RCU Forums - Search Results

Search: Posts Made By: xtraflyr

Showing results 1 to 6 of 6
Search took 0.03 seconds.

Forum: WildHare R/C Support

04-07-2007, 08:24 AM

Replies: 856

1.20 Edge Review, the beginnings

Views: 77,106

Posted By xtraflyr

RE: 1.20 Edge Review, the beginnings

Hey there,
With the pull-pull you dont have to constantly check them and tightened them.But it should be part of your pre flight check anyways..
Just make sure the rudder servo is...

Forum: WildHare R/C Support

05-29-2006, 08:48 AM

Replies: 856

1.20 Edge Review, the beginnings

Views: 77,106

Posted By xtraflyr

RE: 1.20 Edge Review, the beginnings

Hey Rob,
How exactly are the rods on it,are they over a 4/40 rod or by themselves and into threaded ends? Mine are the second way on my BME Yak and the have been fine for the 12 flights I have on...

Forum: WildHare R/C Support

05-20-2006, 07:19 PM

Replies: 856

1.20 Edge Review, the beginnings

Views: 77,106

Posted By xtraflyr

RE: 1.20 Edge Review, the beginnings

ben,you have the link to your edge vid?I can't find it...[>:]

Thanks, frank

Forum: WildHare R/C Support

05-20-2006, 06:43 PM

Replies: 856

1.20 Edge Review, the beginnings

Views: 77,106

Posted By xtraflyr

RE: 1.20 Edge Review, the beginnings

Yeah,here in NJ I'm getting over 9000rpm on 15/18%Wildcat fuel on a 18x6 Menz and Bolly props. I saw your vid Ben and gotta say it was pretty cool!!

Later,
Frank

Forum: WildHare R/C Support

05-20-2006, 07:49 AM

Replies: 856

1.20 Edge Review, the beginnings

Views: 77,106

Posted By xtraflyr

RE: 1.20 Edge Review, the beginnings

Hey Tom,
Is it 3D capable with the YS,pulling out of a hover ect..??

Thanks,
Frank

Forum: WildHare R/C Support

05-19-2006, 08:33 PM

Replies: 856

1.20 Edge Review, the beginnings

Views: 77,106

Posted By xtraflyr

RE: 1.20 Edge Review, the beginnings

Hey Guys,
I'm thinking about getting one of these.. I have a Moki 1.8 and a YS120SF(old school).What do you guys think about either one of these motors? I know in the begining of this thread...

Showing results 1 to 6 of 6