RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: bcchi
Showing results 1 to 7 of 7
Search took 0.04 seconds.
Forum: Engine Conversions
01-16-2011, 12:04 AM
Replies: 188
Views: 60,283
Posted By bcchi

RE: Custom Piston Rings

Hi Frank,
Did you get my order for rings for DL20&30. Not sure what I ordered but want three rings for DL 20 and two for DL 30.If you have sent fifferent thats OK.
No Hurry,
' BCCHI
Forum: Engine Conversions
12-26-2010, 11:48 PM
Replies: 188
Views: 60,283
Posted By bcchi

RE: Custom Piston Rings

This is not Terry,this is Bill C.BCCHI
Happy new year.
BCCHI
Forum: Engine Conversions
12-22-2010, 04:17 PM
Replies: 188
Views: 60,283
Posted By bcchi

RE: Custom Piston Rings

Hello Frank,
We have had great luck with your rings in all three of the DL 30 that we have installed them in.Better compression right off the bat.eaiser hand starts and 100 to 150 better RPM.They...
Forum: Engine Conversions
11-11-2010, 01:17 AM
Replies: 188
Views: 60,283
Posted By bcchi

RE: Custom Piston Rings

They found the airplane no survivors.It was about a mile from where it disapeared off radar.His last radio message he said he had lost control of the airplane. From picture in Riverton Ranger it...
Forum: Engine Conversions
10-31-2010, 11:50 PM
Replies: 188
Views: 60,283
Posted By bcchi

RE: Custom Piston Rings

They have not found the airplane,Have been using air guard Helos and CAP planes.They did pick up a ELT but cannot locate it.
Bad,Bad,Bad,
Poor family,The pilot had three of his sons with him...
Forum: Engine Conversions
10-28-2010, 11:56 PM
Replies: 188
Views: 60,283
Posted By bcchi

RE: Custom Piston Rings

You are close but no Cigar.
The wind river starts at Wind River lake,a few miles past Brooks lake turn off.Brooks lake creek comes out of Brooks lake and into Wind river.
There is a airplane...
Forum: Engine Conversions
10-12-2010, 12:16 AM
Replies: 188
Views: 60,283
Posted By bcchi

RE: Custom Piston Rings

Hi John and all,
Taking .015 off the bottom of DL cyl was not one of my better ideas.Do not do it.With no cyl gasket piston hit the top.Put on two cyl gaskets and a bowman ring.
After a short...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.