RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: Planejaw
Showing results 1 to 8 of 8
Search took 0.02 seconds.
04-23-2015, 02:38 AM
Replies: 114
Views: 17,998
Posted By Planejaw

Larry, I didn't mix in any down-elevator...

Larry,

I didn't mix in any down-elevator with flaps. Found that with much more than a few degrees of flapperons, you really need to use the rudder to make directional corrections on final and to...
06-09-2014, 02:42 AM
Replies: 114
Views: 17,998
Posted By Planejaw

Rocco, if the "flap" wing version is produced,...

Rocco, if the "flap" wing version is produced, please be sure to make it a "retro-fit" for those of us who have the original version. Hopefully, we will be able to buy a set of the "new" wings with...
06-04-2014, 02:46 AM
Replies: 114
Views: 17,998
Posted By Planejaw

I maidened my GT-20 last week. DLE-20 provides...

I maidened my GT-20 last week. DLE-20 provides plenty of power and very miserly on the fuel consumption. Was able to drop tennis balls and parachuter from the bomb-drop bay. Programmed in...
01-31-2014, 04:14 AM
Replies: 114
Views: 17,998
Posted By Planejaw

Cory, The smaller LiFe batteries I have,...

Cory,

The smaller LiFe batteries I have, 2100 mah, would not balance the airplane if used where the batteries are. The three 3200 mah packs are a little overkill, but at least no "useless" extra...
01-30-2014, 04:20 AM
Replies: 114
Views: 17,998
Posted By Planejaw

A couple more photos. Almost forgot, Aeroworks...

A couple more photos. Almost forgot, Aeroworks fuel-dot. Will need to put a small tail-skid on there also.




...
01-30-2014, 04:12 AM
Replies: 114
Views: 17,998
Posted By Planejaw

DLE-20 under the bonnet, Align 610 servos on all...

DLE-20 under the bonnet, Align 610 servos on all flight surfaces, JR DS-821 servo on throttle. Smart-Fly Power System Sport-Plus w/fail-safe pin switch, two 3200 mah 2-cell LiFe batteries to the...
01-27-2014, 03:51 AM
Replies: 114
Views: 17,998
Posted By Planejaw

Thanks for your note Rocco. The balance of the...

Thanks for your note Rocco. The balance of the assembly went perfect. Everything else lined up and fit very well.
01-23-2014, 10:44 AM
Replies: 114
Views: 17,998
Posted By Planejaw

Paint match between the fiberglass and covering...

Paint match between the fiberglass and covering is very good. Landing gear holes did not match the blind-nuts installed in the fuselage. Some "elongating" of the holes with a round file needed to...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.