RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: causeitflies
Showing results 1 to 25 of 42
Search took 0.01 seconds.
Forum: RC Jets
10-29-2023, 05:10 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

if you saved a backup in Jeti studio, you can...

if you saved a backup in Jeti studio, you can retrieve it there.
Forum: RC Jets
08-15-2022, 07:05 AM
Replies: 2,111
Views: 495,839
Posted By causeitflies

Harvey also wants a 900 thrown in the mix. Are...

Harvey also wants a 900 thrown in the mix. Are you using a 900 with the Rex7 and R3?
Forum: RC Jets
08-14-2022, 06:34 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

I did my setup quite a few years ago. So the...

I did my setup quite a few years ago. So the reason yours worked with the lead plugged into the EXT port could be this which is probably the newer better option....
Forum: RC Jets
08-14-2022, 06:03 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

Ok, so my R3 is as you described connected to...

Ok, so my R3 is as you described connected to port 3 which is configured as ppm out. The EXT port is used when connecting to a CBxxx. My R3 is connected to a REX12A. So make sure port 3 (or the one...
Forum: RC Jets
08-14-2022, 05:42 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

Well now I'll have to run out and double check my...

Well now I'll have to run out and double check my install LOL.
Forum: RC Jets
08-14-2022, 05:10 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

EXT port is correct.

EXT port is correct.
Forum: RC Jets
04-26-2022, 04:14 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

Maybe something in the headphone jack. I would...

Maybe something in the headphone jack. I would take the back off and take a peek.
Forum: RC Jets
12-20-2021, 03:57 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

Good catch, Bob. I think I had something similar...

Good catch, Bob. I think I had something similar happen when assigning a switch.
Forum: RC Jets
12-20-2021, 01:38 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

Not really much else to try except maybe a...

Not really much else to try except maybe a different sound file.
Forum: RC Jets
12-20-2021, 12:32 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

In the Sounds on Event menu, does the switch show...

In the Sounds on Event menu, does the switch show the check mark? Is the delay set for 0.0?
Forum: RC Jets
08-01-2020, 10:11 AM
Replies: 2,111
Views: 495,839
Posted By causeitflies

There is no “fix”. There is nothing to fix, just...

There is no “fix”. There is nothing to fix, just as I don’t expect a color screen for my old DS 16 as a fix.
Forum: RC Jets
06-30-2020, 08:18 AM
Replies: 2,111
Views: 495,839
Posted By causeitflies

I always keep a couple white towels in the van to...

I always keep a couple white towels in the van to throw over the cockpit. I've seen canopies melt even on cool sunny days and some dark parts of my planes get too hot to touch.
Forum: RC Jets
06-18-2020, 08:35 AM
Replies: 2,111
Views: 495,839
Posted By causeitflies

Yes that does explain why the only one of my jets...

Yes that does explain why the only one of my jets that experiences dropouts is the one with the Cortex.
Forum: RC Jets
06-11-2020, 01:06 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

Thanks Harry. I haven’t pulled that jet out yet...

Thanks Harry. I haven’t pulled that jet out yet this year but will soon and was going to look at my whole set up again anyway.
Forum: RC Jets
06-11-2020, 09:13 AM
Replies: 2,111
Views: 495,839
Posted By causeitflies

This may confirm what I was thinking about my set...

This may confirm what I was thinking about my set up on my Hawker Hunter. The gear doors are controlled by Telemetry using sensors on the gear. Quite often the gear doors open and close during a...
Forum: RC Jets
01-30-2020, 10:02 AM
Replies: 2,111
Views: 495,839
Posted By causeitflies

Still not fixed, mine works better :p ...

Still not fixed, mine works better :p
https://www.rcgroups.com/forums/showthread.php?3516047-1-YouTube-Livestream-Ideas-for-Episode-1
Looking forward to the stream.
Forum: RC Jets
01-29-2020, 03:18 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

Try this ...

Try this
https://www.rcgroups.com/forums/showthread.php?3516047-1-YouTube-Livestream-Ideas-for-Episode-1
Forum: RC Jets
12-19-2019, 09:19 AM
Replies: 2,111
Views: 495,839
Posted By causeitflies

There is a very long T-1 thread already so no...

There is a very long T-1 thread already so no need to start a new one. FWIW I have a T-1 and use a 12ch Assist and an R3 in dual mode with a Dual battery switch. No problems after about 75 flights.
Forum: RC Jets
12-11-2019, 08:27 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

Do you have any delay set in the "SERVO" menu?...

Do you have any delay set in the "SERVO" menu? There are multiple places where you can set a delay to slow down flaps but I would check the servo menu to make sure they are the same.
Forum: RC Jets
11-18-2019, 03:42 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

I also had this happen recently when changing a...

I also had this happen recently when changing a slider to a two position switch on my DS16. I was surprised that it was global and carried over to other models.
Forum: RC Jets
08-11-2019, 07:09 AM
Replies: 2,111
Views: 495,839
Posted By causeitflies

It's a demo video...

It's a demo video...
Forum: RC Jets
07-31-2019, 05:23 AM
Replies: 2,111
Views: 495,839
Posted By causeitflies

Thumbs up TERO is the man :cool:

TERO is the man :cool:
Forum: RC Jets
05-07-2019, 11:52 AM
Replies: 2,111
Views: 495,839
Posted By causeitflies

F1 Rocket, I am using two R3's into a Cortex...

F1 Rocket,
I am using two R3's into a Cortex and then into a CB200 (no 900). What type of switchover occurs in the Cortex with the R3's before the CB200? I am currently using "mixing" in the CB and...
Forum: RC Jets
03-12-2019, 02:20 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

Why are you using an Assist and a Cortex Pro...

Why are you using an Assist and a Cortex Pro together? How are they connected to the CB200?
Forum: RC Jets
03-10-2019, 05:07 PM
Replies: 2,111
Views: 495,839
Posted By causeitflies

Ver. 1.30 was more extensive but from the release...

Ver. 1.30 was more extensive but from the release notes for ver. 1.31:
Version 1.31 (January 2019)
- Fixed: Telemetry input of the Ext2/Ext3 (telemetry inputs did not work properly) .
Showing results 1 to 25 of 42
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.