RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Tidnab
Showing results 1 to 7 of 7
Search took 0.02 seconds.
Forum: Speed - RC Gas Boats
06-14-2014, 05:00 PM
Replies: 23
Views: 4,691
Posted By Tidnab

I did a search on here and on the web and some...

I did a search on here and on the web and some have used the 49cc engines ,but in larger hulls, to give room for the engine,radio box, fuel tank, and to get the CG adjusted.The width of the hull I...
Forum: Speed - RC Gas Boats
06-14-2014, 03:27 PM
Replies: 23
Views: 4,691
Posted By Tidnab

Might need a little bigger hull for that...

Might need a little bigger hull for that beast.The usual spacing between engine rails is 5". You might need wider ones with this engine.I saw one in a bike and it isn't that small.Does the clutch end...
Forum: Speed - RC Gas Boats
06-12-2014, 03:49 PM
Replies: 23
Views: 4,691
Posted By Tidnab

Cyanoacrylate glue or CA as everyone calls it,is...

Cyanoacrylate glue or CA as everyone calls it,is useful in a build in some places ,but I wouldn't trust it to hold on the whole build. I use it in places where I can't get a good hold on with clamps...
Forum: Speed - RC Gas Boats
06-07-2014, 01:43 PM
Replies: 23
Views: 4,691
Posted By Tidnab

You should put your Enforcer in the classifieds...

You should put your Enforcer in the classifieds here.Seems like the list of boats for sale is really short.
Forum: Speed - RC Gas Boats
06-07-2014, 09:02 AM
Replies: 23
Views: 4,691
Posted By Tidnab

I wish I had the extra money right now to get a...

I wish I had the extra money right now to get a Rev-Unlimited stock engine.It looks like you don't get a carb with it and you would still need the collet end mount, rubber isolators and a collet,so...
Forum: Speed - RC Gas Boats
06-07-2014, 03:14 AM
Replies: 23
Views: 4,691
Posted By Tidnab

Even though the Prowler and Zippkits Easy Vee are...

Even though the Prowler and Zippkits Easy Vee are both nice boats,they have been built by everyone and his brother. If you like working with wood,cutting your own material and a lot of sanding,then...
Forum: Speed - RC Gas Boats
06-06-2014, 05:04 PM
Replies: 23
Views: 4,691
Posted By Tidnab

Not to buy different thicknesses of plywood,I'd...

Not to buy different thicknesses of plywood,I'd just use 1/8"(3mm) for the whole boat.The frames should be 1/8" and the transom 1/4",using two pieces of 1/8" laminated together.Aircraft grade Finnish...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.