RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: Xeller8
Showing results 1 to 8 of 8
Search took 0.10 seconds.
03-15-2006, 11:10 AM
Replies: 17
Views: 1,674
Posted By Xeller8

RE: tuning help

Bumping this to the top for the newbies coming in.[8D]
03-06-2006, 05:16 PM
Replies: 17
Views: 1,674
Posted By Xeller8

RE: tuning help

Couterclockwise to slow it down...and it doesn't take much of a turn to affect it....try about an 1/8th of a turn...blip the throttle a couple of times and give it chance to get use to the change.
03-05-2006, 10:50 PM
Replies: 17
Views: 1,674
Posted By Xeller8

RE: tuning help

Yes sir I believe you are...is the gap staying where it should when you hit the brake and the car is idling?....is so then richen your LSN about a 1/16th to an 1/8 of a turn...blip the throttle a bit...
03-05-2006, 10:29 PM
Replies: 17
Views: 1,674
Posted By Xeller8

RE: tuning help

If it dies when you brake the idle speed screw could be set too low and you have the trim on your controller to set the idle higher...DO NOT rely on the trim setting to set the idle....make sure you...
02-28-2006, 06:12 PM
Replies: 17
Views: 1,674
Posted By Xeller8

RE: tuning help

Good...I'm glad you are getting there!

Start leaning it out a bit if you are dumping a lot of fuel out the exhaust...lean out your low speed needle a little bit first and see what...
02-28-2006, 12:29 AM
Replies: 17
Views: 1,674
Posted By Xeller8

RE: tuning help

Well DUUUUUUH!....LMAO!!!!

You should have stopped right there the first time it happened and got some help...not run 4 tanks like that...

To be honest...I'm worried you may have ruined the...
02-28-2006, 12:13 AM
Replies: 17
Views: 1,674
Posted By Xeller8

RE: tuning help

1/4 of an inch??......WHOA!!!..NO WAY!...LOL!!....that thing should be zinging off the charts if it is set at that...yes...that is WAY too much!

Look at a tape measure and set the idle speed...
02-27-2006, 11:36 AM
Replies: 17
Views: 1,674
Posted By Xeller8

RE: tuning help

LOL....hey...the majority of that post looks VERY familiar..:D

I really don't mind being plagerized in this instance...I'm glad I could help and it's actually kind of nice to see my advice being...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.