RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: orlandomd
Showing results 1 to 25 of 25
Search took 0.15 seconds.
04-03-2006, 10:20 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Guys,

While messing around with the 4in1, I lost one of the two screws to the cockpit. Does anyone know where I could get replacements screws? Would local HD or Lowes carry them?
03-28-2006, 08:25 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Excellent. I will try this. Thanks, my friend.
03-28-2006, 07:26 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

That pot thats on the board controls the motor proportion. Set your trim on your TX to nuetral, and center the pot. Adjust thepot from from there, also the adjustment to the proportion pot on the...
03-28-2006, 05:34 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

My friend, you have two people that are willing to buy the set, and I am sure you can find more in this thread. In any case, thanks for the offer to answer any questions. I'll see what I can do on...
03-28-2006, 04:40 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

My friend, how much would you charge me for preparing one for me and mailing it, as I am not handy? I live in Maryland. :D
03-28-2006, 10:26 AM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Also, what did you do with the antenna wire?
03-28-2006, 10:21 AM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Great looking LAMA! I like it a lot!! How did you make the tail and how did you attach it to the body?
03-27-2006, 10:54 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

I was actually able to get it out by pulling with a set of pliers. Tested it and flew well.....until I had a minor crash that broke the brand new inner shaft (the top black part) of it. So the new...
03-27-2006, 09:36 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Ok guys. I was able to find a post on changing the inner shaft but when i did what it said, i didn't quite get the results I was looking for. The attached picture shows what I got. The main gear A...
03-27-2006, 08:35 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Guys

The rubber tip of the inner shaft A has broken on my Lama. Are there any instructions on this thread on how to change it? I've tried to lossen up every screw that is attahced to it, but...
03-22-2006, 08:24 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Guys

Would someone kindly tell me how to adjust the pots in the 4 in 1? My Lama continues to rotate clockwise, and I've been able to control much of it with the trim, however, it continues to...
02-15-2006, 02:23 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

ok crystal. got it. I see it and did not replace it. I will try it now. Thank you so much!! I'll let you know how it does
02-15-2006, 01:20 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Guys,

I 've just changed the 4 in 1, as the original burned out, and so I've installed it and when I try to turn it on, I have my remote controls down, but the light in the 4 in 1 is flashing...
02-15-2006, 11:43 AM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Guys,

I am charging my battery again for the first time in a month, and when I plug it in the green light begins to blink instead of being steady. Any ideas as to what that means?
01-21-2006, 05:40 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Good to know. Thanks lseguy!
01-21-2006, 01:24 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Guys, it finally happened. My 4 in 1 control burned this morning. I've seen threads about this. Does anybody know in what page it's located? I need to obviously replace it, but do I have to...
01-12-2006, 06:22 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Thanks for the advise.

What other parts should I stock on, though?
01-12-2006, 05:42 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Guys, I am about to place an order for some parts, primarily the top blades and the main tail, since they already broke - gotta love this hobby. In any case, so far I've only found Heli Fever to be...
01-11-2006, 10:07 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

01-11-2006, 10:05 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Thank you Nubli. It did work. I appreciate the quick replies, guys.


Also, I always take any and all advise from the guys that have been flying for a while. So, please feel free to shoot...
01-11-2006, 09:50 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

ok it worked, and I was able to hover quite a bit. not bad at all to learn. so far I am pretty satisfied. could you tell me what extra parts you recommend I get, and where to get them from? i am...
01-11-2006, 09:24 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

No. I will do so right now, though. Thanks, my friend. I'll keep you updated.
01-11-2006, 09:09 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Ok guys. The batter is fully charged. I've installed the battery to the copter and the red light flashes a few times, but then it goes steady red. IT doesn't turn to green, and so I am back with...
01-11-2006, 08:41 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Hi guys. I am new to the site and new to the Esky Lama. Just received it and tried to fly it using the battery off the box without charging it first, but the rotor is not spinning. Forgive my...
01-11-2006, 08:39 PM
Replies: 1,137
Views: 150,759
Posted By orlandomd

RE: E-SKY LAMA 2 THREAD

Hi guys. I am new to the site and new to the Esky Lama. Just received it and tried to fly it using the battery off the box without charging it first, but the rotor is not spinning. Forgive my...
Showing results 1 to 25 of 25


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.