RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: nozzler
Showing results 1 to 20 of 20
Search took 0.67 seconds.
Forum: Tips & Techniques
10-25-2010, 02:47 PM
Replies: 11
Views: 2,615
Posted By nozzler

WW1 Roundels

I have covered a 1/4 scale ww1 aircraft with Coverite fabric, and would like to paint the roundels onto the wing, rather than using vinyl decals or whatever.
Anyone have suggestions as to what I...
Forum: Airtronics Support Forum
08-25-2010, 03:09 PM
Replies: 5
Views: 1,340
Posted By nozzler

SD-10G charging

Can I use a different charger (other than the one which comes with the radio) to charge my TX?
I have a Hobbico Accu-cycle that I have used with other transmitters in the past, and I was hoping...
Forum: RC Sailboats
06-07-2010, 02:15 PM
Replies: 5
Views: 3,366
Posted By nozzler

RE: Dartmouth Nova Scotia Canada

Contact the Canadian r/c yacht association at http://crya.ca/

I'm pretty sure there is a club in Halifax.
Forum: Batteries & Chargers
05-07-2010, 02:08 PM
Replies: 1
Views: 679
Posted By nozzler

RE: Is the thunder ac6 known to be slow?

It could be that your charger is limited to 50w max, as many are. So, with a 11v pack, the charger likely can't reach 1C current (5 amps for a 5000mah pack). This causes a slowdown. Also, most of...
Forum: Gas Engines
12-26-2007, 04:20 PM
Replies: 1
Views: 1,085
Posted By nozzler

RE: CRRC Pro 26cc Prop Shaft Diameter

Measured mine - it is 8 mm.
Forum: RC Scale Boating
12-19-2007, 04:08 PM
Replies: 1
Views: 1,289
Posted By nozzler

Pittman motor

Picked up a Dumas/Pittman 12v motor for my boat. Can someone tell me if I need to solder some capacitors to this motor to reduce the RFI?
Forum: 3D Electric Flying!
11-01-2005, 04:30 PM
Replies: 4
Views: 1,220
Posted By nozzler

RE: Stevens Edge 540 ""NICE""

Scan the Stevens Aero site - I believe he sells the Hacker A30-16M (the recommended motor for the Edge) at a very good price.
Forum: Twin & Multi Engine RC Aircraft
05-20-2005, 03:46 PM
Replies: 12
Views: 3,120
Posted By nozzler

RE: Bristol Beaufighter

Is the Beau built from plans or a kit? Are you using LiPolys or round cells?
Forum: Glow Engines
02-04-2005, 06:02 PM
Replies: 7
Views: 892
Posted By nozzler

Inverted 4-stroke

Where should the center of the fule tank be located, in relation to the needle valve on an inverted Saito 100? My new ARF pattern plane requires an inverted engine, and permits a fair bit of latitude...
Forum: Gas Engines
09-10-2003, 05:30 PM
Replies: 6
Views: 1,041
Posted By nozzler

RE: zdz40 sportsman

The "sportsman" version of the ZDZ40 apparently uses a reed valve, while the regular version uses a rotary valve on the intake. Anyone know if these differences add up to better/worse performance or...
Forum: Gas Engines
09-06-2003, 10:30 PM
Replies: 6
Views: 1,041
Posted By nozzler

zdz40 sportsman

Would this engine (ZDZ 40 Sportsman) be a good choice for my first try at gas engines? I'm not into 3D or any other extremes, just want a reliable gasser for sport flying a 11-12 lb airframe.
Forum: RC Scale Aircraft
07-20-2003, 09:16 PM
Replies: 0
Views: 522
Posted By nozzler

CGM Sukhoi

Does anyone know if the SU-26 kit being offered by the "new" Carl Goldberg Products company has the LG affixed to the fuselage, hopefully, rather than to the wing as in the original version?
Forum: Giant Scale Aircraft - 3D & Aerobatic
05-24-2003, 08:18 PM
Replies: 10
Views: 3,745
Posted By nozzler

1/4 Aviatik D1 Berg

Try Hannan's bookstore www.hrunway.com
He sells a lot of the Windsok publications on ww1 aircraft, and there is an issue devoted to the Berg D1 which may still be available.
Forum: Batteries & Chargers
12-28-2002, 11:43 PM
Replies: 8
Views: 1,318
Posted By nozzler

Sure Cycle - How to know when charging completed?

Most radio systems are using 600mah or 700 mah batteries in the TX and RX. So, for these, use the 50ma charge setting on your Sure Cycle, and give the packs a nice overnight charge.

Many people...
Forum: Batteries & Chargers
12-28-2002, 03:39 AM
Replies: 8
Views: 1,318
Posted By nozzler

Sure Cycle - How to know when charging completed?

It is no different than the charger that came with you radio. So, the normal 14 hour overnight charge is what you are aiming for.

The cycler is simply an excellent tool to let you know the...
Forum: RC Scale Aircraft
05-14-2002, 07:42 PM
Replies: 4
Views: 2,235
Posted By nozzler

1/4 Scale WW1 German Pilot

I believe that Proctor sells a nicely finished full-body pilot, but don't know if they have just the bust.
Forum: RC Scale Aircraft
04-23-2002, 07:28 PM
Replies: 3
Views: 2,026
Posted By nozzler

Sopwith Camel kits??

The only 1/4 Camel I've come across is the one kitted by Mick Reeves in the U.K. Sells for about 350 pounds, as I recall, but is contest-quality scale.
Forum: RC Scale Aircraft
03-05-2002, 09:57 PM
Replies: 4
Views: 1,891
Posted By nozzler

Torrance models new Fokker D-8 kit

I have his DR.1 kit and it certainly is a match for Proctor quality. I'm sure you'll be happy with the D.VIII
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-22-2002, 09:15 PM
Replies: 40
Views: 3,672
Posted By nozzler

Futaba 9C any thoughts

There's a full review of this radio in the latest issue of R/C Report.
Forum: Glow Engines
02-01-2002, 11:10 PM
Replies: 10
Views: 1,476
Posted By nozzler

If you could put any engine in a Goldberg Sukhoi, what would it be?

I'd be inclined to go with a Super Tigre 2300 which should have ample power to pull the Suky through any maneuver one would wish.
Showing results 1 to 20 of 20


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.