RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: newjak
Showing results 1 to 5 of 5
Search took 0.11 seconds.
11-21-2008, 03:49 PM
Replies: 1,963
Views: 319,588
Posted By newjak

RE: E-Flite Mini Pulse XT Owner's Club

I went through a similar situation with my MUS. I suspect it was a BEC overload and shutdown. My MUS went in from about 100 ft up. Since then it has been repaired and I now use a UBEC. Slowly but...
07-02-2007, 05:24 PM
Replies: 1,963
Views: 319,588
Posted By newjak

RE: E-Flite Mini Pulse XT Owner's Club

I got rid of the wheel pants on my MPXT because I figured that would happen. I also changed to 3 inch MPI spoked wheels which make a HUGE difference when landing in grass. I am a beleiver in the...
05-04-2007, 08:43 PM
Replies: 1,963
Views: 319,588
Posted By newjak

RE: E-Flite Mini Pulse XT Owner's Club

I have been enjoying my MPXT for several weeks until today. Unfortunately I had to take the walk of shame. I got a little to low and too slow and planted the nose into the ground. I will try to...
04-28-2007, 07:45 PM
Replies: 1,963
Views: 319,588
Posted By newjak

RE: E-Flite Mini Pulse XT Owner's Club

I had a similar problem with my MUS. It drove me crazy trying to figure it out. After messing with the wing and not getting any results I discovered that one side of the elevator was slightly warped...
04-01-2007, 06:27 PM
Replies: 1,963
Views: 319,588
Posted By newjak

RE: E-Flite Mini Pulse XT Owner's Club

I have used the PVC method with great success. !/2" is a little too flimsy. Start out a little beefier and thin out to 1" toward the top. I stand on a 20' ladder and use the PVC to reach the plane....
Showing results 1 to 5 of 5


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.