RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: flyitrite
Showing results 1 to 10 of 10
Search took 0.02 seconds.
Forum: Gas Engines
11-02-2014, 11:04 AM
Replies: 2,224
Views: 445,182
Posted By flyitrite

Current prop is the Evolution 13x6. It peaks to...

Current prop is the Evolution 13x6. It peaks to 10570 and is tuned to 10300. 450 ele. 58F It is so much better with the Macs in my opinion. I will try an APC 13x6 when I can make a locater...
Forum: Gas Engines
11-01-2014, 05:52 PM
Replies: 2,224
Views: 445,182
Posted By flyitrite

Also looked at temps today since I tuned it , but...

Also looked at temps today since I tuned it , but I was surprised by the increase in head temp after holding the nose up at full throttle. Anybody look at temp during hard flight or long verticals?...
Forum: Gas Engines
11-01-2014, 05:39 PM
Replies: 2,224
Views: 445,182
Posted By flyitrite

Don't have the 20cc Swordsn. Hey Ahicks, you...

Don't have the 20cc Swordsn. Hey Ahicks, you mentioned earlier about the back pressure when I said I was considering taking out the baffle. That got me wondering about nose-up/nose down testing and...
Forum: Gas Engines
10-26-2014, 04:42 PM
Replies: 2,224
Views: 445,182
Posted By flyitrite

A tiny pumper would be the cat's meow. Today was...

A tiny pumper would be the cat's meow. Today was goooood. The 13x6 is THE hot ticket with this plane. After 2/3 of a gallon I decided to lean to peak and back down a touch then filled the tank (4oz...
Forum: Gas Engines
10-25-2014, 05:06 PM
Replies: 2,224
Views: 445,182
Posted By flyitrite

I ran the engine today with the new Macs pipe....

I ran the engine today with the new Macs pipe. The same 12x8 Evo prop did pick up rpm. It went from about 9500 to 9850 static. It also had a different sound. The high speed needle had to be turned in...
Forum: Gas Engines
10-24-2014, 05:51 PM
Replies: 2,224
Views: 445,182
Posted By flyitrite

Nothing? Still wondering where everyone has their...

Nothing? Still wondering where everyone has their needles at. Hope to try Macs pipe this weekend with the 12x8 Evo prop. Anybody have numbers for that? I am getting 95 to 96k. This is a great...
Forum: Gas Engines
10-17-2014, 05:55 PM
Replies: 2,224
Views: 445,182
Posted By flyitrite

Ran the engine more today, about a half gallon...

Ran the engine more today, about a half gallon total through it so far. This is the 2nd one of these 10cc's I have used and at this point I think I can say they are indeed good engines. I have also...
Forum: Gas Engines
10-13-2014, 02:06 PM
Replies: 2,224
Views: 445,182
Posted By flyitrite

The plane I have this one on comes in at 5lb 2oz...

The plane I have this one on comes in at 5lb 2oz . It had good vertical with the 10x6 MA. Now it has a 12x6 MA and is powerful. I am using a 4oz tank, Tech aero ibec, 700mah life battery. Lots of...
Forum: Gas Engines
10-13-2014, 08:50 AM
Replies: 2,224
Views: 445,182
Posted By flyitrite

I was thinking along the line of something like a...

I was thinking along the line of something like a Cline regulator or perhaps how the YS fz series work. These types only allow fuel to pass if there is a demand ( pull from the engine) and permit...
Forum: Gas Engines
10-12-2014, 05:39 PM
Replies: 2,224
Views: 445,182
Posted By flyitrite

Hello all, I installed the 10cc in an Escapade...

Hello all, I installed the 10cc in an Escapade Mx and have been running it in the last few days. I was wondering about the carb regulator, is it a demand type? I have not disassembled it to examine...
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.