RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 7
1
2
3
Last »
Search: Posts Made By: mrasmm
Showing results 1 to 25 of 173
Search took 0.09 seconds.
Forum: Electric RC Helis
12-09-2007, 09:41 AM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

it does have reverse polarity protection.... so I wonder what it was that cause the problem with the charger to make it smoke.

hehe, yeah like everyone else said, you're pretty lucky nothing...
Forum: Electric RC Helis
12-05-2007, 07:54 AM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

you may also want to consider brushless. The two heli's use the same motors, and if you get the one you want for the blade, you can put it on this heli as well =)
Forum: Electric RC Helis
12-02-2007, 01:19 AM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

you may want to check the batteries in the Tx, when they get low the heli can do things like that for seemingly no reason =)
Forum: Electric RC Helis
11-28-2007, 03:18 AM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

if you want to PM me with your e-mail I can send you a guide =)
Forum: Electric RC Helis
11-12-2007, 07:00 PM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

the higher the C rating, just the more expensive the pack will be. Honestly to get any flight duration you're gona need atleast a 500mAh pack, and the F40 takes an average of 4 to 5 amps, max...
Forum: Electric RC Helis
11-11-2007, 03:22 AM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

yeah, no prob =)

nope I haven't heard from or seen robo in a long time. he hasn't posted inover a month, but he logged in just a few days ago
...
Forum: Electric RC Helis
11-05-2007, 07:21 PM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

hey bonez your back =) I haven't seen you around in a while!
Forum: Electric RC Helis
11-04-2007, 03:24 AM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

140 teeth for the main gear on most 300 sized heli's
Forum: Electric RC Helis
11-04-2007, 03:20 AM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

lol, that's a good one =)

hehe yeah you'll defiantely have to turn the gain down a good deal, that's too bad it took 3 sets of blades to get it mostly adjusted. The n30's should have 8 teeth on...
Forum: Electric RC Helis
11-03-2007, 06:04 PM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

actually none of these motors are rated for a 3s lipo =) even the mains. They are rated for 7.2v I believe, and that is why they wear out so quickly. They'll work just fine though, just wont last...
Forum: Electric RC Helis
11-03-2007, 06:01 PM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

yeah, no prob =)

I would agree with michael on the 11.1, overall it's not really recommended, but you should be fine doing it especially if you put the fuses in. 7.5A for the main and 2A for...
Forum: Electric RC Helis
11-03-2007, 04:38 AM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

yeah, the stock pack weighs in something like 88g is what someone said before, so 84 or 85g sounds right on the money to me.

As far as the low flight times, sounds like you've already got that...
Forum: Electric RC Helis
10-30-2007, 07:37 PM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

yup, that's the one I was talking about. You'll have to get a jst end and solder it on (don't get just the end, get the wire leads, it's so much easier that way, they run about $3 bucks from a...
Forum: Electric RC Helis
10-30-2007, 05:57 PM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

yeah, if they are the stock packs and they have 100 cycles each on them, then yup, they are probably gone.

you may want to look at getting some lipo's, something around 1200 to 1300mAh 2s lipo's...
Forum: Electric RC Helis
10-30-2007, 03:40 AM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

yup, no prob =)

It's 1 cell low, and a bit bigger so it's gona be a bit heavier, so it may have a hard time getting off the ground, but by all means if it fits in the heli and will get it off of...
Forum: Electric RC Helis
10-30-2007, 03:39 AM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

also check the tail motor, that can draw alot of amps if it's failing.

If you can make a homemade ammeter with your DMM and a male and female JSt connector and see what kinds of amps the heli is...
Forum: Electric RC Helis
10-28-2007, 05:33 PM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

xheli (and raidentech I believe) have been bought out recently and are under new management. He seems alot more on the ball from what I have seen posted in the forums, but I don't really know, but...
Forum: Electric RC Helis
10-26-2007, 11:27 PM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

you can figure out what page the post would have been on also, the current # is 30, and the previous used to be 25 I think, so just take the old page number, and divide it by 1.2, and that should get...
Forum: Electric RC Helis
10-22-2007, 07:33 PM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

I'm a little late =) I'm glad it worked though, as i keep reading I will probably find out that you've already tested it. Shesh, not getting on RCU for 5 days leaves you alot of reading to do =P
Forum: Electric RC Helis
10-16-2007, 09:36 PM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

you might need to balance the blades, pm me with your e-mail for a guide =)
Forum: Electric RC Helis
10-16-2007, 06:03 PM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

hehe, good deal =) you wanna keep that smoke in there, makes the electrical genies happy and they get their job done =P
Forum: Electric RC Helis
10-16-2007, 03:58 AM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

Note: For safety, disconnect both main motor plugs from the 4-in-1 control unit (as shown on page 16)
before proceeding. Once the binding process is complete and the flight battery is unplugged...
Forum: Electric RC Helis
10-16-2007, 03:56 AM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

the Tx and Rx should swap out fine, just the main problem is the FET's, the cx2 has 7313's only rated at 6A cont each if they are sunk, the main motor on the falcon could easily draw 8A or more in...
Forum: Electric RC Helis
10-11-2007, 02:18 AM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

hopefully this will clear it up for you.

store NiCD's and NiMH's at whatever voltage you want, lipo's are at 50% cap or about 3.8 to 3.85v per cell. NiCd's have "memory" but that's really mroe...
Forum: Electric RC Helis
10-05-2007, 06:28 PM
Replies: 9,618
Views: 910,212
Posted By mrasmm

RE: Falcon 40 (Exceed heli) Forum

thanks rdrunner, looks like I missed the bday =(, but happy belated bday all =D

I haven't seen robo around forever, hrm, wonder where he is, anyone heard from him?

about the stock 4 in 1,...
Showing results 1 to 25 of 173
 
Page 1 of 7
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.