RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: freakingfast
Showing results 1 to 10 of 10
Search took 0.04 seconds.
Forum: Glow Engines
01-12-2011, 09:10 PM
Replies: 154
Views: 34,330
Posted By freakingfast

RE: OS 55AX problems

If there is any question, always error on the side of the customer.
Forum: Glow Engines
06-29-2010, 09:09 PM
Replies: 154
Views: 34,330
Posted By freakingfast

RE: OS 55AX problems

Ten ata-boy's Mike! And thanks for getting back to us Steve!
Forum: Glow Engines
06-28-2010, 07:43 PM
Replies: 154
Views: 34,330
Posted By freakingfast

RE: OS 55AX problems

I have had this happen on an engine before, however this doesn't apply to the 55AX as it has a slanted to the rear,carb mounted HS needle. The only AX series engine that has a remote needle is the...
Forum: Glow Engines
06-27-2010, 04:10 PM
Replies: 154
Views: 34,330
Posted By freakingfast

RE: OS 55AX problems

Well, what has changed?......the weather, it's getting warmer and sometimes what you could get away with then, you cant now & vice versa. The 12X6 and the 13X6, I could see some potential problems...
Forum: Glow Engines
06-26-2010, 10:43 PM
Replies: 154
Views: 34,330
Posted By freakingfast

RE: OS 55AX problems

What prop, what plug, what fuel(oil type/%nitro). Is it cowled in (poor air flow), are you able to observe the fuel line to the carb when it quits and are there bubbles in the line?
Forum: Glow Engines
06-10-2010, 08:35 PM
Replies: 154
Views: 34,330
Posted By freakingfast

RE: OS 55AX problems

Sometimes it's the most subtle of things that cause problems. It may be time to start from square one and eliminate each potential problem one at a time. Correct glow plug, fuel, prop, cooling and...
Forum: Glow Engines
06-09-2010, 11:24 PM
Replies: 154
Views: 34,330
Posted By freakingfast

RE: OS 55AX problems

There it is....Bing,bingo!
Way too much prop, Yeh...I know what the manual says. Try a APC 11X6 or a Master Airscrew 11X7 S-2 series for sport, 12X5 scale. Loose the all synthetic or add some...
Forum: Glow Engines
06-09-2010, 09:05 PM
Replies: 154
Views: 34,330
Posted By freakingfast

RE: OS 55AX problems

What prop, what plane, what fuel?
If you have things set up right, these things run for years without a hiccup.
It's very,very rare to have a dud.
If it has been hurt too many times, it's not...
Forum: Glow Engines
06-06-2010, 04:04 PM
Replies: 154
Views: 34,330
Posted By freakingfast

RE: OS 55AX problems

I think you have proven that it is your setup.
Is your fuel tank well centered to your carburetor? When inverted, is the carb a lot higher than tank center? A pinhole on the bottom of the clunk...
Forum: Glow Engines
06-06-2010, 03:35 PM
Replies: 154
Views: 34,330
Posted By freakingfast

RE: OS 55AX problems

You may have a fuel foaming problem. This can happen when the fuel level lowers and there is more air available to mix in to the fuel. Try to isolate the tank with REAL foam rubber such as Dubro's...
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.