RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: helitroy
Showing results 1 to 25 of 58
Search took 0.13 seconds.
Forum: Walkera Helis - Dragonfly, etc..
06-26-2006, 05:36 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

Hiene,
I say If its working, leave it be....But if your determined to mess with it and get it tuned even better, Im wondering if you need more pitch on the tail? If you adjust the slider out more...
Forum: Walkera Helis - Dragonfly, etc..
06-25-2006, 03:34 PM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

Hmmm.. Its down to about 9.2 after three runs. On yours, when you charge it, does the light turn green when done? mine allways stays red no matter how long I charge it. Thanks.
Forum: Walkera Helis - Dragonfly, etc..
06-25-2006, 01:00 PM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

That will be an excellent setup and the heli will have much power! Look out. On the tx, I use the DX6 and it is very easy to set up. The only thing I dont like is the batt. does not last long, I'm...
Forum: Walkera Helis - Dragonfly, etc..
06-25-2006, 12:55 PM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

I found with mine the same problem. Even with the factory brushed weak motor, I needed to adjust the pitch to 6 deg mid throttle and it took off. Do you have a pitch guage? Try adjusting the pitch a...
Forum: Walkera Helis - Dragonfly, etc..
06-22-2006, 07:15 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

Man, Its no fun when it quits. I thought you had picked up the DX6? Isnt the walkera tx suppose to warn you of low voltage? That is the only thing I dis like about the DX6 is the batt. does not last...
Forum: Walkera Helis - Dragonfly, etc..
06-22-2006, 07:09 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

Yes, the tail should be very smooth. Undo the long push rod from the tail and see how smooth it is. With mine I found one blade holder was too tight and causing drag. (actually it was the little...
Forum: Walkera Helis - Dragonfly, etc..
06-18-2006, 09:47 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

To post a pic, you have to hit reply or quote on someones coment than when the box to post a note comes on you'll see a link that says upload a file than just browse to the pic and it loads it.
On...
Forum: Walkera Helis - Dragonfly, etc..
06-18-2006, 09:40 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

Nice Servos! they seem to fit good. How well are they working?
Forum: Walkera Helis - Dragonfly, etc..
06-18-2006, 09:37 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

I deserve a butt chewin. The wind in the canyon is unpredictable but still should have waited. I have to keep in control by remaining in my air space till I'm ready for flight! I think that was my...
Forum: Walkera Helis - Dragonfly, etc..
06-18-2006, 08:39 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

[X(] I have terrible news.....
I have ran 25-30 batt. on my 60, learning and only getting it up 2-3 feet. It has been unstable. I posted a couple days ago about a tail problem. I started all...
Forum: Walkera Helis - Dragonfly, etc..
06-17-2006, 10:35 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

Hmmmmm, Yea. nuff said. :D
Forum: Walkera Helis - Dragonfly, etc..
06-17-2006, 07:56 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

It seems the shaft is fine as I have full movement for blade pitch, Its like the blades dont spin fast enough to compensate for a rotation. I'm wondering if it is slipping on the shaft? Like you...
Forum: Walkera Helis - Dragonfly, etc..
06-17-2006, 07:52 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

I just want to mention, mine shook good too at lower revs, I tightened my blades 1/8 or less of a turn evenly till allmost completely gone, I dont know if its a good idea or not. My blades are...
Forum: Walkera Helis - Dragonfly, etc..
06-17-2006, 07:42 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

Soneebee,
Great, Thanks, I'm getting ready to check it out. I had some other issues yesterday so I need to start over and check from top to bottom. I have noticed It's a different bird every day....
Forum: Walkera Helis - Dragonfly, etc..
06-17-2006, 07:19 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

Soneebee,
I can't remember, was there an issue of the belt becoming loose? When I try to turn right, the rotor blades pitch just fine but the heli doesn't want to turn, could it be slipping?. Was...
Forum: Walkera Helis - Dragonfly, etc..
06-15-2006, 09:25 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

consultjdm,

its amazing how well it will fly and not even on the controls. Its got a mind of its own. Run, duck..........

soneebee,

I havent found a head yet. I thought about getting...
Forum: Walkera Helis - Dragonfly, etc..
06-14-2006, 10:59 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

My heli took off with out my permission, in my house and smaked the microwave and flew over onto the coutch (glitched with walkera tx) ( my first "flight") and when I got to it and checked it out the...
Forum: Walkera Helis - Dragonfly, etc..
06-14-2006, 10:46 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

Thanks, I just noticed they carry 60 parts. Has any one tried a metal swash for the 60 yet?
You should have seen my flight yesterday. I got it up 4-5 ft a few times and get nervous but this one...
Forum: Walkera Helis - Dragonfly, etc..
06-14-2006, 09:32 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

It might be missing the bearing on the shaft. You have to hold each end with allen wrenches to keep it from just spinning. There should be two bearings on each holder. The DX6 is a tx rx made by...
Forum: Walkera Helis - Dragonfly, etc..
06-14-2006, 08:50 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

oryan2,

I just wanted to ask you if you have flown before? If you have practiced on a sim and read Radds school of flight? This will save you much repair and headach. You can purchase new canopy...
Forum: Walkera Helis - Dragonfly, etc..
06-12-2006, 12:11 PM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

Yes those are it. I replaced the arms and the new pins fit very tight but I have to keep an eye on them. I will use glue if I see any movement. Thanks. :D
Forum: Walkera Helis - Dragonfly, etc..
06-12-2006, 06:19 AM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

Hi, just an update. Two days ago I was spinning the heli up and just as it got light it all of a suddon dropped. I knew something was wrong. Sure enough the little pin on the seesaw had came out and...
Forum: Walkera Helis - Dragonfly, etc..
06-09-2006, 01:30 PM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

Soneebee,

I'm sorry to hear about your crash. Sounds like you got it back together ok. With mine, I readjusted the blade pitch, one was off about a degree. I than went into my dx6 and on the...
Forum: Walkera Helis - Dragonfly, etc..
06-08-2006, 01:55 PM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

Um, On the dx6, are you talking about ccpm setting? I believe its 2 3 and 6? I dont have it with me right now. It does not have much responce from 50% to full but is already cranking. That would...
Forum: Walkera Helis - Dragonfly, etc..
06-08-2006, 01:47 PM
Replies: 7,266
Views: 567,411
Posted By helitroy

RE: WALKERA 60

It won't lift till 100% throttle and it will go about a foot. Steady as can be though till I set it down to reposition if needed. I dont know what the rpm is. The motor is a 3000 L 380. I never had...
Showing results 1 to 25 of 58
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Manage Preferences - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.