RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Corsair013
Showing results 1 to 9 of 9
Search took 0.01 seconds.
Replies: 15
Views: 957
Posted By Corsair013

Yup, structural reinforcement seems to be the...

Yup, structural reinforcement seems to be the answer.

Thanks!
Replies: 15
Views: 957
Posted By Corsair013

Ok, will do. The mount seemed to be a bit weak...

Ok, will do. The mount seemed to be a bit weak looking.
Replies: 15
Views: 957
Posted By Corsair013

Just tried it now, works just fine all the way up...

Just tried it now, works just fine all the way up to full throttle.

Would a too small prop do this? (vibrate on a too large motor?)
Replies: 15
Views: 957
Posted By Corsair013

Thank you, will try now.

Thank you, will try now.
Replies: 15
Views: 957
Posted By Corsair013

Brand new prop, checked it was balanced. Also...

Brand new prop, checked it was balanced. Also tried the motor with different props and same result. Runs fine without any though.

No evidence of shaft bending, all straight as far as I can see.
Replies: 15
Views: 957
Posted By Corsair013

Here you go, pictures of it with and without the...

Here you go, pictures of it with and without the motor:
Replies: 15
Views: 957
Posted By Corsair013

motor vibrating uncontrollably at high throttle

Why is my rc airplanes motor vibrating uncontrollably at high throttle? I am running a 1500kv Turnigy SK3 spinning a 8x6 prop.
Motor runs offa 30amp esc, and i use a 2200 3cell 25c lipo.

it runs...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.