RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: johncpen
Showing results 1 to 7 of 7
Search took 0.43 seconds.
Forum: Gas Engines
05-31-2014, 01:39 PM
Replies: 55
Views: 15,555
Posted By johncpen

Richening the low needle did the trick! Thanks

Richening the low needle did the trick! Thanks
Forum: Gas Engines
05-18-2014, 05:54 AM
Replies: 55
Views: 15,555
Posted By johncpen

I know this is an old thread, but I am having...

I know this is an old thread, but I am having the exactly the same problem. Did you figure out what was causing this?
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-23-2013, 06:13 PM
Replies: 1
Views: 26,419
Posted By johncpen

Spektrum DX5e Power switch repair

So I was flying my Radian yesterday and I lost all contact. I discovered the power switch was faulty and according to several posts on the World Wide Web is a common problem and just a cheap switch....
Forum: ARF or RTF
06-24-2013, 06:21 PM
Replies: 67
Views: 7,347
Posted By johncpen

RE: Aeroworks Quality

I have a 35cc extra 260. The landing gear is too weak, the carbon fiber upgrade. Is fine, but the gear cover won' t fit over it. The hinges break. When I complained, they said the gear is strong...
Forum: Kit Building
05-04-2013, 07:54 AM
Replies: 15
Views: 4,657
Posted By johncpen

RE: making tail braces

Thanks for the info! I decided not to use brass tubing, mostly because I did not have any on hand. I sandwiched. the cable between two washers and gently tightened with threadlocker.
Forum: Kit Building
05-03-2013, 02:07 PM
Replies: 15
Views: 4,657
Posted By johncpen

RE: making tail braces

I tried this on my Giant Super Sportster. The brass post that go in the horizontal stabilizer were not long enough in my case. I manage to make it work though by countersinking the top hole and...
Forum: Scratch Building, Aircraft Design, 3D/CAD
02-17-2009, 07:36 PM
Replies: 3
Views: 3,796
Posted By johncpen

RE: Ace Whiz 40 Scratch build questions

I have a Whiz 40 and the centerline for the fuel tank is 1 1/2 inches below the needle valve. I have no way to either raise the tank or lower the engine. Could you ask the designer why it's made...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.