RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
Search: Posts Made By: ibuild
Showing results 1 to 6 of 6
Search took 0.01 seconds.
Forum: Composites Fabrication And Repair
08-08-2017, 06:23 PM
Replies: 35
Views: 8,739
Posted By ibuild

The purpose of the surface coat is to avoid air...

The purpose of the surface coat is to avoid air bubbles in the mold surface and such, if you are an experienced guy like Pylonracr it does not matter but as a first time it might make it easier to...
Forum: Composites Fabrication And Repair
04-29-2017, 08:45 AM
Replies: 35
Views: 8,739
Posted By ibuild

It depends, if you had any spots that stuck to...

It depends, if you had any spots that stuck to the point that the mold surface was damaged you do the complete routine. I would recommend to do that anyway, in time you will know what is necessary...
Forum: Composites Fabrication And Repair
04-22-2017, 04:38 AM
Replies: 35
Views: 8,739
Posted By ibuild

I just read my own post and that doesn't sound...

I just read my own post and that doesn't sound encouraging at all does it, I guess my strong ability is honesty more than tactical...
Anyway, I think that in most cases the release is easier from...
Forum: Composites Fabrication And Repair
04-20-2017, 10:26 PM
Replies: 35
Views: 8,739
Posted By ibuild

&lt;br /&gt;<br /> &lt;br /&gt;<br /> <br /> ...

&lt;br /&gt;<br />
&lt;br /&gt;<br />
<br />

It's a little mysterious this particular subject to get a nice release when making a mold, one should think there is a simple receipt to make it work but it's...
Forum: Composites Fabrication And Repair
04-12-2017, 03:48 PM
Replies: 35
Views: 8,739
Posted By ibuild

Manks7477, you have gotten past the first barrier...

Manks7477, you have gotten past the first barrier that is actually to do the work, the next time you already know what to do and it makes it alot easier. I wish you did use the PVA the first time, it...
Forum: Composites Fabrication And Repair
04-08-2017, 03:39 AM
Replies: 35
Views: 8,739
Posted By ibuild

The color of typical PVA release film (old or...

The color of typical PVA release film (old or new) is usually no color at all to my experience, but I have a bottle of the Partall brand (Rexco) that is purple, this is a special PVA made to provide...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.