RCU Forums - Search Results

Search: Posts Made By: kggivens

Showing results 1 to 5 of 5
Search took 0.53 seconds.

Forum: Twin & Multi Engine RC Aircraft

06-09-2006, 07:26 AM

Replies: 195

Nitro Models Cessna 337 - Build Thread

Views: 50,238

Posted By kggivens

RE: Nitro Models Cessna 337 - Build Thread

Hello All:
I have been looking at my wing, and I am unable to locate the screw holes to attach the wing, any chance you could measure the distance from the leading edge and the end of the wing?...

Forum: Twin & Multi Engine RC Aircraft

06-09-2006, 05:17 AM

Replies: 195

Nitro Models Cessna 337 - Build Thread

Views: 50,238

Posted By kggivens

RE: Nitro Models Cessna 337 - Build Thread

Hey Guys, Thanks so much for all the tips, I have just started my 337 and I was wondering what to do with the wing attachment issue. All you advice really helps. Just wondered some club members...

Forum: Glow Engines

08-21-2005, 06:33 AM

Replies: 7

Removing connecting rod from Super Tigre 45

Views: 2,326

Posted By kggivens

RE: Removing connecting rod from Super Tigre 45

Thanks Guys, I heated it up a little and it slid off. The new crank is installed and hopefully will run today.
See Ya
kggivens

Forum: Glow Engines

08-20-2005, 01:49 PM

Replies: 7

Removing connecting rod from Super Tigre 45

Views: 2,326

Posted By kggivens

RE: Removing connecting rod from Super Tigre 45

Hi Bill:
Thanks for your response. I have removed the cylinder liner, but there isn't quite enough room to slide the rod off, I do not want to force it. Maybe the crank was pushed back from the...

Forum: Glow Engines

08-20-2005, 01:07 PM

Replies: 7

Removing connecting rod from Super Tigre 45

Views: 2,326

Posted By kggivens

Removing connecting rod from Super Tigre 45

Hello All:
I am trying to replace a bent crankshaft on a super tigre 45, And I can not figure out how to remove the connecting rod from the crank, as there is not enough room to slide it off. Can...

Showing results 1 to 5 of 5