RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: pe reivers
Showing results 1 to 3 of 3
Search took 0.11 seconds.
Forum: Gas Engines
02-22-2013, 03:53 PM
Replies: 7
Views: 7,855
Posted By pe reivers

RE: Walbro carb linkage hookup

It sure is the easiest way to do it. Sometimes it needs a pulley or 90° lever to negotiate corners.
Forum: Gas Engines
02-22-2013, 09:15 AM
Replies: 7
Views: 7,855
Posted By pe reivers

RE: Walbro carb linkage hookup

Home building shops sell aluminum angle hardware etc. Makes great material to make things of.
Sloppy hole? drill it out and press in a piece of glow fuel tubing. Cut off neatly, and you will have a...
Forum: Gas Engines
08-14-2004, 09:46 AM
Replies: 7
Views: 7,855
Posted By pe reivers

RE: Walbro carb linkage hookup

I use the same ball setup, but fit an 1/8" thick aluminum extension to the throttle arm to get better idle and low speed control. I use Sullivan golden rods, and tiewrap the outer sheath to the...
Showing results 1 to 3 of 3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.