RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: pe reivers
Showing results 1 to 1 of 1
Search took 0.02 seconds.
Forum: MVVS Support
08-23-2012, 09:00 AM
Replies: 2
Views: 1,004
Posted By pe reivers

RE: Prop Shaft thread

The central shaft is M10x1 metric fine thread. This nut is not really needed, and if present should be torqued only lightly, as too much torque can drive the prop drive up the taper on the crankshaft...
Showing results 1 to 1 of 1


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.