RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: HiOne
Showing results 1 to 7 of 7
Search took 0.69 seconds.
Replies: 4
Views: 721
Posted By HiOne

RE: Programming EXPERT GLOW DRIVER w/8103

I'm using the saito 100 inverted in a u can do 60 and everytime i came in low and slow ,then pulled vertical to hover at about 20'then hammered in the throttle to hold my hover the engine would just...
Replies: 4
Views: 721
Posted By HiOne

Programming EXPERT GLOW DRIVER w/8103

Hi all:D
This is my first post on RC Universe and let me tell ya's this is a great place to look for anything i want to know.My question is "I have a JR 8103 radio and just bought a EXPERT on board...
03-18-2004, 09:39 PM
Replies: 3
Views: 470
Posted By HiOne

RE: Balancing and trimming the aero hawk

also if you have a pushrod(like one that attaches to a servo arm in an airplane )you can cut it to the same length as the old one you broke and get your bird back in the air quickly
03-16-2004, 07:44 AM
Replies: 3
Views: 470
Posted By HiOne

RE: Balancing and trimming the aero hawk

believe it or not but you need to tighten the main rotor blades pretty tight almost to the point where they wont move then when you go to fly it straighten them out as straight as you can then the...
03-16-2004, 07:36 AM
Replies: 3
Views: 339
Posted By HiOne

RE: setting up the futaba 7 cap

Is your hawk a ccpm?
the venture is 120degrees ccpm and i am having problems getting the pitch to work with the throttle when i set it up according to the book then the expo dial is what controls...
03-15-2004, 07:35 PM
Replies: 3
Views: 339
Posted By HiOne

setting up the futaba 7 cap

i am still looking for help setting up my 7cap radio to work with my venture 30!Can anyone please help ?
03-14-2004, 08:06 PM
Replies: 0
Views: 317
Posted By HiOne

Using the futaba7cap w/venture 30

I am totally new to helli's ,i got my hands on a aerohawk and learned to hover it pretty well,after a few tail rotor blades and tail motors,mainshafts...etc Now i am into gas powered and there's alot...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.