RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: evlfkr
Showing results 1 to 6 of 6
Search took 0.10 seconds.
Forum: Redcat Racing Support
03-05-2007, 09:02 PM
Replies: 3,672
Views: 318,302
Posted By evlfkr

RE: Redcat Racing Tornado Thread

If its the stock plug, there only good for a couple of runs. Use an A3 plug. Did you mess with any of the settings on the engine? Do not touch the low end needle (the one in the center of the...
Forum: Redcat Racing Support
02-28-2007, 05:53 PM
Replies: 3,672
Views: 318,302
Posted By evlfkr

RE: Redcat Racing Tornado Thread

Here's some pics of my xp. The body is final painting stage. "AS SMOOTH AS A BABY'S BUTT!!!"
This is with the mods listed on this forum on page 1. HPI clutch set up and rustler wheels with proline...
Forum: Redcat Racing Support
02-28-2007, 05:31 PM
Replies: 3,672
Views: 318,302
Posted By evlfkr

RE: Redcat Racing Tornado Thread

First turn the highend needle all the way in softly until it resists, back it out about 2 3/4 turns. Look at the low end make sure its flush, then check the batteries in your glow starter or power...
Forum: Redcat Racing Support
02-28-2007, 05:27 PM
Replies: 3,672
Views: 318,302
Posted By evlfkr

RE: Redcat Racing Tornado Thread

Always use after run oil in the vx 18. The main bearings rust very quick! Just turn the high end needle out about 2 3/4 and let it run 3 to 4 tanks good and rich for break in.
Forum: Redcat Racing Support
02-26-2007, 07:32 PM
Replies: 3,672
Views: 318,302
Posted By evlfkr

RE: Redcat Racing Tornado Thread

What shims does it need? I'm not a newbie by no means, but I just don't see how it can be shimed! It could just be a defect in the part, its only the right rear that does it. Do you have a washer...
Forum: Redcat Racing Support
02-26-2007, 05:29 PM
Replies: 3,672
Views: 318,302
Posted By evlfkr

RE: Redcat Racing Tornado Thread

Does anyone know where I can get front and rear aluminum carriers for the tornado xp? My rear carriers heat up and melt on the outside face. The bearings are fine, so thats not the problem.
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.