RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Nitro77
Showing results 1 to 7 of 7
Search took 0.03 seconds.
Forum: RC Boats General Discussion
01-30-2017, 12:16 PM
Replies: 5
Views: 1,363
Posted By Nitro77

This was posted a while ago but I wanted to add...

This was posted a while ago but I wanted to add my response. I ran my RIO with the stock motor several times. on one of the last runs, I brought it in after about 5 laps. When I refueled and went...
Forum: Speed - RC Gas Boats
01-30-2017, 12:05 PM
Replies: 8
Views: 2,122
Posted By Nitro77

Thanks for the reference. I will check it out. ...

Thanks for the reference. I will check it out. I saw some good videos on youtube of enforcer boats.
Forum: Speed - RC Gas Boats
01-27-2017, 05:26 PM
Replies: 3
Views: 1,446
Posted By Nitro77

I run a kill switch from enforcer (Bonzi) called...

I run a kill switch from enforcer (Bonzi) called Engine Kill Guard (EKG) in my gencat. It is about 40$ from them. It is water proof and unlike my radio failsafe which needs electrical power to...
Forum: Speed - RC Gas Boats
01-27-2017, 05:15 PM
Replies: 8
Views: 2,122
Posted By Nitro77

SUPER-V this is a cool boat and video. I have a...

SUPER-V this is a cool boat and video. I have a magnum but need to convert to old school with a couple of drivers. is the driver and instrument panel from enforcer boats? This is one of the best...
Forum: Speed - RC Gas Boats
08-26-2016, 09:25 PM
Replies: 7
Views: 2,647
Posted By Nitro77

Digerman, Nice work. Thanks again for the...

Digerman, Nice work. Thanks again for the information. Happy boating!
Forum: Speed - RC Gas Boats
08-01-2016, 05:37 AM
Replies: 7
Views: 2,647
Posted By Nitro77

Very good. Did you completely replace the stock...

Very good. Did you completely replace the stock sleeve? Sounds like a machine shop job. As I have seen many posts with people running rio-51s, I would think there might be people interested in...
Forum: Speed - RC Gas Boats
07-31-2016, 09:50 AM
Replies: 7
Views: 2,647
Posted By Nitro77

have you loosened the screws on the stinger? ...

have you loosened the screws on the stinger?
I have seen several posts now where the rio shafts have broken while running. So, I have been looking to replace mine. The thing is,,,, the rio shaft...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.