RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: 46u
Showing results 1 to 8 of 8
Search took 0.03 seconds.
Forum: RC Giant Scale Cars
12-01-2011, 11:22 AM
Replies: 11
Views: 1,508
Posted By 46u

RE: Putting Zenoah piston on CY crank

Just received my new Zen G270 top end and mic the C clips for the wrist pin and they are the same as CY.
Forum: RC Giant Scale Cars
11-27-2011, 03:26 PM
Replies: 11
Views: 1,508
Posted By 46u

RE: Putting Zenoah piston on CY crank

I have a Zen cylinder kit coming for one of the engines I am building. Will have to mic the thinness of the wire of both a CY and Zen wrist pin clip.
Forum: RC Giant Scale Cars
11-27-2011, 06:30 AM
Replies: 11
Views: 1,508
Posted By 46u

RE: Putting Zenoah piston on CY crank

I will be using a Zen top end so the wrist pin comes with it. But if you have the right length do not see way it maters about the wrist pin as both CY and Zen are 8mm OD.
Forum: RC Giant Scale Cars
11-25-2011, 05:40 PM
Replies: 11
Views: 1,508
Posted By 46u

RE: Putting Zenoah piston on CY crank

I checked a CY and Zen bearing and the Zen is about .040 shorter then the CY.
Forum: RC Giant Scale Cars
11-25-2011, 05:37 PM
Replies: 11
Views: 1,508
Posted By 46u

RE: Putting Zenoah piston on CY crank

The top end kit I will be getting does not come with the wrist pin bearing or washers.
Thanks
Forum: RC Giant Scale Cars
11-25-2011, 04:41 PM
Replies: 11
Views: 1,508
Posted By 46u

RE: Putting Zenoah piston on CY crank

I did some research and both Zen and CY pins are 8MM OD.
Forum: RC Giant Scale Cars
11-25-2011, 03:13 PM
Replies: 11
Views: 1,508
Posted By 46u

RE: Putting Zenoah piston on CY crank

I am guessing the Zen pin and bearing are bigger or smaller in diameter then the CY? When I get my Zen top end I will mic all this just out of curiosity.
Thanks
Forum: RC Giant Scale Cars
11-25-2011, 01:59 PM
Replies: 11
Views: 1,508
Posted By 46u

Putting Zenoah piston on CY crank

Since Zenoah does not make a stroker crank to build the motor I am building I will be running a CY crank. Now to put a Zenoah piston on a CY crank do you have to run both the Zenoah wrist pin bearing...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.