RCU Forums - Search Results

Search: Posts Made By: martno1fan

Showing results 1 to 8 of 8
Search took 0.04 seconds.

Forum: Speed - RC Gas Boats

07-06-2011, 11:05 PM

Replies: 57

72" mono build, twin weedies

Views: 11,133

Posted By martno1fan

RE: 72

Did you print off all the parts because i think theres one sheet thats just a parts list that prints on one sheet if i remember correctly ?.As Doug says though when printing set the printer to print...

Forum: Speed - RC Gas Boats

04-23-2011, 07:07 AM

Replies: 57

72" mono build, twin weedies

Views: 11,133

Posted By martno1fan

RE: 72

Its your choice,you can either leave it as is or paint it ;).
Mart

Forum: Speed - RC Gas Boats

04-22-2011, 11:56 PM

Replies: 57

72" mono build, twin weedies

Views: 11,133

Posted By martno1fan

RE: 72

Seal the hull with any good slow setting epoxy,i use west sytems,use an old credit card to spread it on thin and scrape off the exess,repeat this process a cpl more times lightly sanding between...

Forum: Speed - RC Gas Boats

04-16-2011, 05:09 PM

Replies: 57

72" mono build, twin weedies

Views: 11,133

Posted By martno1fan

RE: 72

Run both engines normal rotation you wont suffer severe prop walk torque in a large vee,plenty run 56 apaches with twin zenoahs in normal rotation without problems just be sure to use sharp balanced...

Forum: Speed - RC Gas Boats

01-01-2011, 03:40 PM

Replies: 57

72" mono build, twin weedies

Views: 11,133

Posted By martno1fan

RE: 72" mono build, twin weedies

Pocket bike motors such as the one Del mentioned can be used but some are expensive.

Forum: Speed - RC Gas Boats

01-01-2011, 03:38 PM

Replies: 57

72" mono build, twin weedies

Views: 11,133

Posted By martno1fan

RE: 72" mono build, twin weedies

You need slow set epoxy for the build then when built you coat the outside with it using a credit card or similar removing exess as you go so its a thin coat then once set repeat so you get 3 thin...

Forum: Speed - RC Gas Boats

01-01-2011, 04:01 AM

Replies: 57

72" mono build, twin weedies

Views: 11,133

Posted By martno1fan

RE: 72" mono build, twin weedies

Glue the bottom on first then glue the sides on leaving a slight overhang, this will form the chinerails,least this is how i did the smaller one you can fill the overhang with filler and smooth it...

Forum: Speed - RC Gas Boats

12-31-2010, 12:02 AM

Replies: 57

72" mono build, twin weedies

Views: 11,133

Posted By martno1fan

RE: 72" mono build, twin weedies

Hi boat looks good so far nice job.I would seriously doubt that a weedy will push this thing much over 15 mph if im honest unless you can fit two in there.Much better go with a zenoah or preferably...

Showing results 1 to 8 of 8