RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
 
Page 1 of 13
1
2
3
11
Last »
Search: Posts Made By: G.P.
Showing results 1 to 25 of 315
Search took 0.61 seconds.
Forum: ARF or RTF
11-12-2019, 05:43 PM
Replies: 2,036
Views: 441,289
Posted By G.P.

Those are for the smaller cub. You want the...

Those are for the smaller cub.

You want the discontinued 1/4-Scale Cub Floats (HAN4580) if you can find some.
Forum: ARF or RTF
03-06-2019, 04:55 PM
Replies: 1,332
Views: 218,499
Posted By G.P.

eBay has carbon tubes that look like they would...

eBay has carbon tubes that look like they would work for a wing tube. From the specs posted above it looks like 19mm x 1000mm would be able to be cut down to length.
Forum: ARF or RTF
03-05-2019, 09:50 AM
Replies: 1,332
Views: 218,499
Posted By G.P.

Same here. I tried forever but never found one. ...

Same here. I tried forever but never found one.

Sounds like you got a great deal VZ65. I think I remember reading that the H9 cub was basically the same as the DP cub, and that the parts may even...
Forum: ARF or RTF
05-16-2014, 07:35 AM
Replies: 2,036
Views: 441,289
Posted By G.P.

Is it ok if you tell us why? I was lucky enough...

Is it ok if you tell us why? I was lucky enough to get a set for my 3DHS Bigfoot, but haven't used them yet. Is there something I should look out for? I can imagine having problems putting them on...
Forum: ARF or RTF
05-23-2013, 03:18 PM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

Just found this. Guy throws it around a little. Too bad it sounds like a weed whacker!

http://www.youtube.com/watch?v=nTkFSlnKNHg
Forum: ARF or RTF
05-04-2013, 05:02 PM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

None of these are mine, but I don't think I've seen any of these in this thread yet.

Enjoy.

http://www.youtube.com/watch?v=8UvAN5r3w3k

http://www.youtube.com/watch?v=L2vKja1B8RE

...
Forum: ARF or RTF
04-17-2013, 04:50 PM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

:D Got her in the air today!!! :D

Wind was about 5 km/h all day, of course after I got the Cub put together it was gusting 28 km/h and switching directions all over the place. The only place...
Forum: ARF or RTF
04-17-2013, 07:53 AM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

I haven't done anything to my gear, it came with the camber on one wheel. It's not that bad, and I can probably just bend the axle to compensate if it's a problem. It would be more of a hassle to...
Forum: ARF or RTF
04-16-2013, 01:00 PM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

Anybody tried the big bush wheels on pavement? The only place that is mud and snow free at the moment is pavement. I would like to get the maiden done though. I'm a little worried that it won't...
Forum: ARF or RTF
04-16-2013, 09:58 AM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

Sorry about the trolling comment, but any post that does not contribute to the conversation and is worded in such a way to provoke an emotional response is trolling IMO. You may not have intended it...
Forum: ARF or RTF
04-15-2013, 12:30 PM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

+1 Would love to see it instead of trolling comments like that.

Obviously not much flying weather out there yet...or those that can are having too much fun flying their Cubs to post about it on...
Forum: ARF or RTF
04-14-2013, 08:51 AM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

I have a couple of sizes of cloth from years gone by. I have no idea what the weights are anymore, but i do have some ultra thin stuff. I just use whatever epoxy I can get in town. I'll check out...
Forum: ARF or RTF
04-13-2013, 09:47 AM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

I see. No I didn't weigh them before. The stuff foams a lot when water is added to it, and I can't see it adding more than an ounce per float.
Forum: ARF or RTF
04-13-2013, 06:46 AM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

Do you mean the CG with the floats and without, or the final weight of the floats if I glass them? I don't have much experience glassing, so they will probably change a lot!

My CG with floats...
Forum: ARF or RTF
04-12-2013, 07:14 AM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

I tested a can of the supposedly high expansion stuff. The end result about the same size block of foam, but it weighed 1/2 an ounce less than the standard stuff. I think I'm just going o go with a...
Forum: ARF or RTF
04-06-2013, 07:16 PM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

Here's an example of Gorilla Glue & water on a gear plate. I did a low snap-to-pancake with my 70" 3DHS Slick a few years ago and this was the result. You can see the gear plate in the lower RH...
Forum: ARF or RTF
04-06-2013, 06:54 PM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

Thanks for the offer, but you don't have to go through the hassle of doing that for me.

The Gorrila Glue was done inside the float. If you squirt a little water on it and mix it up it expands...
Forum: ARF or RTF
04-06-2013, 01:01 PM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

Well I sprayed out a small can of the expanding foam. It looks like the correct amount to do the forward half of one float. It felt pretty light for it's size, but I weighed it and it came to 10...
Forum: ARF or RTF
03-27-2013, 10:22 AM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

I see! Your help and information is greatly appreciated, and I don't want to anyone to feel upset.

;)
Forum: ARF or RTF
03-27-2013, 07:19 AM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

Love the wig wag wing lights! Is the bottom landing light a scale location, or just to help you see the ground coming up on approach?

Looks great!


edit: Just saw the center landing...
Forum: ARF or RTF
03-27-2013, 07:14 AM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

I don't recall anyone disputing, arguing with, or questioning anything that you have said.

[:o]
Forum: ARF or RTF
03-26-2013, 06:52 PM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

Sweet, I didn't know that the home stuff was two part as well. I would actually prefer the nozzle to get the stuff in the floats without having to cut any extra access holes. I've got a few places...
Forum: ARF or RTF
03-26-2013, 02:44 PM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

Thanks for the link Brian!

What is the advantage of the 2 part stuff, is it worth the added time and cost to get it?
Forum: ARF or RTF
03-26-2013, 12:53 PM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

Family has had to take the front seat lately, so I haven't done much. I haven't been able to find any of the professional 2 part sfoam, so I'm just going to go with the home grade foam. My next...
Forum: ARF or RTF
03-24-2013, 10:02 AM
Replies: 2,036
Views: 441,289
Posted By G.P.

RE: New Hangar 9 1/4 Scale P 18 Super Cub

That sounds better! :D
Showing results 1 to 25 of 315
 
Page 1 of 13
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.