RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: nitrometan
Showing results 1 to 25 of 31
Search took 0.54 seconds.
03-12-2015, 03:23 AM
Replies: 8
Views: 4,852
Posted By nitrometan

I think you do not read carefully my previous...

I think you do not read carefully my previous posts.You keep telling me about pump/pumped carburettors.I say again and hopefully for last time:I want to keep it running as simple and cheap it can...
03-11-2015, 04:40 AM
Replies: 8
Views: 4,852
Posted By nitrometan

Actually the engine runs almost with the same...

Actually the engine runs almost with the same temperature because it has really nice cooling fins,much more effective as lets say Evolution 20cc.About the compresion ratio,it can be raised but...
03-10-2015, 03:18 PM
Replies: 8
Views: 4,852
Posted By nitrometan

Well,I know the site very well from a long time...

Well,I know the site very well from a long time and I followed what the gentleman there did ,but by me it works just with muffler pressure and no walbro,only with the original carburettor.Also I...
03-09-2015, 11:57 AM
Replies: 8
Views: 4,852
Posted By nitrometan

Well as I said,wanted to keep it simple and...

Well as I said,wanted to keep it simple and cheap.I can easily put a 9mm walbro carb at the backplate using original DLE setup(Flatters and filling the crank with a enligted teflon rod) but I just...
03-09-2015, 11:04 AM
Replies: 8
Views: 4,852
Posted By nitrometan

Thunder Tiger 120 Pro Amazing forgotten motor

Hi everybody!Someone just said is totally dead here and nobody says nothing.Well I thought it may be the right time to share you my experience .I wanted to buy a DLE 20 because 3 club members here do...
Forum: Gas Engines
03-10-2014, 09:21 AM
Replies: 375
Views: 82,391
Posted By nitrometan

After 2,5 L 25:1 mixture with Castrol 2stroke...

After 2,5 L 25:1 mixture with Castrol 2stroke mineral oil I switched to 33:1 mixture with Motul 800 Double ester Road Racing 2 stroke oil and 95 okt gasoline.No big improvement,after 1,5 liter...
Forum: Gas Engines
03-06-2014, 01:20 PM
Replies: 375
Views: 82,391
Posted By nitrometan

Ich Stimme Zu!:p

Ich Stimme Zu!:p
Forum: Gas Engines
03-06-2014, 11:15 AM
Replies: 375
Views: 82,391
Posted By nitrometan

Well, today I went on the field and try to start...

Well, today I went on the field and try to start the engine.Two propellers,18X8 and 18X10 Mezjlick wide blades.Carb primed,fuel line full,choke,3 flips with choke,ignition on,first flip pop,choke...
Forum: Gas Engines
03-05-2014, 09:46 AM
Replies: 375
Views: 82,391
Posted By nitrometan

Yesterday I got my AGM 30 cc from ebay Germany...

Yesterday I got my AGM 30 cc from ebay Germany for just 108 euros postage included.As usual by Chinese engines I carefully inspected what I got and I can tell you that for the first time I have...
Forum: Glow Engines
07-26-2011, 09:34 AM
Replies: 22
Views: 4,492
Posted By nitrometan

RE: OS 120 AX ON PIPE

It runs anyway hot at WOT if more than 1 minute.Piped it runs hotter because it burns extra mixture otherweise should be lost(that is why we use pipe :) ).I think a speed maschine can be an option...
Forum: Glow Engines
07-17-2011, 11:38 PM
Replies: 22
Views: 4,492
Posted By nitrometan

RE: OS 120 AX ON PIPE

Although OS 120 AX has amazing power for its size,it can be used only for light frames for 3D.the total weight must not exceed 10 LBS wet.My AX on pipe pulled vertically an EXTRA 330 from CMP 12LBS...
Forum: Gas Engines
09-01-2010, 03:57 PM
Replies: 27
Views: 4,056
Posted By nitrometan

RE: CRRC GF 40i broken crank

Dear Tina,
We are using here in Romania also a CRRC GF 40 kit.Despite using a light propeller for break-in (Xoar 18X8) and a oil mix of 25:1 Motul 800 double esther(one of the best synthetic oil...
Forum: Gas Engines
09-01-2010, 03:59 AM
Replies: 6,892
Views: 1,133,130
Posted By nitrometan

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

Hey!!
We are talking about 2 stroke gas engines,not about any turbo or compressor charged type of engine.[sm=49_49.gif].There are of course hundreds of methods of power increase but not suitable in...
Forum: Gas Engines
09-01-2010, 02:12 AM
Replies: 6,892
Views: 1,133,130
Posted By nitrometan

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

Well,my knowdleges tell me that the power of an engine,no matter which one, is directly related to compression ratio.Bigger means powerful but also vibration.That is why many producers prefer to keep...
Forum: Gas Engines
08-31-2010, 01:56 PM
Replies: 6,892
Views: 1,133,130
Posted By nitrometan

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

Please explain us why??
3W28i has 11:1 and it uses reed valves.
Forum: Glow Engines
06-02-2010, 01:11 PM
Replies: 22
Views: 4,492
Posted By nitrometan

RE: OS 120 AX ON PIPE

Hi everybody!

Today I made another test with another propeller,Graupner G-Sonic 18X8.Pipe length 540mm same fuel.8500 rpm steady 8,1-8,2kg pull.20 ounces of fuel in 7 minutes.Engine about...
Forum: Glow Engines
05-30-2010, 05:49 AM
Replies: 22
Views: 4,492
Posted By nitrometan

RE: OS 120 AX ON PIPE

I tried to make a rich mixture as much as possible,because if i tune everything on top performance i can obtain a little over 10000 rpm,so i rotate the HS needle 45 degrees counter-clockweise to keep...
Forum: Glow Engines
05-29-2010, 09:08 AM
Replies: 22
Views: 4,492
Posted By nitrometan

RE: OS 120 AX ON PIPE

OS 108 is a legendary engine and a very solid one with more than enough cooling fins.The problem is not the rpm,the problem is the heat generated,because the power is almost 4hp.Even without pipe,the...
Forum: Glow Engines
05-28-2010, 11:02 AM
Replies: 22
Views: 4,492
Posted By nitrometan

RE: OS 120 AX ON PIPE

I know,I was surprised myself,and I wish I had the next big pipe from Krumscheid,which is for 25-35cc.It has more volume(50mm diameter) and bigger exhaust diameter(14mm instead of 12),but I am sure...
05-28-2010, 08:45 AM
Replies: 92
Views: 24,652
Posted By nitrometan

RE: O.S 1.20AX Owners. Post your tach readings

OS 120 AX,Graupner G-Sonic 18x6 propeller,tuned pipe Krumscheid 1010-5,10% nitro 15% oil 9500 rpm steady,peak 9800,pull 7,5 kg.Tuned very carefully the pipe,45 degrees counter-clockwise rich from...
Forum: Glow Engines
05-28-2010, 06:36 AM
Replies: 22
Views: 4,492
Posted By nitrometan

OS 120 AX ON PIPE

Dear gentlemen,I want to share you my results in trying to get the most useful thrust from OS 120 AX.
After many many many experiments and lost money for recomanded propellers and exhaust systems...
Forum: Gas Engines
04-11-2010, 09:33 AM
Replies: 1
Views: 1,782
Posted By nitrometan

RE: New: Magnum .52 ci gas engine!

I wish that we have the posibility to see the engine running.If it is so dependable like his alcoholic brother,a new era comes soon!
03-25-2010, 04:17 PM
Replies: 30
Views: 6,871
Posted By nitrometan

RE: OS 46AX On A Header & Pipe

Well sir,we use a lot the G-Sonic around here and the figures you mentioned are more than every optimistic thinkings,especially thrust.7,15kg thrust are possible with maybe a good 3W28I CS with the...
03-25-2010, 09:43 AM
Replies: 3
Views: 1,175
Posted By nitrometan

RE: Tomy Model MT35 gasser

After 1 hour running time,try Motul 800 35:1 mix and keep this ratio.You will have a very long-lasting engine doing so.
What about Temperature?(Celsius...)
My converted stays around 125 celsius...
03-25-2010, 06:43 AM
Replies: 3
Views: 1,175
Posted By nitrometan

RE: Tomy Model MT35 gasser

Good values.I thought that MT 35 turns a little faster.Actually I am surprised that my Super Tigre ST 3250 converted to gas performs better with Menz S 18x10 at 8200,Menz S 19x8 at 7800 rpm,Menz S...
Showing results 1 to 25 of 31
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.