 PM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

Alright I fixed the throttle linkage thanks guys! But now it wont idle it keeps accelerating. I check the bell housing it spins freely and when I mess with the needles settings I can get it to idle...
05-03-2013, 11:55 AM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

Also my throttle linkage pops off the throttle body every time I apply the brakes any ideas?
05-01-2013, 10:37 AM
04-30-2013, 07:17 PM
Replies: 3
Views: 729
Posted By rx7devil210

RE: rs4 brake help

Yea I had that problem to solve the problem turn on your car and transmitter apply the brakes and look in your carb to see if there is a small open gap. That should stop chocking the engine.
04-28-2013, 07:10 PM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

Does anyone know if the carb is supposed to rotate? Meaning the the hole in the carb spins around</p>

</p>

 </p>
04-28-2013, 07:08 PM
Replies: 3
Views: 539
Posted By rx7devil210

RE: Acceleration issue

I figured it out it was the clutch springs and shoes weren't on there right.
04-27-2013, 06:53 PM
Replies: 3
Views: 539
Posted By rx7devil210

Acceleration issue

Alright I just got my new carburetor installed. Reason I had to get a new carburetor was because it would go open throttle after id apply the brakes. Now when I start it it keeps accelerating. Any...
04-22-2013, 07:00 PM
Replies: 5
Views: 676
Posted By rx7devil210

RE: clutch bell help

Yea they spin freely!</p>

</p>
04-15-2013, 04:07 PM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

Figured it out my carburetor was loose. I have to order a new lock pin for the carburetor cause I stripped it.
04-15-2013, 02:07 PM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

Its the same servo horn ive been using the whole time while it was running. I don't think it could be the servo horn. But im taking it to my lhs here in a couple hours. Hopefully they can help me out...
04-15-2013, 01:33 PM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

I dunno the whole car moves when I brake. After I brake the car goes to wide open throttle.
04-15-2013, 12:09 PM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

I did unscrew it and screwed back on without taking the brake or throttle line off. I think its the servo horn because after I brake it goes to open throttle and I can push the horn back a little and...
04-14-2013, 07:10 PM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

Could it be the thing that screws on to the servo?
04-14-2013, 06:59 PM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

Yea hpi sent me a new futaba servo and it still did it. But it was running good for like 30 mins while I based and towards the end it started to do that. Im taking it to my lhs next week.
04-10-2013, 07:59 PM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

I installed the throttle servo but it still goes back to half throttle after I brake. Meaning after I brake it randomly takes off. I broke my throttle arm :( I guess bashing will have to wait. Any...
04-10-2013, 06:26 PM
Replies: 7
Views: 2,469
Posted By rx7devil210

RE: glow plug help!

I got 3 off ebay iridium platinums for 10 bucks.
04-04-2013, 11:48 AM
Replies: 3
Views: 566
Posted By rx7devil210

RE: Rs4 EVO + losing control

Could be the throttle servo, or maybe the clutch springs are enganging. Take the bell housing out and check the springs. </p>
04-03-2013, 03:35 PM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

My bad for doing 3 posts in one time. I figured it out had nothing to do with the clutch it was the throttle servo. When I applied the brakes it would go back to half open throttle. This is the...
04-03-2013, 02:13 PM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

alright guys got the flywheel in but it when I turn the flywheel the bell housing spins too. It seems like a tight fit. I started it up and it just went crazy on me. Any ideas?
04-03-2013, 12:48 PM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

Alright guys my flywheel came in bout to start the install in a little bit.
03-31-2013, 11:28 AM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

Nice car tune where is this drags strip at? I wish we had a drag strip here in San Antonio.
03-30-2013, 06:27 PM
Replies: 6,263
Views: 548,894
Posted By rx7devil210

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

Here is a link on what I ordered car tune. http://www.ebay.com/itm/Alloy-Lighter-Fly-Wheel-For-Car-HPI-Nitro-RS4-3-/130506107053?pt=US_Radio_Control_Control_Line&amp;hash=item1e62c528ad
Showing results 1 to 25 of 246
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.