RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: gold teef
Showing results 1 to 25 of 66
Search took 0.68 seconds.
Forum: Speed - RC Gas Boats
06-30-2008, 07:07 PM
Replies: 2
Views: 449
Posted By gold teef

anyone know where to buy graphics ?

graphics for rc boat in general
Forum: Speed - RC Gas Boats
05-19-2008, 03:19 AM
Replies: 1,378
Views: 179,384
Posted By gold teef

RE: New GAS Boats from Venom!!

hey iam from idaho,twin falls and i dont even know whee hayden id is?? cool boats though. and here i thought i was the only one in idaho who had a gas boat ...lol jk
Forum: Speed - RC Gas Boats
07-15-2006, 02:24 PM
Replies: 5
Views: 636
Posted By gold teef

pics needed of shaft tube install without tbar.

also i have had the iso pad thing ,personally don't like it it keeps failing .any pics of maybe a glassed in, or other way would be nice thanks
Forum: Speed - RC Gas Boats
09-18-2005, 02:01 PM
Replies: 2
Views: 706
Posted By gold teef

walbro 257 carb wo/bulb ????help

does this carb without the bulb ,does the fuel tank have to sealed tight with no air leaks or does the tank have to be pressurized with just one tube from the tank to the carb and be air tight.
Forum: Speed - RC Gas Boats
09-17-2005, 07:47 PM
Replies: 5
Views: 816
Posted By gold teef

257 CARB PROBLEM? MABEY?

my z 260 is running erratically, when i set the low at 2 1/4 turns and the high to 1 turn it will be ok for like a lap then it either dies, or i mess with the idle screw in order to keep it idling...
Forum: RC Airboats
06-18-2005, 01:23 PM
Replies: 7
Views: 1,316
Posted By gold teef

hey try an air scoop !!!!

hey i have a basic boogie board design air boat i do alot of grass driving with .it it has an os four stroke 91 surpass ,it hauls but i was always flipping it .so i slammed a homemade air scoop made...
Forum: Speed - RC Gas Boats
11-22-2004, 10:00 PM
Replies: 1
Views: 538
Posted By gold teef

help on ultra thin gaskets for g 260

ok i replaced the original head gasket with those ultra thin gaskets,, but now it wont start very easy.. is there a certain way the ring should be facing on the piston ,the gap on the ring is what i...
Forum: Speed - RC Gas Boats
11-02-2004, 12:16 AM
Replies: 2
Views: 614
Posted By gold teef

ok my carb intake block was warped,do I???

ok i sanded down the back like fast rat said ,,do i also sand down the front where the carb meets the plastic intake block????i also trimed the bolts a little too, so they wont do that Bull--SH--NIKE...
Forum: Speed - RC Gas Boats
10-27-2004, 01:12 PM
Replies: 7
Views: 1,049
Posted By gold teef

RE: hey im new

hey look up shark racing ,rc boats they have all kinds of good info about boating
Forum: Speed - RC Gas Boats
10-26-2004, 03:19 AM
Replies: 1
Views: 605
Posted By gold teef

help my zen 260 just wont keep running

i have tryed all differnt types of carb setting. its like it never keeps a needle setting.i will go around a lap or so, then when i throttle down it just dies, so then all set the idle up a bit to...
Forum: Speed - RC Gas Boats
10-24-2004, 01:06 AM
Replies: 2
Views: 715
Posted By gold teef

are there any mods for the wt-644 stock carb

well ????i hate that carb
Forum: Speed - RC Gas Boats
10-21-2004, 12:17 AM
Replies: 1
Views: 646
Posted By gold teef

which is better wa-167 or wt -644 for g260??

if the wt -644 is better are there any mods that can be done to it ,because is has a frickin choke vs the 167 that dont,the 167 looks a bit smaller.
Forum: Speed - RC Gas Boats
09-18-2004, 11:06 AM
Replies: 5
Views: 794
Posted By gold teef

help with new zenoah g 260

i just got this engine from komtsu ,had it running fine couple of pulls and it was off ,,but this last week at the lake it seen something was up after about 5 mins it just died .was kind of hot and...
Forum: Speed - RC Gas Boats
09-05-2004, 11:08 AM
Replies: 2
Views: 1,182
Posted By gold teef

water pick up ????wheres the best place to

where is the best place to put this i have the whh dual rudder setup so there isnt on in the rudder ,what size, or how big around of water pickup can i make or is it possible to make one youself. if...
Forum: Speed - RC Gas Boats
08-15-2004, 09:59 AM
Replies: 3
Views: 1,253
Posted By gold teef

help water coming in from my stuffing tube..

it dosnt matter how much greese i put up there it spits it out and water starts to come in is there some way to make a water tight stuffing tube homemade or whats the best way to have a water tight...
Forum: Speed - RC Gas Boats
08-12-2004, 08:40 PM
Replies: 2
Views: 599
Posted By gold teef

PUSLE line on zeanoah 260 for water pump?>?

where do i get a pulse for my water pump for my zeanoah g 260 pum ,where do i put one or where can i put one ,like best location or easyest place .....
Forum: Speed - RC Gas Boats
08-04-2004, 10:59 AM
Replies: 2
Views: 612
Posted By gold teef

help my boat aint hooken up !!! whats up

i dont know if it is a weight issue or wrong prop ,which is a ocura x472 on a cobra int rc drive .. for some reason when i go full throttle it revs high but barley moves and when i turn the rudder it...
Forum: RC Boats General Discussion
07-27-2004, 02:39 PM
Replies: 0
Views: 345
Posted By gold teef

MOVED: help setting up surface drive

Speed - Gas Boats: http://www.rcuniverse.com/forum/fb.asp?m=2027886
Forum: Speed - RC Gas Boats
07-27-2004, 10:59 AM
Replies: 3
Views: 856
Posted By gold teef

help setting up surface drive

i have just recived a Int"rc cobra outdrive "as seen on ebay" i got that part figured out its the rudder part thats confusing me i have a standered offset rudder with standoff also the old strut i...
Forum: Speed - RC Gas Boats
06-28-2004, 01:11 PM
Replies: 3
Views: 747
Posted By gold teef

ok whats with this walbro carb ??

i have a homelight 30 cc that came with the wyj carb not installed, from walbro ,but i cant figure out how to get it to mount on there ,the holes dont line up on the gaskets ot the manifold deal any...
Forum: Speed - RC Gas Boats
06-24-2004, 06:46 AM
Replies: 5
Views: 1,042
Posted By gold teef

hey all you hardcore boat people i got a ??

any one of you ever heard of an "american eagle deep vee 60'" heres a pic, i cant seem to find anything about this boat any where .has a 30cc home..in it ,just wondering if anyone knows any thing...
Forum: RC Airboats
06-12-2004, 12:06 PM
Replies: 1
Views: 426
Posted By gold teef

hey daddy i have ?on the blue airforce boat pic on your new site

hey is that an air rudder on that ??? or does it have the standard rudder and if it is a air rudder how does it work ???any good ?? i have an air-force to I'm not to pleased kinda lame...
Forum: RC Airboats
06-11-2004, 01:39 PM
Replies: 3
Views: 492
Posted By gold teef

hey got a quik ??on cg

i finally got my steering problem fix i lowed the mount and cut my rudder in half both ways now she turns on a dime but the problem .well really not a problem is when its full speed it tends to...
Forum: RC Warbirds and Warplanes
05-28-2004, 05:39 PM
Replies: 1
Views: 487
Posted By gold teef

hey anyone have any pics of there gp stukas with glassed firewall mod??

HEY ANY PICS OUT THERE WOULD GREATLY HELP ,,ON A SIDE NOTE HOW DO YOU GET TO THE GLOW PLUG ONCE ITS BUILT IN ORDER TO START IT...
Showing results 1 to 25 of 66
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.