RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Bill Diedrich
Showing results 1 to 6 of 6
Search took 0.04 seconds.
Forum: ARF or RTF
07-14-2010, 09:24 PM
Replies: 11
Views: 3,348
Posted By Bill Diedrich

RE: CMP Edge 540-T .40-.50 size

Moved the elevator servo around 180 degrees and it is a lot better,
after adjusting the clevis's on both sides I am within 1/16th inch of
having everything equal. Also got the rudder cables...
Forum: ARF or RTF
07-14-2010, 02:37 PM
Replies: 11
Views: 3,348
Posted By Bill Diedrich

RE: CMP Edge 540-T .40-.50 size

Yes they are, there is a double wire fitting in the rear end of of fiberglass tube and a
fitting for a single wire in the forward end of the tube. but although the 2 wires are of
equal length to...
Forum: ARF or RTF
07-13-2010, 10:06 PM
Replies: 11
Views: 3,348
Posted By Bill Diedrich

RE: CMP Edge 540-T .40-.50 size

Thanks for the tip on the tailwheel assembly, will have to get some of those
on my next Tower supplies order.

Opjose I am having a heck of a time with the elevator linkage on this one, once
...
Forum: ARF or RTF
07-13-2010, 06:20 AM
Replies: 11
Views: 3,348
Posted By Bill Diedrich

RE: CMP Edge 540-T .40-.50 size

A little off the subject but I had 2 Magnum 91 4 strokes and they both went
back to Global Hobbies, twice, for problems, cams were replaced,could never
get them to idle below 3500 RPM. Our...
Forum: ARF or RTF
07-12-2010, 01:47 PM
Replies: 11
Views: 3,348
Posted By Bill Diedrich

RE: CMP Edge 540-T .40-.50 size

No I stay as far away from Magnum 4-strokes as I can, have had nothing but bad luck
with them, but I have several 2-stokes and that is what is going in this bird.
Magnum .52 2-Stroker with a...
Forum: ARF or RTF
07-11-2010, 02:52 PM
Replies: 11
Views: 3,348
Posted By Bill Diedrich

CMP Edge 540-T .40-.50 size

Anyone have any comments, good, bad or ugly about the 40-50 size CMP Edge 540-T.
Started the assembly process on mine this weekend, should be ready for maiden next
weekend weather permitting.
...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.