RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: SGC
Showing results 1 to 6 of 6
Search took 0.11 seconds.
Forum: "1/2 A" & "1/8 A" airplanes
11-23-2006, 01:57 AM
Replies: 13
Views: 1,393
Posted By SGC

RE: Cox QueenBee upgrade-more cubes

CP,
Im makeing a split heat sheild that will clamp on the rod to draw heat away and stop it traveling up to the ball socket and also sheild the piston from the heat of the brazeing. As for the...
Forum: "1/2 A" & "1/8 A" airplanes
11-23-2006, 12:42 AM
Replies: 13
Views: 1,393
Posted By SGC

RE: Cox QueenBee upgrade-more cubes

CP,
Saddly a lot were disapointed to find all they had was an overweight motor that was about the same output as a BabyBee, I bought this knowing its limitations and intending to do this mod,...
Forum: "1/2 A" & "1/8 A" airplanes
11-23-2006, 12:21 AM
Replies: 13
Views: 1,393
Posted By SGC

RE: Cox QueenBee upgrade-more cubes

CP ,
Well I hope it is, so far it all looks good, only the prop No's will tell the true story, but more capacity certainly cant hurt.
Stewart
Forum: "1/2 A" & "1/8 A" airplanes
11-23-2006, 12:12 AM
Replies: 13
Views: 1,393
Posted By SGC

RE: Cox QueenBee upgrade-more cubes

Thanks , I'll try my local plumbers first seeing its a plumbing item.
Cox really missed the boat on the QB design. It has so much untapped potential, if I had a lathe I'ed do the obviouse and make...
Forum: "1/2 A" & "1/8 A" airplanes
11-22-2006, 11:47 PM
Replies: 13
Views: 1,393
Posted By SGC

RE: Cox QueenBee upgrade-more cubes

The engine modded as above will have the same working stroke as an 09, ie from TDC to exhaust port opens , but the exhaust and tranfer durations will be reduced , but as these are quite large on a TD...
Forum: "1/2 A" & "1/8 A" airplanes
11-22-2006, 09:57 PM
Replies: 13
Views: 1,393
Posted By SGC

Cox QueenBee upgrade-more cubes

I got my first QueenBee recently , it was well used and with a bent rod. Needing a new piston /cylinder I looked at fitting a TD09 piston/cylinder.
Well initial fitting of one of my TD cylinders...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.