RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: JariV
Showing results 1 to 8 of 8
Search took 0.11 seconds.
Forum: Glow Engines
08-05-2012, 10:42 AM
Replies: 54,883
Views: 5,427,790
Posted By JariV

RE: Welcome to Club SAITO !

SrTelemaster, regarding the Moki conrod offset; the two opposite slave rod big end pin locations are closer to each other than the other pins on the same base circle. So all pistons have the same...
Forum: Glow Engines
08-04-2012, 01:16 PM
Replies: 54,883
Views: 5,427,790
Posted By JariV

RE: Welcome to Club SAITO !

Did you know that Moki radial has the opposite to master slave rods offset closer to each other in 5-cyl radials?

Reason for this in my opinion could be either to dampen certain harmonics or to...
Forum: Glow Engines
09-24-2011, 11:30 AM
Replies: 54,883
Views: 5,427,790
Posted By JariV

RE: Welcome to Club SAITO !

My member number can be released for someone else. I sold my only Saito engine.
Forum: Glow Engines
09-13-2011, 10:02 PM
Replies: 54,883
Views: 5,427,790
Posted By JariV

RE: Welcome to Club SAITO !

Are you talking now about 2-t heli fuel or 2-t car fuel?

Car fuel has substantially lesser amount of oil in it, usually around 10%, 4-t heli fuels usually have around 20% of oil. I don't know...
Forum: Glow Engines
09-09-2011, 07:26 PM
Replies: 54,883
Views: 5,427,790
Posted By JariV

RE: Welcome to Club SAITO !

The idea behind my velocity stack is that it is positioned directly in the prop stream and also against prop blade pressure. My velocity stack has a slight negative contour opposed to the examples...
Forum: Glow Engines
09-08-2011, 01:08 PM
Replies: 54,883
Views: 5,427,790
Posted By JariV

RE: Welcome to Club SAITO !

That's not a real velocity stack. The mouth of the stack should be considerably larger and the contour is very important. I did a stack into my radial Saito and power went up by 10 % after adjusting...
Forum: Glow Engines
08-25-2011, 10:02 PM
Replies: 54,883
Views: 5,427,790
Posted By JariV

RE: Welcome to Club SAITO !

Hello,

if someone is having trouble with Saito radial engines dropping a cylinder during flight then there is a cure for that. I had this problem with my FA90R3 radial dropping a cylinder during...
Forum: Glow Engines
08-21-2011, 09:02 AM
Replies: 54,883
Views: 5,427,790
Posted By JariV

RE: Welcome to Club SAITO !

I only have one Saito myself, the FA90R3 radial. I have been very impressed by it, good quality and very easy to start. It resides in this airplane:

...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.