RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: Fly Mower
Showing results 1 to 25 of 81
Search took 0.06 seconds.
Forum: RC Jets
10-02-2016, 07:21 PM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

Put a small Flat on the pin, use a new (sharp)...

Put a small Flat on the pin, use a new (sharp) grub screw and thread-lock it.
Forum: RC Jets
09-28-2016, 12:47 AM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

Looks good to me....

Looks good to me....
Forum: RC Jets
09-27-2016, 05:03 PM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

Simon is spot-on that you want as little of the...

Simon is spot-on that you want as little of the cone sticking out the back as possible to minimise any weight you may have to add up front to balance it out. But that said, at the same time you don't...
Forum: RC Jets
09-18-2016, 09:01 AM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

Another 7 flights on my Xcalibur today...! We...

Another 7 flights on my Xcalibur today...! We were blessed with zero wind so I tried CROW..... I configured it to come in with full flaps, about 6mm as recommended on here.

It work brilliantly,...
Forum: RC Jets
09-12-2016, 05:57 AM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

Welcome Steve. You are going to love it..... ...

Welcome Steve. You are going to love it.....

Keep the pictures (and any questions) coming.....
Forum: RC Jets
08-29-2016, 12:26 AM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

Thanks Simon, How much CROW do you use then...

Thanks Simon, How much CROW do you use then (mm)..?
Forum: RC Jets
08-28-2016, 09:58 PM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

Pretty much the same experience here and I'm also...

Pretty much the same experience here and I'm also using the JM100XBL. I know from the specs the JM has nearly three times the residual trust than the equivalent JetCat100.

I'm going to give CROW a...
Forum: RC Jets
08-26-2016, 10:34 PM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

1) Without question...

1) Without question...
Forum: RC Jets
03-05-2016, 11:09 PM
Replies: 16
Views: 6,356
Posted By Fly Mower

if I remember correctly the AR12120 has two blue...

if I remember correctly the AR12120 has two blue LEDs to show when a battery is connected and active. Turning off the smart switch also turns (both) the LED's off signifying the non-pass through of...
Forum: RC Jets
02-27-2016, 10:39 PM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

Looking good there Flaps2012..... I see you...

Looking good there Flaps2012.....

I see you have used the supplied short pieces of silicon for the 'keepers' on the control rod clevis's. A great tip I picked up on here, again from Dave W, was to...
Forum: RC Jets
02-20-2016, 12:03 AM
Replies: 8
Views: 2,670
Posted By Fly Mower

Just popped out to the workshop to power a model...

Just popped out to the workshop to power a model up and get these screen grabs for you;

In Device Explorer look into the CB200. Then General Settings and then Expander Settings (EXT). You can then...
Forum: RC Jets
02-19-2016, 06:57 AM
Replies: 8
Views: 2,670
Posted By Fly Mower

I recently had exactly the same experience...

I recently had exactly the same experience setting this up. In the end it was due to the EXT port not being configured as a 'Telemetry Input' as mentioned above.

I plugged the sensor into one of...
Forum: RC Jets
02-18-2016, 09:50 PM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

Electron make a set of Electric retracts that a...

Electron make a set of Electric retracts that a few here have fitted.....

https://www.electron-retracts.com/product/xcalibur-combo/

The standard air retracts from Ripmax are very very good...
Forum: RC Jets
02-15-2016, 11:30 PM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

Jeremy, I have been through this with a GBR...

Jeremy,

I have been through this with a GBR CAT. (See post 1307# Page 53 onward in this thread).

If you use something like the Festo range of reducers (the brass type not the plastic pressure...
Forum: RC Jets
02-11-2016, 06:43 AM
Replies: 3,501
Views: 596,133
Posted By Fly Mower

SD Card full maybe?

SD Card full maybe?
Forum: RC Jets
01-23-2016, 08:53 AM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

Had a chat with a friend today who owns a boat...

Had a chat with a friend today who owns a boat chandlers; seems algae in Diesel / Kero etc. is a common problem (with boats anyway)

Apparently its due to condensation forming in the tank and then...
Forum: RC Jets
01-23-2016, 12:58 AM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

I fill via the UAT - Its a GBR CAT so the fill /...

I fill via the UAT - Its a GBR CAT so the fill / drain doesn't go via the filter so hopefully that's still clean! And I use a filtered clunk based on the recommendations in this thread. I assume...
Forum: RC Jets
01-23-2016, 12:56 AM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

The main caddy is clean as is the secondary caddy...

The main caddy is clean as is the secondary caddy I use to fill the main caddy...! (Taxi tank is okay also).

I use a Mr Funnel when decanting the raw Kero to get any excess water out and to be...
Forum: RC Jets
01-22-2016, 09:15 AM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

No, just heating Kero! Any ideas Dave how...

No, just heating Kero!

Any ideas Dave how to address and should I use A1 rather than the heating Kero stuff.
Forum: RC Jets
01-22-2016, 09:02 AM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

Just doing a bit of a winter health check on my...

Just doing a bit of a winter health check on my Xcalibur. Mid way through I lifted out the tank and the bottom looks like this.............

I filter everything several times! Do I have fungus...
Forum: RC Jets
01-09-2016, 08:56 PM
Replies: 2,111
Views: 492,273
Posted By Fly Mower

I've asked this question on the DS-16 thread but...

I've asked this question on the DS-16 thread but no answer......

Can somebody enlighten me on the new multi-mode gimbals. Can these be configured to give a super smooth feel on the throttle stick...
Forum: RC Jets
01-06-2016, 09:16 AM
Replies: 3,501
Views: 596,133
Posted By Fly Mower

Does anyone have any experience of the new...

Does anyone have any experience of the new multi-mode gimbals on the colored DS-16 units..?

Do they offer any advantages over the older 'standard' gimbals other than the obvious ability to change...
Forum: RC Jets
12-15-2015, 11:33 PM
Replies: 12
Views: 2,829
Posted By Fly Mower

I too have a 100XBL in a Xcalibur. It's my first...

I too have a 100XBL in a Xcalibur. It's my first turbine model and now has approximately 5 hours run time during which the 100XBL has given me everything it should (and perhaps most importantly for...
Forum: RC Jets
12-11-2015, 09:09 AM
Replies: 2,625
Views: 735,682
Posted By Fly Mower

Two years or 25 hours run time, which ever comes...

Two years or 25 hours run time, which ever comes first.....

100XBL in my Xcalibur also and I only fly off concrete. I have no issues with 'creep' due to residual idle trust or any issues on...
Forum: RC Jets
12-06-2015, 03:38 AM
Replies: 3,501
Views: 596,133
Posted By Fly Mower

Guys, I considering the jump to Jeti (DS-16)...

Guys,

I considering the jump to Jeti (DS-16) and after a couple of weeks or reading and youtube I'm pretty well versed on the technical / programming capability. Although I'm struggling to find...
Showing results 1 to 25 of 81
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.