RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: NuttyPro
Showing results 1 to 10 of 10
Search took 0.09 seconds.
Forum: Giant Scale Aircraft - 3D & Aerobatic
04-23-2007, 11:35 AM
Replies: 187
Views: 30,652
Posted By NuttyPro

RE: airwild extra 260 29% who's got one?

By the way, the NX and TBM are the same props. It was made the same manufacturer. At least I was told by TBM that and they look and feel the same.
Forum: Giant Scale Aircraft - 3D & Aerobatic
04-23-2007, 11:32 AM
Replies: 187
Views: 30,652
Posted By NuttyPro

RE: airwild extra 260 29% who's got one?

The NX and the Xoar props are 2 different props. The NX does not have as much pull as the Xoar, therefore allowing the engine to spool-up faster and running at higher RPM. Whereas the Xoar prop pull...
Forum: Giant Scale Aircraft - 3D & Aerobatic
04-23-2007, 10:10 AM
Replies: 187
Views: 30,652
Posted By NuttyPro

RE: airwild extra 260 29% who's got one?

I think you need to adjust your engine - both high and low needle valves. Adjusting the DA is very easy.
You need mixing for KE about 10%. Same elev. direction for both directions of rudder. One...
Forum: Giant Scale Aircraft - 3D & Aerobatic
04-23-2007, 09:48 AM
Replies: 187
Views: 30,652
Posted By NuttyPro

RE: airwild extra 260 29% who's got one?

I didn't need to put in anymore right thrust than what already built in and the airplane hovered great, just 2-3 clicks of right ruder trim with fine trim rate(2 out of 4-coarse). I had a DA 50 with...
Forum: Giant Scale Aircraft - 3D & Aerobatic
04-10-2007, 09:47 AM
Replies: 187
Views: 30,652
Posted By NuttyPro

RE: airwild extra 260 29% who's got one?

In addition, this a/c is a hover king. It hovers and torque roll just as good and easy as the 33% counterparts.
Forum: Giant Scale Aircraft - 3D & Aerobatic
04-10-2007, 09:42 AM
Replies: 187
Views: 30,652
Posted By NuttyPro

RE: airwild extra 260 29% who's got one?

When the plane was new, I had to re-glue the hinges 3 times. After each flight, the hinges came off. I eventually got so pissed. I just pin the hinges in place. I really hated this CA hinges on big...
Forum: Giant Scale Aircraft - 3D & Aerobatic
04-09-2007, 10:15 AM
Replies: 187
Views: 30,652
Posted By NuttyPro

RE: airwild extra 260 29% who's got one?

I've already crashed mine. If I buy another model, I'll put some carbon fiber strips on the inside of the engine box.
Forum: Giant Scale Aircraft - 3D & Aerobatic
04-06-2007, 09:49 AM
Replies: 187
Views: 30,652
Posted By NuttyPro

RE: airwild extra 260 29% who's got one?

Not sure how many flights, but I flew it a lot. About 6 flights per weekend on average. Periodically check the engine and make sure it is not loose. I found that my engine came loose twice even with...
Forum: Giant Scale Aircraft - 3D & Aerobatic
03-30-2007, 11:11 AM
Replies: 187
Views: 30,652
Posted By NuttyPro

RE: airwild extra 260 29% who's got one?

I only have this a/c for about 4 months but the engine is already showing some damage to the front housing where the front bearing is. My DA50 was brandnew when installed on this airplane. The reason...
Forum: Giant Scale Aircraft - 3D & Aerobatic
12-11-2006, 12:13 PM
Replies: 187
Views: 30,652
Posted By NuttyPro

RE: airwild extra 260 29% who's got one?

I just finish building this a/c. My first impression is this a/c must be the most overpriced arf on the market. With this quality and the level of completion and the amount of hw included, I believe...
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.