RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: KGSS28
Showing results 1 to 25 of 286
Search took 0.53 seconds.
03-10-2017, 10:32 AM
Replies: 732
Views: 203,766
Posted By KGSS28

The HiMax motors are bullet prof I have one with...

The HiMax motors are bullet prof I have one with almost 2000 flights no problems at all.
10-14-2016, 10:38 AM
Replies: 1
Views: 1,229
Posted By KGSS28

I have run that combo for years 18 degree timing...

I have run that combo for years 18 degree timing and frequency 8 kHz flawless never a problem static about 70 amps motor never more than warm after flight have some packs well over 100 flights on...
04-07-2015, 03:27 AM
Replies: 204
Views: 41,797
Posted By KGSS28

Great thanks, I had my phone mounted to the left...

Great thanks, I had my phone mounted to the left side of the hand rest on my transmitter tray and got to thinking about how far from center of tray that was so I played with it with a small level...
04-04-2015, 05:15 AM
Replies: 43
Views: 18,329
Posted By KGSS28

Sounds Good, I want to try it on a Hacker A60 7S...

Sounds Good, I want to try it on a Hacker A60 7S in a Nuance . I think it might work, I only fly Intermediate so not very demanding.
Did you notice any trim changes with it ?
Thanks Kirk
04-04-2015, 04:30 AM
Replies: 43
Views: 18,329
Posted By KGSS28

What motor are you using ? Was there any...

What motor are you using ? Was there any difference in amp draw compared to the 2 blade ?
Thanks
04-03-2015, 08:29 AM
Replies: 204
Views: 41,797
Posted By KGSS28

Hey Peter Having pretty good luck with the app on...

Hey Peter Having pretty good luck with the app on a I Phone 5 using tilt ( roll ) with my phone on my trans. tray. Is there a way to make it take a little less tilt to advance to the next maneuver...
03-09-2015, 07:40 AM
Replies: 204
Views: 41,797
Posted By KGSS28

Thanks working great .

Thanks working great .
03-07-2015, 07:06 AM
Replies: 204
Views: 41,797
Posted By KGSS28

Will this work on an I Phone 5 without cell or...

Will this work on an I Phone 5 without cell or internet service ? Our field is remote and does not have much service
Thanks
01-08-2015, 09:46 AM
Replies: 43
Views: 18,329
Posted By KGSS28

I was just wondering almost 300 views and only 2...

I was just wondering almost 300 views and only 2 comments on them. I need more info before a try.
01-02-2015, 08:23 AM
Replies: 43
Views: 18,329
Posted By KGSS28

3 Blade props

I notice the 3 blade props advertised as the poor mans Contra. What is the story on them.

Has anyone tried one ?

Thanks
01-02-2015, 04:45 AM
Replies: 204
Views: 41,797
Posted By KGSS28

I put this app on an I phone 4 it works well as...

I put this app on an I phone 4 it works well as long as it has the Internet or cell service. Problem is our field has neither.
Can it be used without cell or internet service ?

I downloader it...
10-24-2014, 03:33 AM
Replies: 23
Views: 2,693
Posted By KGSS28

Yes there are issues with Castle . They just...

Yes there are issues with Castle . They just don't like the 28 pole motors . The same is true for the OS ESC . I recommend the Jeti Spin 99 , I have it in a Nuance with the Hacker A-60 with over 200...
09-24-2014, 01:13 PM
Replies: 0
Views: 525
Posted By KGSS28

SD 10 G Issue with dual Ele. Servos

I have an SD10G that is 14 months old that I use in a 2 m Pattern plane with dual elevator servos in the stabs . I am using the 7 Ch. reciever. The reciever was also new at this time.

I am ...
06-22-2014, 05:20 AM
Replies: 2
Views: 831
Posted By KGSS28

Hey Wayne , For the set up I recommend you follow...

Hey Wayne , For the set up I recommend you follow this procedure.
http://www.rcuniverse.com/forum/electric-pattern-aircraft-385/11598748-help-setting-fixed-end-points-jeti.html

By Jim Odino (...
06-14-2014, 04:16 AM
Replies: 61
Views: 19,134
Posted By KGSS28

Also see...

Also see http://www.rcuniverse.com/forum/electric-pattern-aircraft-385/11598748-help-setting-fixed-end-points-jeti.html Post #3 by Ohd This method works hands down. If you will follow it, it will...
06-14-2014, 04:09 AM
Replies: 61
Views: 19,134
Posted By KGSS28

Also see...

Also see http://www.rcuniverse.com/forum/electric-pattern-aircraft-385/11598748-help-setting-fixed-end-points-jeti.html Post #3 by Ohd This method works hands down. If you will follow it, it will...
06-04-2014, 02:17 PM
Replies: 11
Views: 3,131
Posted By KGSS28

Redundant Receiver battery setup

What is out there in redundant receiver battery setups ? I need something that has an output that I can run in parallel into one channel on the receiver or that I could parallel the batteries at the...
06-04-2014, 02:07 PM
Replies: 9
Views: 1,455
Posted By KGSS28

Did we ever get an answer to this ? I have an...

Did we ever get an answer to this ? I have an SD-10 G that is 5 months old making the noise.
05-29-2014, 01:02 PM
Replies: 14
Views: 5,862
Posted By KGSS28

Thanks Jim , I have done some creative THR curve...

Thanks Jim , I have done some creative THR curve stuff with a flight mode for landing that makes it pretty good. It will start at the fourth click at a slightly fast idle then I can come down one...
05-29-2014, 03:54 AM
Replies: 9
Views: 2,205
Posted By KGSS28

Jeti Spin 99 or Mezon I have a Nuance with...

Jeti Spin 99 or Mezon

I have a Nuance with the same motor, Spin 99, Falcon 21x14 prop and with my heavy batteries putting the plane right at 11 pounds it will jerk it around like a rag doll . The...
05-29-2014, 03:43 AM
Replies: 14
Views: 5,862
Posted By KGSS28

I have the same switch as you . I looked at the...

I have the same switch as you . I looked at the OS but never could get a good answer about the 28 pole motor's with it . I have a Hacker A-60 7S V2 and the Spin 99 that work great .

I just...
05-28-2014, 02:03 PM
Replies: 14
Views: 5,862
Posted By KGSS28

Hey Jim why do the Jeti Spin 's have that little...

Hey Jim why do the Jeti Spin 's have that little lag in motor restart comming out of brake ? I fly ATX SD 10 G and it is 3 clicks up for me. I don't notice it in the air but sometimes trying to use...
05-24-2014, 07:42 AM
Replies: 665
Views: 172,346
Posted By KGSS28

Anyone know if there is any weight difference...

Anyone know if there is any weight difference between the stock gear and the canard gear for the Nuance ?

Thanks
05-22-2014, 09:28 AM
Replies: 16
Views: 4,327
Posted By KGSS28

I have never really tried noticed pull but the...

I have never really tried noticed pull but the carbon will spool up a lot quicker than the APC . Might be the weight difference or the rotating mass thing. I had always heard the blade profile on the...
05-21-2014, 01:51 PM
Replies: 16
Views: 4,327
Posted By KGSS28

I think so, in weight the V-2 Falcon is about 1/2...

I think so, in weight the V-2 Falcon is about 1/2 the weight of some APC's in the same range the extra light one is even less . I use less Mah per flight ,have better breaking and have cooler motor...
Showing results 1 to 25 of 286
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.