RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: JuanPu
Showing results 1 to 25 of 27
Search took 0.11 seconds.
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

I ordered (and payed) some Spektrum receivers at MyRcSupply on 02/05/2007 after reading good opinions about this seller in RCU.

After more than one month the receivers (AR7000, AR6000 and...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

That's correct. However, the positions of ALL the servos should be set prior to binding since their positions will be the ones used at power on until a binded emitter signal is caught, as...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

Well, I took for granted that the only sensible way is to free a servo slot -if there is no one already free- at the very last moment, after having checked that all the positions we have are the...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

AeroBob, I would add this alternative to Capt Jim explanation: just temporarily plug the two wire harness in a free (or temporarily freed) servo slot and directly install the bind plug in the...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

From what I've read, air range is much higher (2 miles+). Additional receivers don't improve range but reliability.

I have a 6100 besides 6000 and 7000 already paid at MyRcSupply since two...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

Yesyerday I did a range test on the ground.

With a GPS in hand I went 850 meters (2789 foot) away with control. There was a small hillock intercepting the line of sight by, let's say, a height...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

The final part of the graph is quite useless.

Playing with ATV settings, differentiating the arm lengths and changing the relative positions of the arms allow you to select a section of the...
Replies: 3,148
Views: 374,691
Posted By JuanPu

Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

Assuming geometry goes strictly from parallel/vertical to vertical/parallel with arms of equal length, the equation is B = ArcSin (1-Cos(A)), being A the servo angle from parallel and B the barrel...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

Nice to see they have solved the antennas issue:

Secondary receiver
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

It reminds me certain punishment that the ancient Roman Empire applied to their enemies.

Seriously speaking, this solution does its job very neatly, but it precludes installing the receiver in...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

I understand that with electrics it is advisable to do the range check with the motor running just to reproduce the worst electrical noise scenario.

With glow, it also is advisable the same...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

Look at this link
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

Here you have.

I suppose silicon sealer may be enough.

An alternative would be using epoxi, but I wouldn't like doing any change I cannot reverse.

Since hot glue is quite rigid, the...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

However, we should be aware that electrical noise may as well affect digital areas of the receiver, that work at much low frequencies and quite low voltages.

Years ago I designed microcontroller...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

In my case the insulation also stopped just short of the case in two of the antennas, so firstly I shifted them inside.

Then I added to each antenna about 5 mm of thermo-shrunken isolation close...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

Have a look at:

MyRcSupply
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

Let us breathe... (sorry, couldn't resist).
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

So please be merciful and lie, lie... :(
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

BTW, I saw him extracting the Spektrum box from a huge cardboard box plenty of them. I believe it had a post signing indicating it came from Singapore. It seems mine is one of the first ones...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

I have bought my DX7 today.

Don't know if this is the real reason or not but the seller told me that the wall charger was not included since it is 110 V and is useless in Europe, and that the...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

Inhibited

Regards.
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

Choosing channels randomly may be done with a standard algorithm as worthy as an algorithm for doing it sequencially...

Just kidding.

Congratulations for your DX7.

Juan.
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

It seems lAR6000 could take advantage from DSM2. From the Spektrum site:

AR6000-Compatible:
DX6 owners and anyone else who flies small electric models will be pleased to know that the AR6000...
Replies: 3,148
Views: 374,691
Posted By JuanPu

RE: Spektrum DX-7

So, back to my original question: regarding range and reliability, does an AR6000 outperform an AR6100 when used with a DX7?
Showing results 1 to 25 of 27
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.