RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 6
1
2
3
Last »
Search: Posts Made By: Mike2002
Showing results 1 to 25 of 141
Search took 0.84 seconds.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-26-2007, 10:42 AM
Replies: 1
Views: 606
Posted By Mike2002

Airtronics Crystals

I need to buy a new crystal for my 27mhz AM Airtronics radio. I can't seem to find any at towerhobbies so can i just use a different brand such as Futaba crystals. Or are there any places that sell...
Forum: RC Nitro Stadium Trucks
03-18-2007, 06:09 PM
Replies: 21,657
Views: 1,514,323
Posted By Mike2002

RE: Official HPI MT2 Thread

Running too lean or hot will definitely burn up the glow plugs. I would guess you are too lean over being too rich. Maybe there is an air leak somewhere as well since you said the needles are set...
Forum: Car Nitro & Gas Engines
03-13-2007, 04:32 PM
Replies: 6
Views: 1,368
Posted By Mike2002

RE: Rebuilt T-15 won't start.

You are correct, the starting pin is missing. This is what the starting pin looks like along with the spring that fits in behind the pin. Pressure Pin I'd make sure that the pin didn't fall off...
Forum: RC Nitro Stadium Trucks
03-13-2007, 01:53 AM
Replies: 3
Views: 551
Posted By Mike2002

Clutch Bell Bearings

I had my clutch bell off the other day and when i removed it and took the bearing off that the clutch bell slides over, about 4/6 of the cylindrical rollers fell out of their housing. Does this...
Forum: Car Nitro & Gas Engines
03-11-2007, 12:32 AM
Replies: 8
Views: 1,031
Posted By Mike2002

RE: Sealing an Engine...Air Leaks

I sealed up the engine the other day and tried to start the engine today. I tried and tried and couldn't get it started. I ended up flooding the engine and stopped after that. I am hoping its just...
Forum: Car Nitro & Gas Engines
03-07-2007, 07:05 PM
Replies: 5
Views: 561
Posted By Mike2002

RE: bit of help please

From the video that you posted it sounds like you are running fairly lean. The weather definitely does make a difference and they really do need to be tuned each and every time out .
Forum: Car Nitro & Gas Engines
03-07-2007, 11:15 AM
Replies: 8
Views: 1,031
Posted By Mike2002

RE: Sealing an Engine...Air Leaks

I don't have a temp gun to test the temperatures but i'll see some smoke coming off the head and sometimes it'll shut off on its own. I did the water test on the cooling head and the water will...
Forum: Car Nitro & Gas Engines
03-07-2007, 10:46 AM
Replies: 8
Views: 1,031
Posted By Mike2002

Sealing an Engine...Air Leaks

I've been having some problems with my engine getting too hot when its warm outside and when i put the body on the car. I have an MT2 with the T-15 engine in it and i've heard that many of them have...
Forum: Car Nitro & Gas Engines
12-09-2006, 11:13 PM
Replies: 4
Views: 1,486
Posted By Mike2002

RE: Glow Plug with Idle Bar

Yup i've taken the plug out of the engine and tested it and it glows very brightly all the way down the coils. I guess i'll just have to play around with it some more to see what the problem is.
Forum: Car Nitro & Gas Engines
12-09-2006, 11:12 PM
Replies: 3
Views: 965
Posted By Mike2002

RE: Glowplug stuck

I think i would also take the cooling head off and then take the glow plug attached to the head button off. I'd then put the glow plug into a vice or just tighten a wrench as much as possible around...
Forum: Car Nitro & Gas Engines
12-09-2006, 02:14 PM
Replies: 4
Views: 1,486
Posted By Mike2002

RE: Glow Plug with Idle Bar

I installed the plug with the idle bar and the piston moves fine wihtout hitting the idle bar, but the engine won't start. Does the idle bar make it any harder to start since it is blocking the...
Forum: Car Nitro & Gas Engines
12-05-2006, 01:39 PM
Replies: 4
Views: 1,486
Posted By Mike2002

Glow Plug with Idle Bar

Is there anything wrong with using a glow plug that has an idle bar on my .15 car engine. My glow plug died and the only ones that i have left are the ones with the idle bar that were in my plane...
Forum: RC Nitro Stadium Trucks
10-20-2006, 10:27 AM
Replies: 9
Views: 953
Posted By Mike2002

RE: QUICK REPLY MT2

Try adjusting the idle screw that's located on the carbureator. It is on the top of the carb, and it might be hidden by the air filter a little bit. Turn the screw into the right to make the idle...
Forum: RC Nitro Stadium Trucks
10-05-2006, 10:26 PM
Replies: 21,657
Views: 1,514,323
Posted By Mike2002

RE: Official HPI MT2 Thread

Has anyone had their clutch bell go bad?? The gear part(sprocket I guess) and the part that connects to the clutch plates came totally disconnected today when I was running my truck. I now have...
Forum: Car Nitro & Gas Engines
10-02-2006, 09:10 PM
Replies: 2
Views: 463
Posted By Mike2002

Glow Plug Question

The glow plug in my .15 sized engine in an HPI MT2 is not lit all the way down the coil. The majority of the coil is red hot with the charger attached except for about the last loop closest to the...
Forum: RC Nitro Stadium Trucks
09-30-2006, 04:16 PM
Replies: 21,657
Views: 1,514,323
Posted By Mike2002

RE: Official HPI MT2 Thread

Do you drive your cars with the body on?? I'd like to drive it with the body on, but the truck overheats after about a half tank so I just drive it around with the body off. I was thinking about...
Forum: RC Nitro Stadium Trucks
09-10-2006, 01:02 AM
Replies: 8
Views: 386
Posted By Mike2002

RE: Car Won't Stay Running

Haha that doesn't bode well for me then. Maybe I just need to get the tuning better. It sounds and feels pretty good but I might not be as good as I think it is. I am also running 20% nitro, do...
Forum: RC Nitro Stadium Trucks
09-09-2006, 01:23 PM
Replies: 8
Views: 386
Posted By Mike2002

Car Won't Stay Running

I have an HPI MT2 with the .15 sized engine. The thing starts very well and will run perfectly for about half a tank or about 5-7 minutes, but after that the engine will stall and I won't be able to...
Forum: RC Nitro Stadium Trucks
05-27-2006, 03:12 PM
Replies: 13
Views: 565
Posted By Mike2002

RE: very hot

A hot run is usually associated with a too lean needle setting. Turn the hi speed needle to the left about a quarter turn. Go from there and see if the engine is running any cooler.
Forum: RC Nitro Stadium Trucks
05-27-2006, 09:40 AM
Replies: 1
Views: 341
Posted By Mike2002

Slipper Clutch Question

Does the slipper clutch on a 4 wheel drive car affect both the front and rear drivetrain or does it only protect the rear drivetrain and tires? Thanks.
Forum: RC Nitro Stadium Trucks
05-25-2006, 11:39 AM
Replies: 6
Views: 562
Posted By Mike2002

RE: 4 Wheel Drive--Only Front Tires Working

I opened up the rear differential and the gears don't really look that bad. They may be rounded off a little, but none of the teeth are missing or worn completely down. There are a few metal flakes...
Forum: RC Nitro Stadium Trucks
05-24-2006, 07:05 PM
Replies: 6
Views: 562
Posted By Mike2002

RE: 4 Wheel Drive--Only Front Tires Working

I just went and played with it some and I found that the rear tires are acutally powered, but the front tires are spinning much faster than the rear ones. It seems like most of the power is being...
Forum: RC Nitro Stadium Trucks
05-24-2006, 06:04 PM
Replies: 6
Views: 562
Posted By Mike2002

4 Wheel Drive--Only Front Tires Working

I have an HPI MT2 truck. It's 4 wheel drive, and I was out with it today and there was a weird noise coming from it and I concluded that only the front tires were being powered. I lifted it in the...
Forum: RC Flight Simulator Software
05-12-2006, 01:11 PM
Replies: 8
Views: 2,310
Posted By Mike2002

Real Flight G2 and Windows XP

Is the Great Planes Real Flight G2 simulator compatible with Windows XP?? I purchased it back a few years ago and have not used it since I upgraded my computer to Windows XP, and I wanted to use the...
Forum: RC Nitro Stadium Trucks
02-19-2005, 06:13 PM
Replies: 6
Views: 362
Posted By Mike2002

Cleaning nitro trucks

I just took my HPI MT2 out to a baseball field and it got extremely dirty. A little bit of fuel leaks around the fuel tank which causes the dirt on the car to turn to mud. Is there any specific way...
Showing results 1 to 25 of 141
 
Page 1 of 6
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.