RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: ekitik
Showing results 1 to 25 of 37
Search took 0.59 seconds.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-19-2014, 04:21 AM
Replies: 6
Views: 809
Posted By ekitik

Thank you for helping

The responses have been helpful in getting the problem resolved, nice to know you can get good advise around here. Anyway, the new (dual modulating) receiver crystal did the trick.
Now I have one...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-11-2014, 03:47 PM
Replies: 6
Views: 809
Posted By ekitik

scratching my head futaba crystal question

Hello:

I have a high channel receiver (futaba FP R 127 DF dual conversion and a skyport T4VF.

The transmitter has a circle sticker on the back indicating channel 58 then 72.950. My goal was...
Forum: Questions and Answers
08-15-2014, 09:05 AM
Replies: 83
Views: 18,363
Posted By ekitik

Use the premixed fuel from Stihl or moto found...

Use the premixed fuel from Stihl or moto found at homedepot. The premixed fuel is available in two ratios plus has no ethanol like gas at the pump.
Forum: Glow Engines
06-23-2014, 12:24 PM
Replies: 222
Views: 20,362
Posted By ekitik

I am stuborn on glow too, I stick to the 40, 46...

I am stuborn on glow too, I stick to the 40, 46 and 61 for the most part. I like the smell too and I enjoy the fact that it takes a little skill and finesse to keep them in good running form. I dont...
Forum: Crash & Rebuild
02-07-2014, 08:11 AM
Replies: 316
Views: 61,280
Posted By ekitik

I intend to buy and use a restraining device, I...

I intend to buy and use a restraining device, I did get bit once and needed a few stitches on a finger. I had a .25 glow at idle on a engine stand. Was in a hurry and attempted an adjustment from the...
Forum: RC Fuels
03-23-2011, 11:29 AM
Replies: 2
Views: 1,281
Posted By ekitik

RE: Best fuel brand and mixture for cool ops: 2 stroke

You may have over looked this one thing here, if you did not please excuse me.

The opening for the front of the cowl right were the engine fins are should be 1/2 to 1/3 of the exit opening of...
Forum: Glow Engines
03-22-2011, 11:40 AM
Replies: 8
Views: 1,104
Posted By ekitik

RE: NORVEL .15...low end issues, how bout u?

With the 25 and the 074 that I had from Norvel they tuned normally. I did buy them new so , I can not guess at what is making yours act like that.


Make sure the hoses and the tank are good....
Forum: Glow Engines
03-19-2011, 12:46 PM
Replies: 8
Views: 1,104
Posted By ekitik

RE: NORVEL .15...low end issues, how bout u?

First things first.

Get a new a3 glow plug, make sure your tank and hoses are good and your fuel is new. 10 to 15% nitro
18 % oil mix of synthetic and castor (most fuels are good) Morgan...
Forum: Glow Engines
03-12-2011, 09:02 AM
Replies: 109
Views: 10,509
Posted By ekitik

RE: Buy American R/C engines

I know the Fox engines in the right hand can be a wonderful engine. I had two of them and the only complaint I have has to do with the muffler. I don't want a tilt anything. The tilt muffler...
Forum: Glow Engines
03-11-2011, 08:00 AM
Replies: 109
Views: 10,509
Posted By ekitik

RE: Buy American R/C engines

Thank you and very nice.

I have flown Fox and I like them too. I had a 40 delux BB with the spinner!

This is what I am talking about keeping the money here.

I also like that discount...
Forum: Glow Engines
03-11-2011, 07:43 AM
Replies: 109
Views: 10,509
Posted By ekitik

Buy American R/C engines

I fly K&B and I love them.

http://www.kbmfg.com/

I recently found that I really like the idea of only buying American. With this in mind lets all give our business to our brother Americans....
Forum: Giant Scale Aircraft - General
12-16-2007, 11:34 AM
Replies: 3
Views: 669
Posted By ekitik

brass connect and set screw or Quick connect

Hello:

Subject Topflite Corsair 60 gold kit.


I have connected the servo arms to the push rods with the brass block and set screw method. I am using this method for the Elevator and the...
Forum: Questions and Answers
08-23-2007, 04:40 PM
Replies: 1
Views: 382
Posted By ekitik

RE: AP.15rc yellowjacket

Contact these folks for a manual.

Maybe they can email you a pdf or give you a link to look at.


AP Engines; distributed by Global Hobby Distributors, 18480 Bandilier Circle, Fountain...
Forum: Glow Engines
07-12-2007, 07:35 AM
Replies: 15
Views: 1,396
Posted By ekitik

RE: Moving the bearings to a new casting case

Thanks all for the answers I will consider all comments and make a decision.

I love this place as it has helped me out many times.

Eric
Forum: Glow Engines
07-11-2007, 03:18 PM
Replies: 11
Views: 1,310
Posted By ekitik

RE: Gasket material Question..

Please consider this idea.

For a muffler gasket I have used metal duck tape that they use for HVAC which is not to be confused with the tape of the duck which is more common.

Stick a piece...
Forum: Glow Engines
07-11-2007, 02:46 PM
Replies: 15
Views: 1,396
Posted By ekitik

Moving the bearings to a new casting case

I have a SK 50 that runs great. Had a mishap and lawn darted it in. Cleaned the engine but had to discard the OEM muffler. Used a OS 46FX muffler on it and it works pretty good with no problems. The...
Forum: "1/2 A" & "1/8 A" airplanes
03-19-2007, 02:23 PM
Replies: 27
Views: 2,185
Posted By ekitik

RE: insane multi-engine

Why not use 6 electric motors and eliminate the starting and fueling issues.

Just a thought!

Eric
Forum: Glow Engines
02-11-2007, 10:45 AM
Replies: 31
Views: 2,877
Posted By ekitik

RE: what duration will an 4 oz tanks give

Buy a NORVEL BIG MIG 25 it gets the best mileage of any two stroke engine.



GO TO

www.sigmfg.com

And look up 2 stroke engines or read the engine reviews here at rcuniverse.
Forum: "1/2 A" & "1/8 A" airplanes
02-11-2007, 09:42 AM
Replies: 7
Views: 1,026
Posted By ekitik

classic neofun arf and the HS 55 SERVO

Hey all:

Just bought the new classic arf from NEOFUN powering with an 074 norvel

Also just got the package for the servos the hs55 and boy they look smaller than i expected.

Can...
Forum: ARF or RTF
01-26-2007, 01:53 PM
Replies: 10
Views: 5,786
Posted By ekitik

RE: What size fuel Tank

Hello:

Based on the calculation that a 10cc glow motor has a 16oz fuel tank you get 1.6 to 1.

25(1.6)= comes to 40 oz.:eek:

dubro makes one and they also make a 50 oz if you have the...
Forum: Sport Flying
12-11-2006, 11:17 AM
Replies: 218
Views: 25,439
Posted By ekitik

RE: Why overpower airplanes? A rant...

I had a great planes cub 60 size with a 90 inch wingspan with a 91 os II and after flying it I believe it would have been better to use a 70 osII which was the lower of the range.

I ran a os61...
Forum: Sport Flying
08-17-2006, 02:26 PM
Replies: 10
Views: 818
Posted By ekitik

RE: Problems with the GP CAP 232

Checked the plane to the book and found that my best friend screwed up.

Bottom line::D

After marking the correct (new) cg points the bird was tail heavy.

Thank you all very much so...
Forum: Sport Flying
08-16-2006, 01:17 PM
Replies: 10
Views: 818
Posted By ekitik

RE: Problems with the GP CAP 232

Yes, It was a kit. Thanks again
Eric
Forum: Sport Flying
08-16-2006, 10:31 AM
Replies: 10
Views: 818
Posted By ekitik

RE: Problems with the GP CAP 232

Thanks to all who helped. We will be going back to the manual and checking the cg to make sure we are doing it right. Maybe put it up on a cg machine who knows. Tail heavy sound right but I must read...
Forum: Sport Flying
08-15-2006, 02:23 PM
Replies: 10
Views: 818
Posted By ekitik

Problems with the GP CAP 232

Plane flies roughly. Noses up then down with the smallest input in the elevator. Had to fly around using trim then line up and land it.

It was a handful.

The setup

FL70 OS,Futaba s148s...
Showing results 1 to 25 of 37
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.