RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: rezenclowd3
Showing results 1 to 25 of 43
Search took 0.49 seconds.
Forum: Car Nitro & Gas Engines
04-21-2008, 12:54 AM
Replies: 8
Views: 764
Posted By rezenclowd3

RE: RB Motor like V-Spec?

The RB C6 is one of the finest race engines made today. It CAN be too much for many club drivers -) Like any engine, the lifespan of the parts depends on how the user treats and tunes the engine....
Forum: Car Nitro & Gas Engines
01-04-2008, 11:26 PM
Replies: 31
Views: 3,547
Posted By rezenclowd3

RE: Make your engine last forever! almost.

You should change your conrod after break in. Clean the engine after every day of running, and if possible, check to see if the conrod can fall of the crank pin with a slight tap. If it can, the...
Forum: RC Car Radio Equipment
12-20-2007, 07:46 PM
Replies: 3
Views: 668
Posted By rezenclowd3

RE: ACE is water proof!!!

Most likely water resistant like most high dollar servos, but not water proof. The output shaft is most likely where water will enter. If running in conditions like that, usually its best to put very...
Forum: RC Car Radio Equipment
08-24-2007, 10:56 PM
Replies: 20
Views: 2,119
Posted By rezenclowd3

RE: What do you guys think of this Airtronics Radio?

I believe DSP is display. If I am correct, when the radio is off, slide the switch up and JUST the display will turn on, so that you can adjust settings without broadcasting a signal. You can assign...
Forum: RC Truggy
08-07-2007, 01:58 AM
Replies: 7
Views: 937
Posted By rezenclowd3

RE: New Starter Box and new company!

I have the TM X5 Turbo II, pretty much the same as that, only difference is the coloring, and damn its good. I just used it to break in my RB C6BB...no troubles at all. Its also quite light. No...
Forum: RC Car Radio Equipment
08-01-2007, 02:16 AM
Replies: 4
Views: 801
Posted By rezenclowd3

RE: Should I wait it out just a little longer?

The failsafe is awesome as far as kicking in..but as far as setting it up with analog servos it BLOWS. If using analog servos, you must set the failsafe up every time you turn on the RX. If you...
Forum: RC 1/8th Scale Buggies
07-23-2007, 07:16 PM
Replies: 95
Views: 5,937
Posted By rezenclowd3

RE: R&B WS7||| & Ninja BO1A

At the minimum, change the conrod after break-in and at about 3-4 gallons, but also check the crank pin size...
Forum: RC 1/8th Scale Buggies
07-22-2007, 09:59 PM
Replies: 95
Views: 5,937
Posted By rezenclowd3

RE: R&B WS7||| & Ninja BO1A

Rody actually designs the engines dude....Yes it may be running fine, but probably has odd internal vibrations, and the bushing on the conrod is probably out of true now...
Forum: RC 1/8th Scale Buggies
07-22-2007, 03:10 AM
Replies: 95
Views: 5,937
Posted By rezenclowd3

RE: R&B WS7||| & Ninja BO1A

You dont need 3 in onroad, but it can help IF you know how to use the mid speed needle correctly to set up the powerband for your track. However, most people have a hard enough time with a 2 needle...
Forum: RC Car Radio Equipment
07-19-2007, 01:54 PM
Replies: 20
Views: 2,119
Posted By rezenclowd3

RE: What do you guys think of this Airtronics Radio?

A software upgrade would not have fixed your issue of losing connection. That is a limitation of AM and FM.
Forum: RC 1/8th Scale Buggies
07-19-2007, 02:48 AM
Replies: 95
Views: 5,937
Posted By rezenclowd3

RE: R&B WS7||| & Ninja BO1A

It really just depends. More engines come with 2 needle (High speed, low speed, and idle) rather than 3 needle (high speed, mid speed, low speed) The 2 needle is easiest to tune, but the 3 needle can...
Forum: RC Car Radio Equipment
07-18-2007, 09:54 PM
Replies: 3
Views: 731
Posted By rezenclowd3

RE: futaba 3pk and 3pks

Go to Futaba's site and download the manual. Sorry, about not taking a pic, but this is much easier :-D
Forum: RC Car Radio Equipment
07-18-2007, 09:52 PM
Replies: 3
Views: 761
Posted By rezenclowd3

RE: looking for a recommendation

Agreed, buy a 2.4Ghz radio. Look into the MX-3 FHSS, the Nomadio React, or a Spektrum DX 2.0 or 3.0. All are great radios, but buy it based on how comfortable it is and what features you need/want.
Forum: RC Car Radio Equipment
07-18-2007, 09:50 PM
Replies: 20
Views: 2,119
Posted By rezenclowd3

RE: What do you guys think of this Airtronics Radio?

You misunderstood, AND I wasn't very clear. I meant to say that other brands also have failsafe built into their systems. It is not exclusively Nomadio, nor were they the first to come out with it....
Forum: RC Car Radio Equipment
07-18-2007, 07:34 PM
Replies: 20
Views: 2,119
Posted By rezenclowd3

RE: What do you guys think of this Airtronics Radio?

1-I do not like the company because of the BS they have been feeding arrogant RCers. If you dont know the tech, how can you tell if its a lie, pushed numbers or just muddying the waters? I wont get ...
Forum: RC Car Radio Equipment
07-17-2007, 11:46 PM
Replies: 20
Views: 2,119
Posted By rezenclowd3

RE: What do you guys think of this Airtronics Radio?

How is there "Nothing close"? The only "extra" things are USB mode (Ill never use that) and built in telemetry that you still have to buy, and that it needs upgrades. Ive never owned a radio that...
Forum: RC 1/8th Scale Buggies
07-17-2007, 08:29 PM
Replies: 95
Views: 5,937
Posted By rezenclowd3

RE: R&B WS7||| & Ninja BO1A

I believe it is a 2 needle carb.
Forum: RC Car Radio Equipment
07-16-2007, 11:41 PM
Replies: 5
Views: 1,609
Posted By rezenclowd3

RE: Futaba 3PM 2.4 Ghz FASST..Failsafe?

I dont know. Look in the manual. I have the 3pks w/Fasst....Also I have yet to use the HRS failsafe...Ive just had a buddy show me, to convince me that I want digital servos;-)
Forum: RC 1/8th Scale Buggies
07-16-2007, 08:43 PM
Replies: 95
Views: 5,937
Posted By rezenclowd3

RE: R&B WS7||| & Ninja BO1A

I agree with it except for the pipe. With a high end engine, use a matched pipe. Try the 2045 out.
Forum: RC 1/8th Scale Buggies
07-16-2007, 08:36 PM
Replies: 95
Views: 5,937
Posted By rezenclowd3

RE: R&B WS7||| & Ninja BO1A

And you are assuming he is decent at tuning, clutch setup and gearing! Many people have opinions, less have real knowledge and experience. There are VERY many variables to consider.
Forum: RC Car Radio Equipment
07-16-2007, 08:04 PM
Replies: 5
Views: 1,609
Posted By rezenclowd3

RE: Futaba 3PM 2.4 Ghz FASST..Failsafe?

The failsafe is built in, but you have to set it every time you lose power to the RX. If you dont, the failsafe is "last given command" which could be full throttle. If you use all digital servos,...
Forum: RC Car Radio Equipment
07-16-2007, 08:02 PM
Replies: 20
Views: 2,119
Posted By rezenclowd3

RE: What do you guys think of this Airtronics Radio?

That is a VERY excellent radio. For the price there is nothing better (some will say the React, but that feels like a cheap wallmart toy)
Forum: RC Car Radio Equipment
07-16-2007, 08:01 PM
Replies: 51
Views: 5,969
Posted By rezenclowd3

RE: Need Your "Best Radio" Opinion Please!

Well, they did just move to another location. They have been going through alot of changes as of late. I have always received VERY good service from them. Ive sent in my M11 to just get cleaned and...
Forum: RC Truggy
07-15-2007, 01:00 PM
Replies: 99
Views: 6,126
Posted By rezenclowd3

RE: best truggy

The xray wasnt out when the article came out. Its still a bunch of hype. Really,the Losi 8 had the best stats of them all, but they kept crashing. Even so, they are all AMAZING vehicles, just buy the...
Forum: RC 1/8th Scale Buggies
07-15-2007, 12:57 PM
Replies: 95
Views: 5,937
Posted By rezenclowd3

RE: R&B WS7||| & Ninja BO1A

Actually no, the WS7III has quite enough low end, but it really screams on the top end. Ninja still has decent-great top end. The C6BB is actually just a tad less revs than the WS7III, but it gets to...
Showing results 1 to 25 of 43
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.