RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: sensei
Showing results 1 to 7 of 7
Search took 0.03 seconds.
Forum: Composites Fabrication And Repair
10-07-2013, 03:30 PM
Replies: 47
Views: 8,035
Posted By sensei

There is also a vast amount of technical...

There is also a vast amount of technical knowledge base right here in this composite forum free for the learning, all one needs to do is open their eyes.

Bob
Forum: Composites Fabrication And Repair
10-06-2013, 04:01 PM
Replies: 47
Views: 8,035
Posted By sensei

I true them with a long straight edge and an...

I true them with a long straight edge and an X-Acto blade, then I touch them up with 80 grit and a 24" flat sanding block. On the 1" strips, I lay them up and and allow them to cure on their own...
Forum: Composites Fabrication And Repair
10-05-2013, 07:52 PM
Replies: 47
Views: 8,035
Posted By sensei

If you tape the balsa sheets together, use...

If you tape the balsa sheets together, use laminating resin and a vacuum bag, there is no reason to edge glue anything and there is also a weight reduction when spline sanding the wing for trueness. ...
Forum: Composites Fabrication And Repair
10-03-2013, 05:02 PM
Replies: 47
Views: 8,035
Posted By sensei

Actually foam wings can be just as light maybe...

Actually foam wings can be just as light maybe lighter then built up, just depends on how far one is willing to go with them.

Bob
Forum: Composites Fabrication And Repair
10-02-2013, 04:01 PM
Replies: 47
Views: 8,035
Posted By sensei

Nice looking airplane, what is the wingspan and...

Nice looking airplane, what is the wingspan and wing area if I may ask?

Bob
Forum: Composites Fabrication And Repair
09-11-2013, 04:10 PM
Replies: 47
Views: 8,035
Posted By sensei

I use a bow for most stuff, but if the cut is...

I use a bow for most stuff, but if the cut is really deep then I sometimes use two handles with the wire attached and alligator clip the juice to the wire. My giles was actually an old Lanier kit, I...
Forum: Composites Fabrication And Repair
09-11-2013, 02:56 AM
Replies: 47
Views: 8,035
Posted By sensei

I make my templates by laying them out, cutting...

I make my templates by laying them out, cutting the out close to the line with a jig saw, and sanding to the line with an oscillating spindle sander. this sander can be purchased from Harbor Freight...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.