RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: kyliesgrampa
Showing results 1 to 16 of 16
Search took 0.62 seconds.
Forum: Marketplace
12-04-2020, 06:51 PM
Replies: 3
Views: 1,063
Posted By kyliesgrampa

Storch

I have a Dennis Bryant 93 in if you might be interested in the smaller size. It's well detailed,scale paint, pilot, 91 4 stroke with on board glow, 3 axis gyro. [email protected]
Forum: Marketplace
12-04-2020, 06:45 PM
Replies: 2
Views: 285
Posted By kyliesgrampa

110 rascal

I have a couple sets of red without flaps. Email [email protected]
Forum: Marketplace
02-13-2020, 07:15 AM
Replies: 0
Views: 1,250
Posted By kyliesgrampa

Meridian 10cc hanger 9

Flown 5 or 6 times, like new 10cc gas engine Meridian made by Hanger 9. Plane has 6.6 life batteries, spektrum receiver, ready to fly. I have an extra set of wheel pants to include and a complete...
Forum: RC Warbirds and Warplanes
06-23-2015, 05:24 PM
Replies: 132
Views: 28,771
Posted By kyliesgrampa

Great looking plane. Mine has taken two years to...

Great looking plane. Mine has taken two years to to learn it's odd flying habits. Everyone watching always had the answer, but until you take the stick it is indescribable. My 2 cents is avoid the...
Forum: Beginners
09-19-2011, 05:44 AM
Replies: 74
Views: 9,254
Posted By kyliesgrampa

RE: ASP 108 gonna be the death of me

I have an ASP 1.08 and am happy with it, although with an OS 7D carb Im not happy with low speed performance, loads at idle. ( I am probably trying to idle too low)I went back to a stock muffler from...
Forum: RC Car General Discussions
04-17-2011, 04:58 AM
Replies: 262
Views: 18,813
Posted By kyliesgrampa

RE: Are People Crap Every where????

What interesting reading this post is, the jerk that gambled his kids toy finally got dealt a result for his actions. Something that apparently is not happening in the rest of his life. I think as...
Forum: SuperTigre Engines Support
04-20-2009, 12:23 PM
Replies: 2
Views: 843
Posted By kyliesgrampa

RE: S.T. 51 Runs ok for 30 seconds

2 seperate tanks and fuel lines tried. Both ran other engines with no problems.
Forum: SuperTigre Engines Support
04-20-2009, 12:07 PM
Replies: 2
Views: 843
Posted By kyliesgrampa

S.T. 51 Runs ok for 30 seconds

My ST51 has been mounted on two different planes with the same results. Running 15 nitro and 18 oil, and have tried # 3, #5,#8 plugs with same outcome. Engine starts and idles ok, I advance to full...
Forum: O.S. Engines Support
08-27-2008, 02:59 PM
Replies: 2
Views: 739
Posted By kyliesgrampa

RE: O.S. 61 F/S Touchy high speed needle

Thanks for the response, I will start off with tank pressure perhaps being low. I believe this would be measureable probably inches W.C. Only a 4 inch run for fuel line and they seem to not leak...
Forum: O.S. Engines Support
08-27-2008, 07:33 AM
Replies: 2
Views: 739
Posted By kyliesgrampa

O.S. 61 F/S Touchy high speed needle

I recently purchased a used OS four stroke 61 and am trying to use 12.75 X 3.75 prop. Running 15% nitro and 18% oil.Power is ok, about equal to ST45 on the same plane. My problem is adjusting my...
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
10-23-2007, 08:13 PM
Replies: 5
Views: 1,078
Posted By kyliesgrampa

RE: New HS-81

I just narrowed down my problem on my V-Bat to HS-81 servos not always finding the same center. I have tried all 4 HS 81s that I own and they hunt after stick is released. I tried a different...
Forum: Kit Building
06-15-2007, 06:20 PM
Replies: 67
Views: 34,288
Posted By kyliesgrampa

RE: Proctor Antic-Bipe build

Just came across your thread on the proctor Antic. Looking great, I just got the nerve to maiden mine yesterday, they are definitly worth the effort. Mine is the bipe without the center extension and...
Forum: ARF or RTF
06-07-2006, 01:37 PM
Replies: 13
Views: 1,694
Posted By kyliesgrampa

RE: Rascal 110

Great airplane to fly,my 110 has had the firewall come loose and last night the stab broke 3 out of 4 flying wires, pulling the complete tail feather assy 75% from the fuse. So my 2 cents says its...
Forum: 3D Electric Flying!
10-16-2005, 05:10 PM
Replies: 85
Views: 9,091
Posted By kyliesgrampa

RE: Typhoon Servos Stripped on 6th Flight

I also experienced a stripped elevator servo on the second day of flying the typhoon. Will see if LHS will assist in returning to HZ. Plane received moderate damage. It is VERY difficult to not get...
Forum: Foamies! - RC Electric Foam Aircraft
10-15-2005, 10:57 PM
Replies: 961
Views: 127,572
Posted By kyliesgrampa

RE: Parkzone Typhoon 3D ?

Just adding my second flight experience, with the typhoon, 15 mph wind today and it was great. A little noticeable with the wind gusts, but overall lots of fun, until my rudder servo stripped. Two...
Forum: Glow Engines
04-24-2005, 07:03 PM
Replies: 13
Views: 1,470
Posted By kyliesgrampa

RE: GMS .47 transition problem

I have two GMS 47 engines and have different problems every time I switch them to a different plane. I know you pulled the pressure line and it continued to run, but that does not account for...
Showing results 1 to 16 of 16


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.