RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: pgmeyer
Showing results 1 to 25 of 105
Search took 0.40 seconds.
10-07-2022, 08:23 AM
Replies: 2
Views: 886
Posted By pgmeyer

Thank you, I guess its time to add to my...

Thank you,
I guess its time to add to my treasured 8FG super:)
10-06-2022, 03:32 PM
Replies: 2
Views: 886
Posted By pgmeyer

Programming the digital servos

I plan on using some high end Futaba digitals in a new giant scale airplane. My question is, which transmitter can offer editing of the servo parameters like center and endpoint without resorting to...
Forum: ARF or RTF
03-15-2016, 04:46 AM
Replies: 1,279
Views: 147,090
Posted By pgmeyer

I am rebuilding my 'coupe and I am looking for a...

I am rebuilding my 'coupe and I am looking for a cowl that is not crunched and a set of wheel pants in the same condition:) Anyone with spares or where to get replacements?

Time to get her off the...
Forum: ARF or RTF
01-04-2015, 02:55 PM
Replies: 3,052
Views: 427,963
Posted By pgmeyer

Dual A123s, Dual switches, Dual feeds to the...

Dual A123s, Dual switches, Dual feeds to the receiver and an IBE. Come over to the Dark Side ��
Look at the NoBs site.
Washington State?
A bit too far for a drive now!
Best Regards, Jim
Paul
Forum: ARF or RTF
02-28-2014, 05:00 AM
Replies: 299
Views: 61,729
Posted By pgmeyer

Always watching, thinking about hunting big boar...

Always watching, thinking about hunting big boar with a big bore
Paul
Forum: Gas Engines
09-20-2013, 06:27 AM
Replies: 6,363
Views: 784,247
Posted By pgmeyer

Once the slime is present, it is in all the...

Once the slime is present, it is in all the internal fuel paths in the carb block. Not sure what causes it, but the last time it happened to me I sent the engine back and the carb was replaced. Since...
Forum: Gas Engines
07-09-2013, 02:07 PM
Replies: 6,363
Views: 784,247
Posted By pgmeyer

RE: SYSSA 30CC GAS MADE IN USA

Gas cans- if kept outside exposed to heat cycles-
Just a thought, with plastic jugs that expand and collapse with heat and cold, they exhale gasoline vapor when hot and inhale cool moist evening...
Forum: Gas Engines
07-09-2013, 03:55 AM
Replies: 6,363
Views: 784,247
Posted By pgmeyer

RE: SYSSA 30CC GAS MADE IN USA

Contact for customer service - I sent my well used engine back due to a carb problem, it was returned within 2 weeks and has run perfectly ever since. It has a Tilotson carb now, the new muffler, and...
Forum: Gas Engines
05-21-2013, 05:21 AM
Replies: 6,363
Views: 784,247
Posted By pgmeyer

RE: SYSSA 30CC GAS MADE IN USA

I don't know about a V2 version, but I just had my SAP 180 upgraded with a new carb and the new muffler. Turnaround was rapid and the cost was only parts and shipping. At one time this was one of the...
Forum: ARF or RTF
03-12-2013, 01:32 PM
Replies: 3,052
Views: 427,963
Posted By pgmeyer

RE: New Giant GP Super Sportster!!!!!

Hi Jim,
nice to see you here again, I got down to Texas again, brought a small electric this time -

Paul
Forum: ARF or RTF
02-04-2013, 04:57 AM
Replies: 3,052
Views: 427,963
Posted By pgmeyer

RE: New Giant GP Super Sportster!!!!!

Nicely designed mod - sort of a "captured spring" technique. Very cool -
Forum: Gas Engines
01-23-2013, 05:19 PM
Replies: 6,363
Views: 784,247
Posted By pgmeyer

RE: SYSSA 30CC GAS MADE IN USA

Steve,
Thanks - putting greens? Wow, sounds wonderful - you keep those armadillos out? but we will still be rolling south to the area around Temple. I have flown at the nice paved runway near...
Forum: Gas Engines
01-22-2013, 06:53 PM
Replies: 6,363
Views: 784,247
Posted By pgmeyer

RE: SYSSA 30CC GAS MADE IN USA

Heading for Texas in March :-)
Bringing the Syssa powered 25% Pilot RC Extra -
Forum: ARF or RTF
01-22-2013, 06:06 AM
Replies: 3,052
Views: 427,963
Posted By pgmeyer

RE: New Giant GP Super Sportster!!!!!

I never heard of any incident where a Tesla burned it's battery. They are built in California and there are almost none on the east coast yet. That should change fairly soon because the Model S has...
Forum: ARF or RTF
01-21-2013, 06:35 AM
Replies: 3,052
Views: 427,963
Posted By pgmeyer

RE: New Giant GP Super Sportster!!!!!

The Dreamliner has a big problem with them. Grounded until they find out why they are burning up - maybe Boeing should get in touch with Tesla?
The people with the best Lithium tech are the Tesla...
Forum: ARF or RTF
01-21-2013, 05:55 AM
Replies: 3,052
Views: 427,963
Posted By pgmeyer

RE: New Giant GP Super Sportster!!!!!

Very sorry to hear of this event. Do you know if the charge connection was through the battery mains or through the individual cell connector? I use quite a few Lithium Polymer batteries for my...
Forum: ARF or RTF
01-08-2013, 08:23 PM
Replies: 3,052
Views: 427,963
Posted By pgmeyer

RE: New Giant GP Super Sportster!!!!!

Hi Dave,
I thought you might be enticed to say something at this point - ok, evil in the way that "way bad" is great!

ahicks - 16.5 lbs, wow - that is a wind penetrating beast at that...
Forum: ARF or RTF
01-08-2013, 03:11 PM
Replies: 3,052
Views: 427,963
Posted By pgmeyer

RE: New Giant GP Super Sportster!!!!!

Yup,
I fly a lot of aerobatics, but I know I will have a GSS because an evil person at the field lets me exercise his on occasion :-) Sure is a sweet flyer in all types of conditions -
Not sure...
Forum: ARF or RTF
01-08-2013, 12:37 PM
Replies: 3,052
Views: 427,963
Posted By pgmeyer

RE: New Giant GP Super Sportster!!!!!

Sheesh, umm, I kind of forgot this is the GSS thread - the minimal mixes I use are on an aerobatic airframe that is already very close to neutral - not sure the GSS will behave well since it has...
Forum: ARF or RTF
01-07-2013, 01:27 PM
Replies: 3,052
Views: 427,963
Posted By pgmeyer

RE: New Giant GP Super Sportster!!!!!

I have a slight roll when knife edge right to left (counter clockwise), removed with a tiny amount of rudder to aileron mix. There does not seem to be the same amount flying clockwise knife edge....
Forum: ARF or RTF
01-07-2013, 08:26 AM
Replies: 3,052
Views: 427,963
Posted By pgmeyer

RE: New Giant GP Super Sportster!!!!!

I agree with the CG statement %100, best way is do a 45 degree inverted climb out and see if the tail drops and tries to go vertical. My ships are neutral at that attitude. Elevator neutral, of...
Forum: ARF or RTF
01-07-2013, 06:16 AM
Replies: 3,052
Views: 427,963
Posted By pgmeyer

RE: New Giant GP Super Sportster!!!!!

Yes,
I agree that trying to mix all the time for the GSS is problematic
- the GSS is not really a very good pattern ship - too many things to fight.
Forum: ARF or RTF
01-07-2013, 05:58 AM
Replies: 3,052
Views: 427,963
Posted By pgmeyer

RE: New Giant GP Super Sportster!!!!!

2 cents:
I practice knife edge in both directions and 4 point rolls constantly. I use the mixes all the time. On an airframe that is designed for aerobatics, neutralizing the airframe behavior...
Forum: ARF or RTF
10-05-2012, 11:35 AM
Replies: 3,052
Views: 427,963
Posted By pgmeyer

RE: New Giant GP Super Sportster!!!!!

Guys,
With a +45 expo she will jump all over the place. Futaba curve uses negative direction to flatten the curve, positive 45 will be a scary experience! I don't think there is anything else wrong...
Forum: Gas Engines
09-25-2012, 03:22 PM
Replies: 6,363
Views: 784,247
Posted By pgmeyer

RE: SYSSA 30CC GAS MADE IN USA

2 cents:
I have lost track of the number of flights and the number of gallons of fuel that went through my SAP-180 number 1. It has been in two airplanes now since Jim and I bought one of the...
Showing results 1 to 25 of 105
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.