RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Night Scream
Showing results 1 to 25 of 242
Search took 0.59 seconds.
Forum: Gas Engines
06-28-2018, 01:45 PM
Replies: 7
Views: 903
Posted By Night Scream

Gas engine oil question

Hi everyone:

I bought some bellray H1R 2 stroke engine oil and have been using it on my dle engines for quite sometime.

But on my new dle 30 which I just finished giving it break in and 6...
02-17-2016, 03:46 AM
Replies: 18
Views: 1,750
Posted By Night Scream

This will be my 1st year going, Hoping to come...

This will be my 1st year going, Hoping to come back with some Glow engines specially looking to find at least a saito 150 don't care if it doesn't run just need one for parts and a lot of goodies,...
11-01-2015, 08:48 AM
Replies: 9
Views: 608
Posted By Night Scream

Exclamation Multi Charger Question

Hi Everyone:

I'm looking for a good AC multi charger where i can charge all my planes.

I fly RC and 99% of my planes have NIMH and i only have 2 lipos i use for a starter and my field box...
Forum: ARF or RTF
07-02-2014, 03:34 AM
Replies: 8
Views: 3,211
Posted By Night Scream

Hi everyone thank you for your reply yes, sorry...

Hi everyone thank you for your reply yes, sorry to say it did confuse those two...
right now I'm balancing out using the carl Goldberg as I seem to have been confused on the other cg.
the plane is...
Forum: ARF or RTF
07-02-2014, 03:29 AM
Replies: 8
Views: 3,211
Posted By Night Scream

Hi everyone thank you for your reply yes, sorry...

Hi everyone thank you for your reply yes, sorry to say it did confuse those two...
right now I'm balancing out you send a card Goldberg to see Jesus I seem to have been confused on the other cg....
Forum: ARF or RTF
06-21-2014, 09:13 AM
Replies: 8
Views: 3,211
Posted By Night Scream

thank you for that information I'm going to...

thank you for that information I'm going to consider I am in the process of measuring the wing comparing to the Goldberg CG to see how the handles.

already in my measurements I already determined...
Forum: ARF or RTF
06-20-2014, 12:33 PM
Replies: 8
Views: 3,211
Posted By Night Scream

Exclamation Seagull Ultimate 90 problem

Hi Everyone:

I recently purchased and build this plane from horizon hobby.

I have re-enforced the front of the plane with 30 min epoxy and fiberglass since I have a Saito 1.50 4stroke engine in...
Forum: ARF or RTF
06-09-2014, 07:57 AM
Replies: 265
Views: 53,785
Posted By Night Scream

Hi everyone: I just got this plane and got...

Hi everyone:

I just got this plane and got it around 60% build.

I'll be running it with a Saito 150 in the nose..

Question I got though.. If anyone is using this same engine where are you...
Forum: Gas Engines
12-05-2013, 05:15 AM
Replies: 5,283
Views: 754,529
Posted By Night Scream

Well i fly this plane cowl off, cause i'm still...

Well i fly this plane cowl off, cause i'm still fixing the cowling cause of the last crash when i had a dead stick.. and i still encounter this probkem when i'm doing slow inverted flight as...
Forum: Gas Engines
12-03-2013, 07:02 AM
Replies: 5,283
Views: 754,529
Posted By Night Scream

Well i tried the diaphragm from another gas...

Well i tried the diaphragm from another gas engine i got and i got the same responce as soon as i went inverted.. could it also be that one has also a bad diaphragm?

I have a new in the box DLE...
Forum: Gas Engines
12-02-2013, 05:30 AM
Replies: 5,283
Views: 754,529
Posted By Night Scream

I will need to check that diaphragm then.. will...

I will need to check that diaphragm then.. will any walbro carb rebuild kit bring the correct one?

Will also otry that switch problem fix.. right now i'll try anything..
Cause i do a lot of...
Forum: Gas Engines
12-01-2013, 04:47 PM
Replies: 5,283
Views: 754,529
Posted By Night Scream

I have checked and even changed the lines in the...

I have checked and even changed the lines in the tank for new one's to make sure nothing like that is happening even check to make sure the tank is in the right position of neither being up or down...
Forum: Gas Engines
12-01-2013, 04:02 PM
Replies: 5,283
Views: 754,529
Posted By Night Scream

Hi guys. Got a nifty problem for you guys...

Hi guys.

Got a nifty problem for you guys cause I'm stumped right now.. Been wracking my brain for days..

The engine works flawlessly good low through high response in normal attitude.. But as...
Forum: Gas Engines
06-22-2013, 05:27 PM
Replies: 47
Views: 3,600
Posted By Night Scream

RE: CM-6 Gas Engine problem

After thinking about it.. it makes no sense to use the voltage regulator so I won't use it for the ignition.
Forum: Gas Engines
06-22-2013, 06:34 AM
Replies: 47
Views: 3,600
Posted By Night Scream

RE: CM-6 Gas Engine problem

That's it guys [X(]!!!

After reading the latest posts and then going to check all my dle-30's and the instructions and notes I got ..

I had all my plugs always set at .25 as that was the...
Forum: Gas Engines
06-21-2013, 04:09 AM
Replies: 47
Views: 3,600
Posted By Night Scream

RE: CM-6 Gas Engine problem

Well here are the picstures..

I know i'm not the best photographer and i took them using my phone's camera.

Ignition Sequence
...
Forum: Gas Engines
06-20-2013, 02:23 PM
Replies: 47
Views: 3,600
Posted By Night Scream

RE: CM-6 Gas Engine problem

I just checked the brand new plug I bought last time from bob's hobby shop in Florida is a Honda NGK japan Cm-6 plug..

I'll be using this one after I change to another ignition on my mx2 as the...
Forum: Gas Engines
06-20-2013, 02:13 PM
Replies: 47
Views: 3,600
Posted By Night Scream

RE: CM-6 Gas Engine problem

Where can you get those iridium plugs from? First time I've heard of them
Forum: Gas Engines
06-20-2013, 08:38 AM
Replies: 47
Views: 3,600
Posted By Night Scream

RE: CM-6 Gas Engine problem

The plugs i'm using i've purchased from tower hobbies or my local hobby shop..

The last plugs i got where 1 original DLE spark plug and another honda cm-6 plug [haven't tried this one yet]
Forum: Gas Engines
06-20-2013, 07:22 AM
Replies: 47
Views: 3,600
Posted By Night Scream

RE: CM-6 Gas Engine problem

I'll try getting a pic tonight when i get home and post it later..

Would a voltage regulator on a regular 4.8volt battery reduce the chances of it getting a high voltage?

Or would these new...
Forum: Gas Engines
06-20-2013, 04:31 AM
Replies: 47
Views: 3,600
Posted By Night Scream

RE: CM-6 Gas Engine problem

Well the last iginitions i bougth from bob's hobby shop are just rcexl says 4.8 to 6volt.. bought them about um.. 1 yr ago i bought 3 of them.

I use a regular 4.8v battery back raging from 1000...
Forum: Gas Engines
06-20-2013, 04:08 AM
Replies: 47
Views: 3,600
Posted By Night Scream

RE: CM-6 Gas Engine problem

I'll try to get a pic from one of my planes showing how i have the ignition.

I'm using DLE 30 both brand new rear carb versions and 1 side carb. which has over 250 flights in it And i got them...
Forum: Gas Engines
06-19-2013, 04:17 PM
Replies: 47
Views: 3,600
Posted By Night Scream

RE: CM-6 Gas Engine problem

I also though so years ago and then just placed a small square just the size of the ignition on the bottom of it using foam to prevent the vibrations.

And still the same problem persists.. after...
Forum: Gas Engines
06-19-2013, 03:00 PM
Replies: 47
Views: 3,600
Posted By Night Scream

CM-6 Gas Engine problem

Hi everyone:

I've been encoutering this problem in the past and though it was just me.. but recently this is getting out of hand..

I'm in mid flight doing aerobatics or just flying around...
Forum: Gas Engines
06-19-2013, 02:58 PM
Replies: 5,283
Views: 754,529
Posted By Night Scream

RE: NEW DLE30!

Hi everyone:

I've been encoutering this problem in the past and though it was just me.. but recently this is getting out of hand..

I'm in mid flight doing aerobatics or just flying around...
Showing results 1 to 25 of 242
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.