RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: MGREENBERG
Showing results 1 to 25 of 71
Search took 0.52 seconds.
Forum: WildHare R/C Support
05-17-2009, 03:31 PM
Replies: 2
Views: 726
Posted By MGREENBERG

Baby Edge 540

Need the fuse and the rudder..do you have them in stock.?
How much?
Does the fuse come with the metal plates for the gear?
Thanks
Forum: Crash & Rebuild
05-17-2009, 03:29 PM
Replies: 3
Views: 1,050
Posted By MGREENBERG

Wild Hare Baby Edge 540

Crashed a nice airplane on its' maiden flight.
Might have had the CG too far forward. I had a YS 140 , 2 lipos and an 18 oz tank in front of the wing tube, maybe the Cg was an 1 1/2" in front of the...
Forum: YS Engines Support
03-29-2009, 04:59 PM
Replies: 2
Views: 928
Posted By MGREENBERG

YS 140 sport

I need a 3" metal spinner for this engine.
Does anyone know makes the proper spinners for this engine and the prop shaft size for the screw..... it seems YS doesn't publish this info.
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
03-23-2009, 07:30 PM
Replies: 4
Views: 844
Posted By MGREENBERG

RE: Hs 5645 MG

I am not having this problem,I purchased the servos and was told they might have this issue.
I reprogrammed the deadband to a 1 value. Is there anything else I can do with the sevos to eliminate...
Forum: WildHare R/C Support
03-22-2009, 03:34 PM
Replies: 1
Views: 630
Posted By MGREENBERG

Baby Edge/ ys 140 fz combo

Get the deal of the century on the above combo.... brand new ...never flown.
Before I finish the plane, will this combo be too much for the airframe or Cg?
Yes, I realise full throttle passes or...
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
03-22-2009, 03:30 PM
Replies: 4
Views: 844
Posted By MGREENBERG

Hs 5645 MG

Understand there might be an issue with flutter when using these servos under extreme loads.
If so I was told reprograming the deadband may solve this issue.
Is this info correct?
Thanks
Forum: ZDZ & RCS Support
03-14-2009, 02:12 PM
Replies: 1
Views: 1,074
Posted By MGREENBERG

Forum?

Is this forum discontinued?
Will troy built pick itup ?
Forum: WildHare R/C Support
03-03-2009, 09:10 PM
Replies: 3
Views: 710
Posted By MGREENBERG

Baby edge 540 / OS ax 75 (new version)

Will the baby edge 540 fly with the new OS 75 AX 2 stroke? I'm not going for 3 d just basic aerobatics.
My finds are limited(wife and new baby).
Thanks
Mike
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
05-15-2008, 07:43 PM
Replies: 2
Views: 311
Posted By MGREENBERG

RE: Spread spectrum radios

Well that sounds like a definite maybe to me.
I'm actually going out to buy a brand new DX7 for $150.00. Most guys are onto the 2 nd generation of Tx's already.
Looks like Hi Tec missed the...
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
05-15-2008, 03:35 PM
Replies: 2
Views: 311
Posted By MGREENBERG

Spread spectrum radios

Why has Hi tec been completely silent on spread sprectrum?
I cannot understand how you can allo your competition to gain market share at your expense.
Any thoughts?
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
05-12-2008, 07:41 PM
Replies: 0
Views: 194
Posted By MGREENBERG

Eclipse spectra 7

Has anyone had "fading" with this trans?
I've had it for 4 years and have no problems,but I've lost 2 aircraft in the last month due to loss of control at about 1000 to 1100 feet from the control...
Forum: O.S. Engines Support
02-06-2008, 10:17 AM
Replies: 0
Views: 346
Posted By MGREENBERG

MOVED: Just ordered the os 75 ax

Glow Engines: http://www.rcuniverse.com/forum/fb.asp?m=7030663
Forum: Glow Engines
02-05-2008, 09:17 PM
Replies: 3
Views: 675
Posted By MGREENBERG

Just ordered the os 75 ax

Does anyone have experiance with the new 75 ax?
Thanks
Mike
Forum: YS Engines Support
12-03-2007, 10:50 AM
Replies: 1
Views: 793
Posted By MGREENBERG

Fuel and Pressure line length

Can long pressure and fuel lines affect the engine when the tank gets low?
I have experianced leaning and engine stall before the tank runs dry. Maybe an once or 2 left in the Hayes tank.I have a...
Forum: YS Engines Support
10-04-2007, 09:23 AM
Replies: 6
Views: 1,020
Posted By MGREENBERG

RE: Ys 110 throttle barrel tight/binds

Troy,
Update on throttle problem.
I pulled the carb out and found nothing,except that the interior of the barrel had some small "rub ' marks on it and the carb barrel had very sharp edges.
I...
Forum: YS Engines Support
10-02-2007, 02:14 PM
Replies: 6
Views: 1,020
Posted By MGREENBERG

RE: Ys 110 throttle barrel tight/binds

Troy,
No I purchased the special oil from PSP.never used regular after run oil in it.
All I did before I stored the engine was disassemble the airboxand regulator and clean inside . Then I found...
Forum: YS Engines Support
10-02-2007, 07:52 AM
Replies: 6
Views: 1,020
Posted By MGREENBERG

RE: Ys 110 throttle barrel tight/binds

Troy,
Thanks for the reply.
Is it possible that since I haven't run the engine in 6 months that there is gummed up fuel residue in the throttle body?
I cleaned and properly oiled the engine...
Forum: YS Engines Support
10-01-2007, 08:50 PM
Replies: 6
Views: 1,020
Posted By MGREENBERG

Ys 110 throttle barrel tight/binds

Ys110..throttle barrel rotation is tight,but not very tight. Barrel is smooth but I've tried two servos and the first 15 to 25 % the throttle opens is not " linear" . It opens slowly at first if I...
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
09-12-2007, 07:45 PM
Replies: 9
Views: 1,748
Posted By MGREENBERG

RE: New Radio System??

It would be nice to have additional info to make that decesion. Like if and when.
Since hi tec has a large and LOYAL following they should respect their customers and give us some info on their...
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
09-08-2007, 05:30 PM
Replies: 9
Views: 1,748
Posted By MGREENBERG

RE: New Radio System??

When will you be out with a 2.4 radio?
The competition has it,should we wait or buy their's?
Mike
Forum: YS Engines Support
06-13-2007, 04:16 PM
Replies: 1
Views: 484
Posted By MGREENBERG

Ys 110

Troy,
Just read your post regarding airleaks from the airbox and carb.
I had to store my 110 for a few months and I disassembled the airbox but not the carb or throttle.
I notice now that the...
Forum: YS Engines Support
05-01-2007, 12:58 PM
Replies: 3
Views: 639
Posted By MGREENBERG

RE: ys 110

Thanks for the reply,i will contact Central hobbies..not ys parts,eh?
The square bump faces the propeller side,thanks
mike
Forum: YS Engines Support
04-30-2007, 03:23 PM
Replies: 3
Views: 639
Posted By MGREENBERG

ys 110

Good afternoon,
I have a ys 100 I am putting into storage for a while.It is faily new with maybean hour on it.
I previously asked you if there was anything special I had to do to store it...
Forum: ARF or RTF
04-04-2007, 11:19 AM
Replies: 25
Views: 3,563
Posted By MGREENBERG

RE: Ultra-RC Support Forum

THANKS FOR THE INFO.
8 1/4 to 8 1/2 s/b less than 21 ozs.maybe 16. Still seems far back but as long a sit cures the bolloonng problem,the plane does fly well.

Suggest you walk in another man's...
Forum: ARF or RTF
04-04-2007, 10:22 AM
Replies: 25
Views: 3,563
Posted By MGREENBERG

RE: Ultra-RC Support Forum

Thanks for the reply.
I notice no one from the "factory support" replyed,or replyes very much to questions.
Check out YS or AEROWORKS.Send them a question and see how fast you get a response.
I...
Showing results 1 to 25 of 71
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.