RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: at7driver
Showing results 1 to 25 of 41
Search took 0.45 seconds.
Forum: Extreme Speed Prop Planes
02-08-2009, 09:05 AM
Replies: 828
Views: 153,968
Posted By at7driver

RE: Sundowner 50 Arf

hey todd,

not sure but I would guess it is his 42% Kelly



while they dont look good those quickies get up pretty fast.. not sure exact numbers but I think around 160.. maybe faster.....
Forum: Extreme Speed Prop Planes
02-06-2009, 08:36 PM
Replies: 828
Views: 153,968
Posted By at7driver

RE: Sundowner 50 Arf

thanks guys,

I'll experiment with the props on the 46 first..


earlier post mentioned rob, typo.... sorry meant to say thanks bob..


david
Forum: Extreme Speed Prop Planes
02-06-2009, 09:43 AM
Replies: 828
Views: 153,968
Posted By at7driver

RE: Sundowner 50 Arf

Thanks Rob,

I will get some 9" apc's and try those...

I love the jettstream pipe, tried to follow your lead on the install.. not as nice and neat but gets the job done.. first time I had...
Forum: Extreme Speed Prop Planes
02-05-2009, 09:59 PM
Replies: 13
Views: 818
Posted By at7driver

RE: Proper Balance

oh

I'll also keep tabs on this thread as that is the engine I want on my SD 50... love it.. if even half of the reports I have read are accurate you will be very impressed with your purchase.. ...
Forum: Extreme Speed Prop Planes
02-05-2009, 09:56 PM
Replies: 13
Views: 818
Posted By at7driver

RE: Proper Balance

hi,

I would try the Jett support forum here on RCU... or their website FAQ's... just for starters.. after all its their engine and they do KNOW the biz and can help.. just my 02cents.

david
Forum: Extreme Speed Prop Planes
02-05-2009, 08:31 PM
Replies: 828
Views: 153,968
Posted By at7driver

RE: Sundowner 50 Arf

hi all,

wanted to get some opinions on engines... I maidened sunday with my trusty os 46ax, 10x7 prop with jettstream thru fuselage pipe setup.. might have had her set a bit rich but wasnt all...
Forum: ARF or RTF
02-02-2009, 08:47 PM
Replies: 73
Views: 14,524
Posted By at7driver

RE: Hanger 9 Sundowner 50

just maidened my SD 50 yesterday..

a little windy but not bad. running a tired OS 46 with jettstream muffler. cg @ 2.5

she flew nice, have not flown anything like this before and it is...
Forum: Extreme Speed Prop Planes
12-04-2008, 10:38 AM
Replies: 16
Views: 2,397
Posted By at7driver

RE: best go fast prop for a OS AX 46?

in regards to prop choice for the OS 46 AX with Jett jetstream red pipe in a H9 SD 50.. 10x6, 10x 7 or ...... looking for APC props for now..
Forum: General Racing Discussion
11-27-2008, 08:29 PM
Replies: 8
Views: 840
Posted By at7driver

RE: Pylon Racing in ATL

thanks for the updates..

I didnt know anybody ran pylons around here.. other then down south.. I'll try and get up there saturday. I fly down near newnan, mostly sport stuff but really want to...
Forum: General Racing Discussion
11-26-2008, 12:59 PM
Replies: 8
Views: 840
Posted By at7driver

Pylon Racing in ATL

Hi all,

wondered if anybody was running pylon in or around atlanta. I know of hodges down south but wasnt sure about the atl area.

If not anybody in the atl area have the SD 50 that would...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-10-2008, 06:54 PM
Replies: 2
Views: 852
Posted By at7driver

RE: DX7 AR7000 loses bind

Thanks,

I will check, I think I am using the MPI's... if not I'll pick some up this week.. the radio system seems to work fine when I bind it and dont turn off the power but I dont want to fly...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-10-2008, 03:59 PM
Replies: 2
Views: 852
Posted By at7driver

DX7 AR7000 loses bind

Hi all,

Hoping to tap into some of the experiences on the board with this issue. I had contacted horizon in june with the same issue and I sent them my old AR7000 and they promptly sent me a...
Forum: Extreme Speed Prop Planes
04-26-2008, 07:52 AM
Replies: 34
Views: 9,725
Posted By at7driver

RE: 140+ mph H9 Sundowner 50 Arf

Hi all,

I have a sundowner 50 and want to put the OS 46 from my twist in it. I have a macs pipe (the black one) on the 46. was hoping to be able to mount the engine on its side and have the...
Forum: MVVS Support
02-04-2008, 04:29 PM
Replies: 11
Views: 1,606
Posted By at7driver

RE: evo 58 gx losing power

Thank you,

I will make the adjustments after I go thru the linkage again just to make sure nothing is loose.


Thank you again for your help,

great engine, pulls my lanier yak around...
Forum: MVVS Support
02-03-2008, 10:57 PM
Replies: 11
Views: 1,606
Posted By at7driver

RE: evo 58 gx losing power

hi,

It appears that when the tx stick is "full" throttle the carb plate is open past the 90 degree point, in other words it is over center, partially closing the bore. I don't have an...
Forum: MVVS Support
02-03-2008, 03:10 PM
Replies: 11
Views: 1,606
Posted By at7driver

RE: evo 58 gx losing power

Hi all,

finally had some time today to clean up the screen.

It wasn't bad, a light coating of crud in a very small area. I installed new fuel lines as well.

I ran it on the ground,...
Forum: MVVS Support
01-30-2008, 11:01 PM
Replies: 11
Views: 1,606
Posted By at7driver

RE: evo 58 gx losing power

Hi,

Yes there is a tank vent to atmosphere.. just got in from work and heading to bed.. will take the carb apart tomorrow to check the screen.. what type of inline fuel filter do you recommend....
Forum: MVVS Support
01-30-2008, 12:59 PM
Replies: 11
Views: 1,606
Posted By at7driver

RE: evo 58 gx losing power

Hi guys,

After checking the engine over.. the ign batt is good, good spark, good throttle servo, good fuel lines, no fuel leaks. I will check the internal carb filter screen tonite. also will...
Forum: MVVS Support
01-29-2008, 09:23 PM
Replies: 11
Views: 1,606
Posted By at7driver

evo 58 gx losing power

Hi all,

I have an evolution 58gx that started losing rpm's... I flew it yesterday and all was well. after about 30 minutes on the ground started right up and after a short warm up period, about...
Forum: RC Gliders, Sailplanes and Slope Soaring
01-29-2008, 07:37 AM
Replies: 4
Views: 1,065
Posted By at7driver

RE: Discus CS 2.65 Mtr

hey,

I had also posted about this ship.. there is a HUGE thread (41pages) on rcgroups, under "scale sailplanes" hope this helps.. just got mine in last week, havent started on her yet but looks...
Forum: RC Gliders, Sailplanes and Slope Soaring
01-20-2008, 07:26 PM
Replies: 27
Views: 5,639
Posted By at7driver

RE: Best RES kit ?

hey,

I think you'll like the skybench.. recently started on the big bird and am having a blast building this one.. cant wait to fly her.. a few months probably.. might go out just to trim her...
Forum: RC Gliders, Sailplanes and Slope Soaring
01-20-2008, 05:14 PM
Replies: 43
Views: 22,689
Posted By at7driver

RE: CM Pro Discus CS

hi all,

I ordered one from raidentech.. should be here tomorrow.

I read on a thread that someone was hi starting theirs. does anybody have any pics of the fuse block you put if for the...
Forum: Giant Scale Aircraft - 3D & Aerobatic
01-20-2008, 04:39 PM
Replies: 42
Views: 4,985
Posted By at7driver

RE: Carden prices?

Hey guys,

it is all very simple..


IT IS A CARDEN.
Forum: Carden Aircraft
12-08-2007, 11:12 PM
Replies: 29
Views: 5,501
Posted By at7driver

RE: Carden 30% extra question, help

HI all,

I recently bought a spring starter for the G62, the plane had a G62 on it from new. Trouble is the spring requires a 2 inch hole thru the firewall. The hole that is pictured is only 1...
Forum: Events, Shows and Fun Flys - Airplanes
10-29-2007, 02:21 PM
Replies: 0
Views: 501
Posted By at7driver

Fun Fly Newnan, GA. NOV17th

CRCC is having our annual Fun Fly Nov 17th from 10am on... Several demonstration flights throughout the day, raffles, food and beverages, swap meet. As well as the usual great flying and good company...
Showing results 1 to 25 of 41
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.