RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: raybaines
Showing results 1 to 25 of 31
Search took 0.06 seconds.
06-25-2017, 10:40 PM
Replies: 487
Views: 123,845
Posted By raybaines

Smile OK chaps !! Tail end now complete ... all glass...

OK chaps !!
Tail end now complete ... all glass work done.
Have decided to try the two blade 19 x 8 option for the initial flight.
Hmmmm ....
06-11-2017, 06:12 PM
Replies: 487
Views: 123,845
Posted By raybaines

Ken ... Great to hear that your Hurricane is...

Ken ...
Great to hear that your Hurricane is performing well after your rebuild ... fantastic effort !!!
Sandy ....
Did the Biela 18x10 three blade overpower the DLE 35 RA at all ??

Hope I can...
06-11-2017, 04:04 AM
Replies: 487
Views: 123,845
Posted By raybaines

Almost Home!!

It has been a while .... But getting close now !!

Ray.
02-02-2017, 03:54 PM
Replies: 1,865
Views: 623,652
Posted By raybaines

Pawnee 235

Maneuvering in for the last run of the morning !!
I have been operating this Pawnee 235 for a couple of seasons now ....
All great fun !!

Ray.
Forum: RC Jets
04-17-2016, 04:00 PM
Replies: 692
Views: 111,204
Posted By raybaines

Warbird_1 .... Thanks for your reply ......

Warbird_1 ....

Thanks for your reply ... sounds like JR will have to address this issue !!

Ray.
Forum: RC Jets
04-17-2016, 03:26 PM
Replies: 692
Views: 111,204
Posted By raybaines

Having recently purchased my 28x .. I would ask...

Having recently purchased my 28x .. I would ask if there has been a definitive answer given as to the linking of voice to add on flight modes ? On my aircraft setup I have a three position switch...
04-13-2016, 01:31 PM
Replies: 487
Views: 123,845
Posted By raybaines

G'day Terry ... I have used fiberglass circuit...

G'day Terry ...
I have used fiberglass circuit board for my control horns with excellent results.
Cut to shape and epoxied in to the control surface.
Here are a couple of shots from an earlier...
03-25-2016, 02:12 AM
Replies: 487
Views: 123,845
Posted By raybaines

By Cripes Ian !!! You have done some...

By Cripes Ian !!!
You have done some sensational work there ... outstanding !!!

Ray.
02-20-2016, 06:50 PM
Replies: 487
Views: 123,845
Posted By raybaines

Morning Terry, I will be using a cable system...

Morning Terry,
I will be using a cable system for the rudder and tail wheel.
For the elevator I will go with a dual servo setup...
A servo for each elevator half linked by a short 4:40 pushrod ......
02-20-2016, 02:01 PM
Replies: 487
Views: 123,845
Posted By raybaines

Awe inspiring effort Ken !!! I truly hope your...

Awe inspiring effort Ken !!!
I truly hope your next outing will be successful ....
Once again ...... Well Done !!!

Ray.
02-14-2016, 02:49 PM
Replies: 487
Views: 123,845
Posted By raybaines

http://www.rcuniverse.com/forum/attachment.php?att...

http://www.rcuniverse.com/forum/attachment.php?attachmentid=2147277http://www.rcuniverse.com/forum/attachment.php?attachmentid=2147278Don`t want to get to far off topic here but Terry was a good...
02-14-2016, 02:28 AM
Replies: 487
Views: 123,845
Posted By raybaines

Replica Spitfire .....

http://www.rcuniverse.com/forum/attachment.php?attachmentid=2147173
02-12-2016, 12:51 PM
Replies: 487
Views: 123,845
Posted By raybaines

http://www.rcuniverse.com/forum/attachment.php?att...

http://www.rcuniverse.com/forum/attachment.php?attachmentid=2146895

Thanks Ken !!

Hey Terry .... while I am still looking at some photos ... thought this might bring back some memories .
Don`t...
02-12-2016, 12:14 PM
Replies: 487
Views: 123,845
Posted By raybaines

http://www.rcuniverse.com/forum/attachment.php?att...

http://www.rcuniverse.com/forum/attachment.php?attachmentid=2146875http://www.rcuniverse.com/forum/attachment.php?attachmentid=2146876http://www.rcuniverse.com/forum/attachment.php?attachmentid=214687...
02-11-2016, 11:58 PM
Replies: 487
Views: 123,845
Posted By raybaines

http://www.rcuniverse.com/forum/attachment.php?att...

http://www.rcuniverse.com/forum/attachment.php?attachmentid=2146804http://www.rcuniverse.com/forum/attachment.php?attachmentid=2146805
Great Scott !!!
Sounds like a sensational project ... 5/8...
02-10-2016, 03:31 PM
Replies: 487
Views: 123,845
Posted By raybaines

Sounds like a good plan Terry ... I have not...

Sounds like a good plan Terry ...
I have not had my Hurricane on the scales as yet ... not game !!!
Your pilot figure looks as though he will be ready for the first scramble !!
I like your...
02-09-2016, 09:08 PM
Replies: 487
Views: 123,845
Posted By raybaines

Ian ... I am powering the lights with a 2 cell...

Ian ...
I am powering the lights with a 2 cell 7.4 volt lipo through the flightlights v5.0 controller .
The braincube product is a complete lighting system which I have found to be a very good.
On...
02-08-2016, 08:14 PM
Replies: 487
Views: 123,845
Posted By raybaines

Fellows ... I have installed two 25mm LED...

Fellows ...
I have installed two 25mm LED lights from the Braincube Aero-Models range.
I have had good results in some earlier projects with this system.
Will have to complete the glass work for...
02-07-2016, 02:18 PM
Replies: 487
Views: 123,845
Posted By raybaines

Tail wheel now in place and have fitted the...

Tail wheel now in place and have fitted the landing lights !!
All great fun !!
...
01-09-2016, 01:41 AM
Replies: 487
Views: 123,845
Posted By raybaines

Hey OldTimer put that Spit wing back under the...

Hey OldTimer put that Spit wing back under the bench and give a bloke a chance !!!
01-08-2016, 11:56 PM
Replies: 487
Views: 123,845
Posted By raybaines

Roughly $70 US so not cheap .... but hey it`s...

Roughly $70 US so not cheap .... but hey it`s what we do !!

Ray.
01-08-2016, 01:50 AM
Replies: 487
Views: 123,845
Posted By raybaines

http://www.rcuniverse.com/forum/attachment.php?att...

http://www.rcuniverse.com/forum/attachment.php?attachmentid=2140299
G'day Terry ...
The exhaust stacks were purchased from Real Model Pilots out of the UK.
Great service and will supply them to...
01-07-2016, 03:23 PM
Replies: 487
Views: 123,845
Posted By raybaines

http://www.rcuniverse.com/forum/attachment.php?att...

http://www.rcuniverse.com/forum/attachment.php?attachmentid=2140204http://www.rcuniverse.com/forum/attachment.php?attachmentid=2140205http://www.rcuniverse.com/forum/attachment.php?attachmentid=214020...
11-04-2015, 10:46 PM
Replies: 487
Views: 123,845
Posted By raybaines

Terry, The wheels I have used are a solid...

Terry,
The wheels I have used are a solid rubber type : 4 inch diameter
I have modified the hubs for a greater scale appearance .
There appears to be no manufacturers brand on the wheels .... They...
11-04-2015, 03:22 PM
Replies: 487
Views: 123,845
Posted By raybaines

The DLE 35 RA Has gone in nicely and should be...

The DLE 35 RA Has gone in nicely and should be adequately cooled with a little in cowl ducting.

Ray.
Showing results 1 to 25 of 31
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.