RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: solar696
Showing results 1 to 7 of 7
Search took 0.04 seconds.
Forum: Speed - RC Gas Boats
08-13-2012, 06:42 PM
Replies: 1,405
Views: 226,895
Posted By solar696

RE: ENFORCER OWNERS ~~ This is your thread

I did not glue the fitting in case I need to remove it. But I used pipe tread sealant to prevent any airleak. Silicon would work just as well.
Forum: Speed - RC Gas Boats
07-19-2012, 06:22 AM
Replies: 1,405
Views: 226,895
Posted By solar696

RE: ENFORCER OWNERS ~~ This is your thread

Check your new install,
got spark?

you sound experienced but my starting routine is:
transmitter ON, receiver ON
CARB at IDLE setting!
prime fuel lines.
choke ON, pull, first burp...
Forum: Speed - RC Gas Boats
08-14-2011, 11:38 AM
Replies: 1,405
Views: 226,895
Posted By solar696

RE: ENFORCER OWNERS ~~ This is your thread

YOur gator LOOKs good... brings back some momories.:)
The noodles will not stop it from a tip over /rolling over, but it will help stopping it from sinking.
Don't forget to plug/tape the...
Forum: Speed - RC Gas Boats
08-10-2011, 05:40 PM
Replies: 1,405
Views: 226,895
Posted By solar696

RE: ENFORCER OWNERS ~~ This is your thread

DO NOT add grease to the clutch, those are just air vents. On the newer models the "greasable" clutch housing extension is sealed off from the clutch, when you add grease it lubes the flex cable...
Forum: Speed - RC Gas Boats
08-09-2011, 01:40 PM
Replies: 1,405
Views: 226,895
Posted By solar696

RE: ENFORCER OWNERS ~~ This is your thread

At first engine choice was homies, later came air cooled zenoahs, then water cooled zens.
I am sure it is normal the way yours is setup.

In theory you should pull out the propshaft/flex...
Forum: Speed - RC Gas Boats
08-09-2011, 12:17 PM
Replies: 1,405
Views: 226,895
Posted By solar696

RE: ENFORCER OWNERS ~~ This is your thread

The magnum with the homie ......It is interesting to see that your carburetor block and carburetor is upside down.
I guess it is because normally these engine have the cylinder facing down, such...
Forum: Speed - RC Gas Boats
10-26-2010, 08:32 PM
Replies: 1,405
Views: 226,895
Posted By solar696

RE: ENFORCER OWNERS ~~ This is your thread

I have installed a speed master throttle in my superG when I swapped out the engine to a zen 260.
What I noticed that the the speed master setup ( nonflexible push-rods) had a good amount of...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.